SPEAKER STAND
LS-M1
INSTRUCTIONS
LVT1248-002A
[US]
Assembly
Installing Speaker
Before assembling—
7 Attach the speaker on the stand
• Prepare a Phillips screwdriver.
• Place a large, thick cloth on the floor where you assemble the
speaker stand to protect the floor and the speaker stand.
1 Locate the speaker properly by aligning both screw holes
of the speaker and the speaker stand.
• Do not install the speaker stand on an uneven surface or in
a place subject to vibration.
• Do not install any overweight equipment (over 10 kg) on the
speaker stand.
7 Assembling the speaker stand
• Tighten the screws firmly so that no space is left between
the legs and plates.
1 Fix the top plate.
2 Fix the speaker with the supplied screws C (M5 x 28 mm).
• Do not overtighten the screws, but firmly enough to prevent
the speakers from being shaky.
• Align the projection of the legs to the holes of the top plate
correctly, then attach them with three of the supplied
screws B (M6 x 16 mm).
Leg B (thin)
Screws B
(M6 x 16 mm)
Leg A (thick)
Top plate
Spacer
* The side without spacer should face outside.
Screw C (M5 x 28 mm)
2 Fix the bottom plate and leg holders.
• Align the projection of the legs to the holes of the bottom
plate correctly, then attach them with three of the supplied
screws A (M6 x 30 mm).
Specifications
Mass:
Spacer
Screws A
(M6 x 30 mm)
5.3 kg each
10 kg
See the diagram.
Maximum load:
Dimensions:
Leg holder
Bottom plate
Leg B (thin)
Leg A (thick)
260
330
Spacer
Unit: mm
Design and specifications subject to change without notice.
Thick cloth
(not supplied)
3 Finally tighten screws A and B fully.
• Tighten them firmly and fully so that no space is left between
the legs and plates.
3
EN, CS, CT
© 2004 Victor Company of Japan, Limited
1104NSMMDWHCE
|