Q2300
Ethernet QoS Access Router
TM
For Ethernet/DSL/Cable Services
The Q2300 router makes low-cost broadband services practical for
business. Until now, business-class routers have been expensive
and overly complex to set up and use, while consumer-level DSL
and cable-modem routers have lacked business-quality monitoring,
control, and security capabilities. The Q2300 router changes all this
by combining the features of an IP router, QoS appliance, IPSec
VPN appliance, firewall, and Ethernet switch into one easy-to-use
network access device.
Business-class network access
Easy-to-use graphical interface
Best-in-class QoS reports
High-performance IP Router
Virtual Private Networking (VPN)
Network Address Translation (NAT)
Intuitive CLI for scripting
VLAN support for 8 LAN subnets
Static, RIP, and OSPF support
Ethernet WAN, PPPoE capable
QoS Appliance
Traffic reports and graphs
Auto DiffServ/ToS priority queuing
Class-based weighted fair queuing
User-configurable QoS policies
Prioritization of VoIP and video traffic
VPN Appliance
100 IPSec tunnels
Encryption (DES, 3DES, AES)
Hardware acceleration for DES/3DES
Windows XP IPsec client support
Stateful Packet Inspection Firewall
Packet filtering (access control lists)
Intrusion Detection System (IDS)
Figure 1: Graphical reports show network statistics and trends at a glance.
Denial of Service (DoS) protection
Application Layer Gateways (ALG)
Quality of Service support for VoIP and other
critical applications—right out of the box
Ethernet/DSL/Cable Services
Bandwidth monitoring and control
Alarms and diagnostics
Mission-critical applications and delay-sensitive traffic, such as VoIP
and video, can degrade significantly when competing with bursty
web traffic for WAN bandwidth. The Q2300 is pre-configured to
provide priority queuing and traffic shaping to ensure high-priority
traffic takes precedence over less critical applications. Traffic can be
classified with user-created policies, making it easy to prioritize traffic
to meet your needs.
Managed Ethernet Switch
Four 10/100 Ethernet LAN ports
Auto-sensing, auto-polarity
Figure 4: The Kentrox Q2300 router offers an intuitive, Web-style GUI to simplify setup and management.
10/100M ETHERNET LAN
10BT LINK 10BT LINK 10BT LINK 10BT LINK
Ethernet WAN
ALM ACT
MODEM
ALM ACT
RS-232
POWER
12 VDC
RESET
PORT
1
PORT
2
PORT
3
PORT
4
Protect your network investment with
support plans and technical training
To keep your network healthy and productive, Kentrox
4 x 10/100 10/100
LAN WAN
Modem
(optional)
Control
port
™
offers Kentrox Care Support Plans for our Q-Series
access routers. Kentrox technical training courses are also
available on site or at the Kentrox campus to help you get
the most out of your Q-Series routers. For details, visit our
website at www.kentrox.com/services.
KENTROX CARE SERVICE AND SUPPORT
PART #
Onsite 7x24x4
Onsite 5x8x4
13803
13813
13802
13812
13804
13809
13820
13830
Onsite 7x24xNBD
Onsite 5x8xNBD
Basic 7x24xNBD
Exchange NBD
Onsite Installation
Phone Installation
ORDERING INFORMATION
DESCRIPTION
CATALOG #
Q2300 Ethernet QoS Access Router
Q2301 Ethernet QoS Access Router with Modem
Items included with the Q2300 and Q2301:
2300
2301
KENTROX TECHNICAL TRAINING
PART #
- Documentation CD (includes Adobe® Acrobat® PDF versions of
the Setup Guide, the User’s Guide and the CLI Reference Guide)
- AC-DC power adapter and cable for use in North America
- One 6’ Ethernet LAN cable, Cat 5E, UTP 568B
- One CLI serial to PC adapter, RJ45 female to DE9 female
(for use with external Ethernet cable)
Customer Site
Basic Config & Maintenance Lecture, 1 day
133811
133812
Advanced Config & Maintenance Lecture, 1 day
Per student charge for lecture in excess of
8 students, per day
133819
- Two #8 wood screws and anchors for wall-mounting
Kentrox Campus
Basic Config & Maintenance Lecture, 1 day
Ethernet Cable, Cat 5E, 6'
Q2300 19" Rack Mounting Kit
93006212
77912
133851
133852
Advanced Config & Maintenance Lecture, 1 day
Q2300 CLI Serial to PC Adapter, RJ45 Female to DE9
Female (for use with external Ethernet cable)
77910
3
SPECIFICATIONS
INTERFACES
ROUTER
WAN:
LAN:
One 10/100Base-Tx (RJ45)
Four-port, 10/100 Ethernet switch (RJ45)
auto-sensing, auto-polarity
One RS-232 (RJ45)
One V.92 modem (RJ11C) for dial-in management
Routing:
Static, RIP v1/v2, and OSPF
DHCP server, client, relay
DNS client, DNS relay
VLAN support for 8 LAN subnets
Load balanced on 4 equal cost routes
Control port (CLI):
Modem (optional):
MANAGEMENT/ADMINISTRATION
GUI: Intuitive Web-style GUI (accessible from WAN
or LAN)
Access Management: Three levels—admin, configure, view;
up to 10 users with passwords
QUALITY OF SERVICE
Bandwidth
Management:
Class-based Weighted Fair Queuing
Auto DiffServ/ToS-based priority queuing
VoIP and video prioritization
All DiffServ classes supported
Logs:
Alarm, System, Intrusion, Traffic, VPN
Syslog support
Configurable queue weighting
Configurable QoS marking
32 user-configurable QoS policies for prioritization
by source and destination addresses, port,
protocol, DiffServ Code Point (DSCP)
QoS traffic reports and graphs
Configurable WAN Latency report
Supports 802.1P user priority and
VLAN 802.1Q tags
Marking:
Policies:
SNMP:
Updates:
CLI:
Traps, MIB II, I/F MIBs
Software updates via FTP or GUI
Intuitive command line interface (CLI) accessible
via control port, Telnet, SSH, or modem
SNTP support and 8-hour power failure backup
Monitoring:
Standards:
Real-time Clock:
FIREWALL
Protection Methods:
Stateful Packet Inspection designed for ICSA
compliance
DIAGNOSTIC LEDS (FRONT PANEL)
Denial of Service (DoS)
Intrusion Detection System (IDS)
Blacklist
TCP and UDP packet filtering
NAT
System:
WAN:
LAN:
System status, security alert, modem status
Port status, Tx status, Rx status
Port status, Tx status, Rx status
PHYSICAL
Application Layer Gateways (ALG)
50 user-configurable policies
16 mapped IP (virtual DMZ/port forwarding)
Trusted, Untrusted, DMZ
Dimensions:
1.6" H x 11.8" W x 8.6" D
Policies:
Mapped IP:
Zones:
(44mm H x 300mm W x 219mm D)
3.8 lbs. (1.72 kg)
Universal AC adapter, 100-240 VAC input,
50-60 Hz; power consumption: ≤ 20W
Table-top, wall-mount or optional
19" rack-mount (1RU)
Weight:
Power:
VIRTUAL PRIVATE NETWORK (VPN)
Mounting Options:
IPSec:
100 IPSec VPN tunnels
Internet Key Exchange (IKE)
Main and aggressive modes
Diffie-Hellman MODP groups 1, 2, and 5
Perfect Forward Secrecy (PFS)
IPSec NAT traversal
ENVIRONMENT
Operating:
0° to 50°C (32° to 122°F)
5% to 95% RH (non-condensing)
-20° to 66°C (-4° to 150°F)
Storage:
Authentication:
Encryption:
Pre-shared key
X.509 certificates
DES, 3DES, AES (128 bit), hardware acceleration
for DES/3DES
5% to 95% RH (non-condensing)
REGULATORY
Emissions:
Safety:
FCC 47 CFR 15 Class A
ANSI/UL 60950-1-2002
CAN/CSA-C22.2 No 60950-1-03
FCC 47 CFR 68
Hash algorithms:
MD5 and SHA-1
WAN PROTOCOLS
Terminal:
Protocols:
IP or PPPoE
IC CS-03
05-15-002-3 3/06 Copyright © 2006 by Kentrox, LLC. All Rights Reserved. Kentrox is a registered trademark and Q-Series is a trademark of Kentrox, LLC.
Information published here is current as of this document’s date of publication, but is subject to change without notice. You may verify product information by
contacting our headquarters in Hillsboro. Kentrox is an Equal Employment Opportunity/Affirmative Action employer.
Kentrox, LLC
20010 NW Tanasbourne Dr.
Hillsboro, OR 97124
Phone 503-643-1681
Service and Support 800-733-5511
|