Quick Setup Guide
|
Crosscut Paper Shredder NS-PS10CC
Using the shredder
Warning: Always turn off the shredder when it is not in use.
Caution: Do not insert more than 10 sheets of paper, one credit card, or one disc at a
time. You may damage the shredder.
LEDs
Power
Features
Power switch
Lights green when the shredder is in use. Turns off when the shredder is in
standy-by (power-saving) mode.
LEDs
Handle
Overheat/Overload Lights red when the shredder is jammed or overheated, you have inserted
more sheets of paper than recommended or the shredder has been used
too long.
To shred paper:
Paper or disc slot
Shredder head
Wastebasket
Insert paper into the paper or disc slot. When the paper has passed
through, the shredder will stop.
Caution: Always feed paper in as straight as possible to avoid paper jams.
Door Open
Lights yellow if the wastebasket is opened or the shredder head is not
mounted correctly.
To shred discs and credit cards:
Hold the disc or credit card by the edge and feed
into the paper or disc slot one at a time, releasing
when shredding begins. The shredder stops when
the entire disc or credit card has been destroyed.
Caution: Do not hold the disc with your finger through
the center hole while feeding it into the shredder.
Serious injury may occur. Never feed more than one disc
or credit card at a time.
Setting up the shredder
Place the shredder head securely on the rim of
the supplied wastebasket.
Caution: Your shredder has very sharp, exposed
blades on the underside. Use care when mounting the
shredder to the wastebasket.
Note: Do not use bags to line the wastebasket.
2 Connect the power cord to a power outlet.
Notes:
Power switch
•
Never shred plastic (except credit cards, CDs, or DVDs), continuous forms, anything
with adhesive including labels and envelopes, newsprint, or any hard materials.
While this shredder will shred staples and small paperclips, it is recommended that
you remove them whenever possible to extend the life of your shredder.
auto The shredder starts automatically when an item is inserted into the paper or disc slot.
•
When the item has passed through the slot, the shredder stops.
off
Turns off the shredder.
rev
Use the reverse setting to clear a paper jam or to pull out unshredded paper.
Caution: Never try to clear a jam by using REV when the wastebasket is full. This could make the jam
worse.
3 Slide the power switch from off to auto.
Before using your new product, please read these instructions to prevent any damage.
|