KITCHEN TOOLS
6
Kettle SWKT 3000 A1
Kettle
Operating instructions
KOMPERNASS GMBH
BURGSTRASSE 21 · D-44867 BOCHUM
ID-Nr.: SWKT3000A1-07/10-V1
CONTENT
PAGE
Intended Use
2
2
2
2
2
3
3
4
5
5
5
5
Technical Data
Items supplied
Operating elements
Safety Instructions
Starting Up the Device
Boiling Water
Cleaning and Care
Storage
Disposal
Warranty & Service
Importer
Read the operating instructions carefully before using the appliance for the first time and preserve this boo-
klet for later reference. Pass the manual on to whomsoever might acquire the scale at a later date.
- 1 -
KETTLE
Safety Instructions
Intended Use
ƽ To avoid the risk of fatalities from electric
shocks:
This device is intended for heating water for house-
hold use. It is not intended for use with other liquids
or for commercial use.
• Make certain that the base
with the electrical
t
connections never comes into contact with
water! Let the base become completely dry
t
before using if it has accidentally become wet.
• Only use the hot water kettle with the supplied
Technical Data
base
.
t
• Make sure that the power cord never becomes
wet or damp during operation. Lay the cord such
that it cannot be pinched or otherwise
Voltage:
220 - 240 V / 50 Hz
~
Power consumption: 2500 - 3000 W
damaged.
ꢀ In older electrical installations, the building
fuse (12A) may be triggered due to the high
power consumption.
• Arrange for defective power plugs and/or
cables to be replaced as soon as possible by a
qualified technician or by our Customer Service
Department to avoid the risk of injury.
• Always pull the plug out of the power socket
after use. Switching off the device is not sufficient
because the device receives power as long as
the power plug is connected to the socket.
Items supplied
Water boiler with stand and spout strainer
Operating Instructions
Ensure that the appliance, the power cable
and the power plug are NEVER submersed
in water or other fluids.
Operating elements
Lid
ƽ To prevent the risk of fire or injury:
q
Unlocking button
ON/OFF switch
Operating light
Base
Temperature control
Kettle
• Always heat water with a closed lid , otherwi-
w
e
r
t
y
u
i
o
q
se the automatic cut-out mechanism doesn’t
work. Boiling water can then spray out over the
edge.
• Hot steam clouds may be released. The kettle
is also very hot during operation. Wear oven
mits.
• Make certain that the device rests firmly and ver-
tically before switching it on. Boiling water can
cause an unstabile kettle to fall over.
u
Level indicator
Spout screen
• Do not use an external timing switch or a separate
remote control system to operate the appliance.
Download from Www.Somanuals.co-m2.-All Manuals Search And Download.
• Do not allow individuals (including children) to
use the appliance whose physical, sensorial or
mental abilities or lack of experience and know-
ledge hinder their safe usage of it if they have
not previously been supervised or instructed in its
correct usage.
• Lift away the kettle
for filling!
u
• Open the lid
by pressing down on the unlok-
q
king button
.
w
• Hold the kettle
vertically while filling. Only
u
then will the level indicator
correctly indicate the water volume.
on the side
i
• Tell children about the appliance and its potenti-
al dangers so that they do not play with it.
Fill the kettle ...
– at least to the MIN mark so that the device does
u
not overheat,
– no higher than the MAX mark so that no boiling
water spills out.
Starting Up the Device
• First close the lid ...
q
• Before starting up the device, make certain that...
– the device, plug and power cable are in good
working order and...
• then place the kettle
straight on the base
• Set the desired water temperature using the
on the base
until it sits
u
t
.
t
– all packaging materials have been removed
from the device.
temperature control
To bring the water to a boil, you must set the
.
y
• Fill the device with water up to the MAX mark
and let it come to a full boil once as described in
the next section. Pour out this water.
temperature controller to the MAX position.
• Now insert the power plug into the power
y
socket and press the ON/OFF switch
until it snaps in.
down
e
• The operating light
now heating up.
indicates that the device is
r
Boiling Water
ƽ Danger! Never place the electrical base
Transition-
range
near water – life-threatening danger!
ƽ Warning: Pull the power plug from the
socket before lifting the kettle
from the
u
MIN
base . This prevents any water
t
splashing out from contacting the electrical
connections in the base , which could
cause a short circuit.
t
MAX
For safety reasons, the lid
should not
q
be opened while the water is boiling or is
very hot. Otherwise there is a risk of
injury.
Temperature regulator in the boiling range
• The devices switches off automatically and the
You should only heat as much water as you need
directly. That helps you save electricity, water and
time:
operating light
is at a full boil. The ON/OFF switch
out.
goes out as soon as the water
r
springs
e
- 3 -
In order to keep the water warm after bringing it to
Cleaning and Care
a boil, set the temperature regulator
warm range.
in the keep
y
ƽ Danger!: Do not open any part of the
housing. There are no operating elements
inside. An open housing can create the risk
of a life-threatening electrical shock.
Press the ON/OFF switch
down, until it snaps in.
e
Temperature regulator in the keep warm range
The left end of the keep warm range indicates the
lower temperature. The right end of the keep warm
range indicates the higher temperature.
(The water does not start boiling in the keep warm
range!).
Never submerse any parts of the device in
water or other liquids! This can create the
risk of a life-threatening electrical shock if
residual liquid comes into contact with
powered components.
• After reaching the desired temperature, the ap-
pliance switches off the heating process. The
Before cleaning the device, ....
• First pull the power plug out of the power socket
and let the device cool completely.
ON/OFF switch
and the operating lights
e
r
remain switched on.
• Clean the exterior surfaces and the power cord
with a slighly damp cloth. Always dry the device
well before using it again.
• Never use any cleansers, abbrasive substances
or solvents. These can damage the device.
ꢀ Because the device is equipped with a heat
maintenance function, the device automatically
begins reheating as soon as the water tempe-
rature falls below the set temperature.
The appliance heats until the desired tempera-
ture is reached. Make sure that the appliance
does not automatically switch on to the keep
warm function. Therefore, do not leave the
appliance unsupervised!
In the event of calcium deposits
• Purchase a decalcifying agent suitable for use
with food containers from a household goods
stores (e.g. coffee machine decalcifier).
• As soon as the kettle
is lifted from the base
• You can use a suitable product from a
specialised dealer for the stainless steel
container bottom.
u
, the ON/OFF switch
t
jumps out and the
e
operating lights
switch off.
r
• In order to halt the heating process, push the
ON/OFF switch up again. The operating
Removing / replacing the spout screen
e
light
goes out then as well.
• Open the lid
completely.
r
q
• Press down on the edge of the spout screen
o
ꢀ Avoid setting the temperature regulator in
from above in order to remove it toward the insi-
de.
y
the transition range, as the water can start boi-
ling on account of varying filling levels.
• Clean the spout screen
moistened wash cloth.
with a lightly
o
• After cleaning, insert the spout screen
above and press it firmly into place.
from
o
Download from Www.Somanuals.co-m4.-All Manuals Search And Download.
• Should the scale deposits in the pourer sieve
The warranty covers only claims for material and
manufacturing defects, but not for transport dama-
ge, for wearing parts or for damage to fragile com-
ponents, e.g. buttons or batteries. This product is for
private use only and is not intended for commercial
use. The warranty is void in the case of abusive and
improper handling, use of force and internal tampe-
ring not carried out by our authorized service
branch. Your statutory rights are not restricted in
any way by this warranty.
The warranty period will not be extended by repairs
made under warranty. This applies also to replaced
and repaired parts. Any damage and defects extant
on purchase must be reported immediately after un-
packing the appliance, at the latest, two days after
the purchase date. Repairs made after the expira-
tion of the warranty period are subject to payment.
o
be firmly settled, lay it in a water-vinegar solution,
with a ratio of 6:1, for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve
with lots of clear water.
o
Storage
Let the device cool completely before storing it.
• Wind the power cord around the holder on the
bottom of the device.
• Store the device in a dry place.
Disposal
Do not dispose of the appliance in your
normal domestic waste. This product is
subject to the European guideline
2002/96/EC.
DES UK LTD
Tel.: 0871 5000 700 (£ 0.10 / minute)
e-mail: [email protected]
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Kompernass Service Ireland
Tel.: 1850 930 412 (0,082 EUR/Min.)
Standard call rates apply. Mobile operators may vary.
e-mail: [email protected]
Dispose of all packaging materials in an
environmentally friendly manner.
Importer
KOMPERNASS GMBH
BURGSTRASSE 21
Warranty & Service
D-44867 BOCHUM
The warranty for this appliance is for 3 years from
the date of purchase. The appliance has been ma-
nufactured with care and meticulously examined be-
fore delivery. Please retain your receipt as proof of
purchase. In the event of a warranty claim, please
make contact by telephone with our Service Depart-
ment. Only in this way can a post-free despatch for
your goods be assured.
- 5 -
|