InStep Stroller SB150 User Manual

®
Keep this manual for future reference. If you sell or give this  
stroller away, make sure you give this manual to the new owner.  
Ask them to read instructions completely.  
SB150 STROLLER/FRAME CARRIER  
SB150 Operating Instructions  
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller/frame  
carrier. If you have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-  
before using.  
Safety Rules:  
WARNING: Failure to follow these warnings and assembly instructions could result in  
serious injury or death.  
WARNING: Immediately discard any plastic wrapping.  
WARNING: Never allow children to fold, assemble or disassemble the stroller/frame carrier.  
WARNING: Do not use stroller until your child is old enough to hold his/her head up on his/her own.  
WARNING: Maximum weight capacity for a child in this stroller is 30 lbs. or 13.6 kg.  
WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt and shoulder harness.  
WARNING: Never leave child unattended.  
WARNING: Never use this stroller/frame carrier with roller skates or in-line skates.  
WARNING: Never allow this stroller/frame carrier to be used as a toy or allow children to give rides to  
others.  
WARNING: Never use stroller/frame carrier if it becomes damaged.  
WARNING: Always be aware of traffic around you when walking.  
WARNING: Always engage brakes when you stop or when you let go of handle.  
WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.  
WARNING: Maximum weight for objects in back pouch is 2.2 lbs. or 1 kg. Excessive weight may  
cause a hazardous unstable condition.  
WARNING: For child’s safety it is best to have another adult help you put on the pack while child is in  
it. Make sure the child is securely strapped in with both shoulder straps and waist strap  
prior to putting on the pack.  
1
 
To lower belly bar pull forward on the spring  
loaded latches (located on each side of the belly  
bar) then tilt down (Picture D).  
Locking Peg  
D
E
F
Step 2. Rear Wheel Asembly  
Push the wide end of the white retaining clip  
onto one end of the axle until it snaps into the  
groove. Press black cap onto retaining clip. Slide  
one rear wheel on the axle and insert the other  
end of the axle through both of the rear support  
holes (Picture E). Place the other rear wheel  
onto the axle (Picture F). Snap the retaining clip  
onto the axle then press on black cap onto clip  
(Picture G).  
Side Latches  
(not latched)  
Spring Latches  
for Belly Bar  
Cap over  
Retaining Clip  
Rear Wheel  
Step 3. Canopy Assembly  
Rear Support  
Hole  
Place the canopy so that the rounded edge is  
positioned behind the headrest, then snap it onto  
the back of the headrest. Bend the canopy and  
snap both sides onto the belly bar (Picture H).  
Axle  
Rear Support  
Hole  
Assembly is now complete!  
Rear Wheel  
Rear Axle  
Rear Brake  
G
H
Cap  
Head  
Rest  
Snap  
Retaining Clip  
Side Latches  
Latched  
Rear Wheel  
Belly Bar Snap  
3
 
Use Instructions  
I
Side Latch  
Locking Peg  
To close stroller:  
Belly Bar  
Pull back on the side latches until they clear the  
locking pegs. The stroller will automatically fold  
when handle is pushed down or when the stroller  
is lifted off the ground (Picture I).  
Side Latch  
J
To engage rear brakes:  
Step lightly on the levers next to the rear wheels  
until the cogs of the brakes engage the cogs of  
the wheel. Repeat on other side. To release  
brake, lift levers with toe until cogs disengage  
(Picture J).  
Rear Pouch  
Child’s Mesh  
Foot Rest  
Rear Brakes  
Shoulder Straps  
Proper use of seat height adjustment,  
shoulder straps and waist strap:  
K
Seat Height  
Adjustment  
Straps  
WARNING: Avoid Serious Injury from  
falling or sliding out. Always use seat belts  
Seat Height  
Adjustment  
Strap  
1. Place child in seat. Adjust the seat height by  
pulling or loosening straps located on the  
sides (Picture K).  
Waist Strap  
Waist Strap  
Center Crotch  
Buckle  
2. Buckle waist strap around child’s waist and  
adjust to a snug fit (Picture K).  
Shoulder Strap  
without Padded  
Covers  
3. Make sure crotch strap buckle is between  
the child’s legs, adjust length by sliding strap  
through plastic slide. Place shoulder straps  
over child’s shoulders and buckle into center  
crotch buckle. Adjust shoulder straps to a  
snug fit by sliding strap through plastic slide  
(Picture L). Replace padded covers over the  
shoulder straps.  
L
Waist Strap  
Center  
Crotch  
Buckle  
4
 
To convert stroller to a frame carrier  
M
WARNING: Please request the help of  
another adult to help you put the frame carrier  
on.  
Shoulder  
Strap  
Waist Strap  
Cover  
Sternum  
Strap  
1. With rear wheels locked, release the frame  
carrier waist strap cover located between the  
front legs.  
Sternum  
Height  
Adjustment  
Slides  
Sternum  
Buckle  
Waist Buckle  
2. Tilt the stroller back slightly, and slide the  
booties onto the front wheels. This will prevent  
your clothes being soiled by the wheels.  
N
Sternum Strap  
3. Release the waist buckle and sternum (chest)  
buckle (Picture M).  
Sternum Strap  
Waist Buckle  
4. To close the stroller, step behind the stroller,  
pull back on the side latches until they clear  
the locking pegs, handle will automatically fold  
down when stroller/carrier is lifted off the  
ground.  
Shoulder  
Strap Ends  
Waist Strap  
5. With the help of another adult to steady the  
child in the seat, stand in front of the carrier.  
Place one arm through the shoulder strap and  
lift carrier onto your shoulder/back. You will  
find this much easier if the other adult also  
assists you with holding the other shoulder  
strap and guiding it over your other shoulder.  
6. Once both shoulder straps are on, pull down  
on the shoulder strap ends to tighten. This will  
position the child higher onto your shoulders  
(Picture N).  
7. Adjust the height of the sternum straps by  
sliding them up or down. Clasp the sternum  
buckle. Pull the ends of the sternum straps to  
tighten (Picture N).  
8. Buckle the waist strap and pull end of the  
waist strap to tighten (Picture N).  
5
 
Care and Maintenance  
Check fasteners  
After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary.  
Periodically check the stroller to ensure that it is in good operating condition.  
To clean seat.  
If cleaning is required, use a soft cloth with warm water and mild soap; air dry. DO NOT BLEACH.  
To clean canopy:  
Spot clean using a soft cloth with warm water and mild soap. DO NOT BLEACH. Do not put in a  
washing machine.  
To clean frame:  
Wipe using a soft cloth with warm water and mild soap. Air dry. DO NOT USE polish or harsh  
abrasives.  
**WARNING: If you have any questions concerning the safe use of this product, please  
contact InSTEP, LLC before using.  
1-800-242-6110  
8am-5pm CST, Monday-Friday, or MAIL to:  
®
314 West 86th Street  
Bloomington, MN 55420  
Tel: 1-800-242-6110  
6
 

Intel Computer Hardware MI940 User Manual
Jabra Microphone GN405 User Manual
JVC Security Camera TK T8101WPRE User Manual
JVC Stereo System VS DT6R User Manual
Karcher Pressure Washer T350 T Racer User Manual
Kenwood Computer Monitor KVT 815DVD User Manual
KitchenAid Cooktop Kdrs505xss01 User Manual
Klipsch Speaker RC 62 User Manual
Konica Minolta Printer C10P User Manual
Kramer Electronics Webcam 2900 300283 User Manual