Analog output card
INSTRUCTIONS
KA-F5604U
COMP/VBS OUT
This instructions book is made from 100%
recycled paper.
For Customer Use:
Enter below the Serial No. which is
located on the body. Retain this
information for future reference.
Thank you for purchasing this JVC product.
Before operating this unit, please read the
instructions carefully to ensure the best
possible performance.
Model No. KA-F5604U
Serial No.
LWT0272-001A
SAFETY PRECAUTIONS (FOR USA AND CANADA)
CAUTION
ATTENTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE D’ELECTROCUTION
NE PAS OUVRIR
ATTENTION: POUR EVITER TOUT RISQUE D’ELECTROCUTION
NE PAS OUVRIR LE BOITER.
AUCUNE PIECE INTERIEURE N’EST
A REGLER PAR L’UTILISATEUR.
SE REFERER A UN AGENT QUALIFIE EN CAS DE PROBLEME.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
Le symbole de l’éclair à l’intérieur d’un triangle
équilatéral est destiné à alerter l’utilisateur sur la
présence d’une “tension dangereuse” non isolée
dansleboîtierduproduit.Cettetensionestsuffisante
pour provoquer l’électrocution de personnes.
The lightning flash with arrowhead symbol, within an
equilateraltriangle, isintendedtoalerttheusertothe
presence of uninsulated “dangerous voltage” within
the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to
persons.
Le point d’exclamation à l’intérieur d’un triangle
équilatéral est destiné à alerter l’utilisateur sur la
présence d’opérations d’entretien importantes au
sujet desquelles des renseignements se trouvent
dans le manuel d’instructions.
Theexclamationpointwithinanequilateraltriangleis
intendedtoalerttheusertothepresenceofimportant
operating and maintenance (servicing) instructions
in the literature accompanying the appliance.
*Ces symboles ne sont utilisés qu’aux Etats-Unis.
WARNING:
AVERTISSEMENT:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
POUR EVITER LES RISQUES D’INCENDIE
OU D’ELECTROCUTION, NE PAS
EXPOSER L’APPAREIL A L’HUMIDITE OU
A LA PLUIE.
This unit should be used with 12 V DC only.
CAUTION:
Cet appareil ne doit être utilisé sur 12 V en
courant continu.
To prevent electric shocks and fire hazards, DO
NOT use any other power source.
ATTENTION:
Afin d’éviter tout resque d’incendie ou
d’électrocution, ne pas utiliser d’autres
sources d’alimentation électrique.
NOTE:
The rating plate (serial number plate) is on this unit.
INFORMATION
REMARQUE:
La plaque d’identification (numéro de série) se
trouve sur la partie inférieure de l’appareil.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
●
●
●
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
●
technician for help.
CAUTION
INFORMATION (FOR CANADA)
RENSEIGNEMENT (POUR CANADA)
CHANGES OR MODIFICATIONS NOT APPROVED
BY JVC COULD VOID USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
This Class B digital apparatus complies with
Canadian ICES-003.
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFER-
ENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
Cet appareil numérique de la Class B est
conforme à la norme NMB-003 du Canada.
3
SAFETY PRECAUTIONS (FOR EUROPE)
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
This unit should be used with 12 V DC only.
CAUTION:
To prevent electric shocks and fire hazards, do
NOT use any other power source.
Note:
The rating plate (serial number plate) is on this unit.
CAUTION
To prevent electric shock, do not open the cabinet. No user
serviceable parts inside. Refer servicing to qualified service
personnel.
This equipment is in conformity with the provisions and protection requirements of the corre-
sponding European Directives.This equipment is designed for professional video appliances
and can be used in the following environments:
5 Residential (including both of the location type class 1 and 2 found in IEC 1000-2-5)
5 Commercial and light industrial (including, for example, theatres)
5 Urban outdoors (based on the definition of location type class 6 in IEC 1000-2-5)
This apparatus is designed for rack mounting or is used close to other apparatus.
In order to keep the best performance and furthermore for electromagnetic compatibility we
recommend to use cables not exceeding the following lengths:
Port
Cable
Length
COMP/ VBS OUT
Shielded Twist Pair Cable
less than 2 m
Caution:
5 Where there are strong electromagnetic waves or magnetism, for example near a radio or
TV transmitter, transformer, motor, etc., the picture may be disturbed.
In such a case, please keep the apparatus away from the sources of the disturbance.
4
Thank you for purchasing the KA-F5604U Analog output card.
Ⅵ By inserting this card into JVC’s color video camera
KY-F560, either composite video signal, component
video signal(Y/Cb/Cr), RGB signal or Y/C signal is
output.
COMP/VBS OUT
Analog output
terminal
Mounting this card to KY-F560 Camera
KY-F560
KY-F560 power must be switched off before mounting
the card.
1. Remove two screws Å from the rear of the camera and
take out the slot cover.
Screw Å
Slot cover
KY-F560
2. Insert this Analog output card into the slot at the rear of
This card
the camera and secure it by screwing back the two
screws Å which were taken out earlier in the above
mentioned step 1..
COMP/VBS OUT
Slot
Notes
Analog output
Ensure that the Analog output card is inserted
terminal
all the way in.
Screw Å
5
Description of Terminals
Notes
Analog Output Terminal (D-sub 9PIN,
Female)
● Cannot be connected to computer monitor.
● The output signal could be selected using
the “OUTPUT” item under the “SYSTEM”
menu screen on the KY-F560.(☞ page 7)
5
1
9
6
Pin No.
RGB output
GND
GND
R OUT
G OUT
B OUT
Y/C output
Y/Cb/Cr output
GND
GND
Cr OUT
Y OUT
Cb OUT
Composite video OUT
-
1
2
3
4
5
6
7
8
9
GND
GND
-
Y OUT
C OUT
Composite video OUT Composite video OUT
-
-
GND
GND
GND
GND
GND
GND
Connection
[ Connection example ]
When connecting
● Perform this when the devices are off.
● Read the instruction manual of the unit before preforming it.
Color video camera
KY-F560
Analog output card
KA-F5604U
D-sub 9pin (2m)
COLOR VIDEO CAMERA KY-F560
Monitor
Notes
● Please make sure to the cable with outer shield when connecting the D-sub cable.
● The screw section for mounting D-sub cable of this unit is mm specification.
When using inch type D-sub cable, change to the supplied inch type screws.
6
Menu Screen
When KY-F560 camera is mounted on this unit, new menu screens and menu items are
appeared on the screen.
The additional new menu screens and menu items will be explained here.
Please refer to KY-F560 instruction manual for details on menu screen setting.
“SYSTEM” Menu Screen
The following additional items are added to the “SYSTEM” menu screen.
The settings in bold are factory settings.
Item
OUTPUT
Function/Variables
From Analog output terminal, besides the composite signal, an-
other type of output video signal could be output. The additional
output signal is selected here.
“Y/Cb/Cr”
“RGB”
: Y/Cb/Cr component signal will be output.
: RGB component signal will be output will embed-
ded sync signal.
“Y/C”
: YC separate signal will be output.
“DISPLAY” Menu Screen
“DISPLAY” menu will be appeared, but not for this unit.
7
Specifications
Analog Output
: Composite video signal
Component signal
(Either Y/Cb/Cr,RGB or YC separate output signal could be selected)
: Supplied by camera
Power supply
Power consumption
: 9.6 W (Include KY-F560 camera)
Operating temperature range : -5 °C to 40 °C (Humidity below 80 %)
Dimensions
Weight
: (W) 22.4 mm x (H) 70.2 mm x (D) 76.5 mm (Exclude protruded part)
: 60 g
Accessories and attachments : Instruction Manual
Screws (Inch type) x 2
ꢀ Dimensions ( unit : mm )
76.5
71
22.4
COMP/VBS OUT
Specification and appearance of this unit are subject to change for further improvement
without prior notice.
is a registered trademark owned by Victor Company of Japan, Limited.
is a registered trademark in Japan, the U.S.A., the U.K. and many other countries.
Printed in Japan
LWT0272-001A
© 2005 Victor Company of Japan, Limited
|