www.dexpres s .com
Fax on Demand (775) 8 33-36 0 0
This Data Sheet Includes Information On
Jenn-Air
Product Model Number (s):
Built-In Electric Warming Drawer:
JWD7030CDX
Cabinet Opening
(not to scale)
•
•
•
Dimensions (Actual Size)
Cutout width: 28 1/2"
•
9 1/4"
Locate junction box
below opening bottom or
in adjacent cabinet.
Cutout height: 9 1/4"
Cutout Depth: 23 1/2"
Distance from face of cabinet to
outer edge of drawer handle: n/a
Overall unit width: 30"
Overall unit height: 10 1/2"
Depth with handle: n/a
28 1/2"
Depth without handle: 23 1/4"
23 1/2"
Oven overlap distances when using
cutout dimensions listed above:
Top overlap: 5/8"
Cabinet face
Bottom overlap: 5/8"
Right side overlap: 3/4"
Left side overlap: 3/4"
Side view of
opening
(not to scale)
•
Additional Information
•
• Electrical requirements : 3 wire, 120V, 50-60Hz. 20
amp grounded circuit. Locate electrical out let in
adjacent cabinetry within 42" of the right side of the
Wall receptacle
opening or within 16" of the left side ot the opening. DO
NOT install receptacle above the top of the opening.
• When installing below a cooktop, allow a 2" minimum
from bottom of cooktop burner box to top of warming
drawer cutout.
drawer handle clearance
n/a
• When installing below a oven, allow a 2" minimum
between cutouts.
• The cutout bottom should be solid or have braces
which adequately support the weight of the warming
drawer, especially in the rear. Install a 2x2 or 2x4 anti
tip block against rear wall 9" from bottom of opening to
bottom of block.
See page 2 for additional information
Subject to change without notice. This system is designed to
be updated daily if necessary. Dimension Express is not
responsible for use of superseded, voided, or outdated data
sheets. Because of the difficulty or impracticability of deter-
mining actual damages, liability of Dimension Express shall
not exceed $50.00.
Copyright © Dimension Express, 2003.
462
• NEVER reuse Data Sheets. Data Sheets are subject to change without
notice. Dimension Express is a FREE service bureau and is updated daily,
it makes far more sense to spend the time necessary to request new Data
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.
• Call Dimension Express if you have any questions at (775) 833-3633 •
• Always refer to a current Code at a Glance or manufacturer directory •
• Data Sheet codes change on the first of odd numbered months at 12:01am •
BN16 • A462B149 • 31646 • 031806 • 16257 • 73958
|