Quick Setup Guide
NS-NAV01 GPS
Actual product may vary from image shown.
Features
Congratulations on your purchase of a high-quality
Insignia product. Your GPS is designed for reliable and
trouble-free performance. Use this guide for initial setup.
See your User Guide for more information.
Top and side panels
Power button
Card slot
Package contents
• 4.3" GPS
• DC power adapter
• Mounting bracket
• Mounting cradle
• SD memory card
• User Guide
• Quick Setup Guide
Mounting your GPS in a car
WARNING: The assembly must not be mounted so that it impairs the driver’s view of the
road.
Bottom panel
Make sure that your car’s airbags are not obstructed by the GPS.
Use the supplied mounting bracket and cradle to mount your GPS in a vehicle.
1 Slide the mount cradle onto the end of the mounting bracket to attach it.
2 Set the bottom edge of your GPS onto the mount cradle, then push the GPS
into the tab (1) at the top of the mount cradle.
Setting up your GPS
Charging the battery
Your portable GPS comes with a built-in rechargeable
battery. Fully charge the battery before using the GPS for the
first time. Charging time is normally about three hours. A
fully charged battery delivers about two hours of use.
See “Connecting power to your GPS” below.
To remove the GPS, lift the tab (1) at the top of the mount cradle and pull
the GPS forward.
3 Lift the suction cup lever (2) and then press the suction cup to the
windshield.
4 Press the suction cup lever toward the windshield to attach the bracket to
the windshield.
Reset USB charging
hole port
Mounting
slot
Mounting
slot
5 Rotate the knob to adjust the assembly to the proper position.
Connecting power to your GPS
Connecting DC power
CAUTION: Disconnect the GPS from the DC power adapter when starting the vehicle.
• Connect the DC power adapter plug to the GPS’s USB port, then plug the other end to the vehicle’s
12-24V DC accessory socket (cigarette lighter socket).
cigarette lighter
socket
|