V1
FINAL
FOR PRINT
NS-LT500P-1_15-0329_QSG_V1_EN.ai 1 4/9/2015 9:06:20 AM
Flat size (W×H): 209.2 × 148 mm.
Final folded size: 104.6 × 148 mm.
|
Quick Setup Guide NS-LT500P-1
Refrigerator Filter
Congratulations on your purchase of one of the highest performing
water filters on the market today. Insignia filters use a high-grade
coconut carbon that has 50% more micro-pores than standard carbon.
They also use fewer high-compression binders, giving you the best
water filtration possible.
INSTALLING THE WATER FILTER
1 YOU MUST SOAK your new filter in water for 15 minutes prior to
installing it in your refrigerator to remove air from the carbon block.
2 Twist the old filter a quarter-turn counter-clockwise.
3 Pull the filter straight down and discard.
4 Push the new filter up into the refrigerator until it stops.
5 Twist the filter a quarter-turn clockwise.
6 Run about two to three gallons of water through your refrigerator’s water
dispenser to remove air and loose carbon pieces. The water may be
cloudy and sputter until the air is removed.
PACKAGE CONTENTS
•
•
Refrigerator filter(s) (1 pack)
Quick Setup Guide
7 Reset your“change filter”indicator (if your refrigerator has one). See
below.
RESETTING YOUR CHANGE FILTER INDICATOR
Note: These are the most common filter reset instructions. If the instructions don’t
work for your refrigerator brand, see the documentation that came with your
refrigerator.
REFRIGERATOR BRAND INSTRUCTIONS
LG
Press and hold the reset button for three seconds.
GENERAL INSTALLATION GUIDELINES
•
It is normal for black carbon fines (particles) to appear on the outside
of your filter. This happens when the filter is jarred in shipping. It is
safe, simply wipe it off.
•
Connections on our filters are larger in size to prevent leakage. This
might require more hand leverage to install.
Before using your new product, please read these instructions to prevent any damage.
|