®
®
EPSON PowerLite 8300i
Quick Setup
Connect the projector
to your laptop
Locate the required cables:
1
Power cord
Computer cable
Connect the computer cable to the
Computer 1 port on the projector.
2
Connect the other end to your laptop’s video-out
3
4
or
monitor port.
Plug in the power cord.
Follow these instructions to connect the projector to your
laptop. For other setup options, see your User’s Guide.
Turn on your equipment Adjust the image
If you’ve turned on your laptop and you don’t see an image, press
the Computer/DVI button on the projector to select Computer 1
as the image source.
1
Turn on your laptop.
1
2
3
NOTE: If you still see a blank screen or have other difficulties,
Remove the projector’s lens cover.
see the troubleshooting tips on the back of this sheet.
Adjust the sharpness, size, and height of the image:
2
Make sure the
power light
is orange and not flashing.
Make sure power light
is not flashing
Power button
Press the
Power button to turn on the projector.
Focus
to sharpen
the image
Zoom
to enlarge
the image
Lens Shift
to adjust the
image height
4
CAUTION: Before unplugging the projector...
To shut down the projector properly
If your image looks like
one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
or
, you’ve placed the projector off to
3
4
1. Press the
Power button twice. Let the projector cool while
the power light flashes orange (about 45 seconds).
2. Once the light stops flashing and stays on, it’s safe to unplug
If your image looks like
square up the image.
or
, use the Keystone button to
the projector.
Never unplug the projector when the
flashing orange.
power light is green or
Turn over
|