Folding Commode
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact carrier/dealer for further instruction.
ꢀ WARNING
• DO NOT use this product or any available optional equipment without first completely reading and
understanding these instructions and any additional instructional material such as owner’s manuals,
service manuals or instruction sheets supplied with this product or optional equipment. If you are unable
to understand the warnings, cautions or instructions, contact a healthcare professional, dealer or
technical personnel before attempting to use this equipment - otherwise, injury or damage may occur.
• Leg extensions with rubber tips MUST be in contact with the floor at all times.
• ALWAYS observe the weight limit on the labeling of your commode. Check that all labels are present
and legible. Replace if necessary.
• Ensure that the snap buttons fully protrude through the same respective adjustment hole of each leg
extension. This ensures that the leg extensions are securely locked in position and an even height
adjustment is achieved.
• Make certain ALL screws, nuts and/or bolts are tight at all times.
• Inspect rubber tips on the leg extensions for rips, tears, cracks, wear or if they are missing. Replace them
IMMEDIATELY if any of these conditions exist.
• Ensure the front crossbrace is locked into the front legs and the snap button protrudes.
• Before removing/installing seat and lid, allow seat/lid to reach room temperature if exposed to cold. This will
help prevent the seat clamps from breaking when being removed/installed onto commode back frame rail.
Installing/Removing the Back
Support
Back Support
DETAIL
“B”
DETAIL
“A”
Snap
Button
(hidden
from
NOTE: To remove the back, reverse this procedure.
Press the snap buttons on either side of the back support
and install it into the seat frame tube. Ensure snap
buttons are fully engaged (Detail “A”).
view)
NOTE: There will be an audible click.
Snap
Pail
Buttons
Folding/Unfolding the Commode
NOTE: To unfold the commode, reverse this procedure.
1. Remove the pail from the commode (Detail “A”).
DETAIL
“C”
DETAIL
“D”
Front Crossbrace
2. Press the snap buttons on either side of the front of
the seat frame (Detail “B”).
3. Lift on the front crosssbrace of the commode
(Detail “C”).
Leg
Leg
4. Swing each leg inward (Detail “D”).
Adjusting the Height
Leg Extension
1. Select desired height for commode by aligning snap button of each leg extension with
appropriate adjustment hole in leg frame.
Leg
2. Ensure snap buttons are fully engaged into adjustment hole of each leg frame and are
at the same height before using.
Snap Button
Limited Warranty
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS
MANUFACTURED AFTER JULY 4, 1975.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state.
Invacare warrants its product to be free from defects in material and workmanship for the period of one year of use by original purchaser. If
within such warranty period any such product shall be proven to be defective, such product shall be repaired or replaced, at Invacare’s option.
This warranty does not include any labor or shipping charges incurred in replacement part installation or repair of any such product. Invacare’s
sole obligation and your exclusive remedy under this warranty shall be limited to such repair and/or replacement.
For warranty service, please contact the dealer from whom you purchased your Invacare product. In the event you do not receive satisfactory
warranty service, please write directly to Invacare at the address on the back cover. Provide dealer’s name, address, model number, date of
purchase, indicate nature of the defect and, if the product is serialized, indicate the serial number.
Invacare Corporation will use a return authorization. The defective unit or parts must be returned for warranty inspection using the serial
number, when applicable, as identification within thirty days of return authorization date. DO NOT return products to our factory without our
prior consent. C.O.D. shipments will be refused; please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE
TO ADHERE TO THE ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL
NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO NEGLIGENCE,
ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STORAGE; OR PRODUCTS MODIFIED WITHOUT INVACARE’S EXPRESS
WRITTEN CONSENT (INCLUDING, BUT NOT LIMITED TO MODIFICATION THROUGH THE USE OF UNAUTHORIZED PARTS OR
ATTACHMENTS, PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC CONSENT
OF INVACARE; PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND INVACARE’S CONTROL; PRODUCTS REPAIRED BY ANYONE
OTHER THAN AN AUTHORIZED INVACARE DEALER). SUCH EVALUATION SHALL BE SOLELY DETERMINED BY INVACARE.
THE FOREGOING EXPRESS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES WHATSOEVER, WHETHER
EXPRESSED OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR
PURPOSE, AND THE SOLE REMEDY FOR VIOLATIONS OF ANY WARRANTY WHATSOEVER, SHALL BE LIMITED TO REPAIR OR
REPLACEMENT OF THE DEFECTIVE PRODUCT PERSUANT TO THE TERMS CONTAINED HEREIN. THE APPLICATION OF ANY
IMPLIED WARRANTY WHATSOEVER SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESS WARRANTY PROVIDED
HEREIN. INVACARE SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER.
THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE/PROVINCIAL LAWS AND REQUIREMENTS.
For more information regarding Invacare products, parts, and services, please visit www.invacare.com
|