1. KEYPAD DETAIL
2. TYPICAL WIRELESS KEYPAD PLACEMENT
DXS-10
PRESS AND
HOLD FOR
2 SECONDS
GREEN
OPERATION
LIGHT
WIRELESS
KEYPAD
MODE BUTTONS
FOR CHANGING
MODES
BY
FIRE BUTTON
TO SOUND
SIREN AT ANY
TIME
FRONT
ROOM
For Use With DVS-2400
Security Console
EMERGENCY
BUTTON TO
WINDOW
TRANSMITTERS
SOUND SIREN
AT ANY TIME
BEDROOM
Installation
Instructions
MAIN
CONSOLE
FRONT
DOOR
WIRELESS
KEYPAD
PRESS THE STAR
KEY TO RESET THE
KEYPAD IF YOU ENTER
THE WRONG CODE
KITCHEN
KEYPAD FOR
ENTERING YOUR
USER CODE
KEY TO ACTIVATE
HOME AUTOMATION
OUTPUT (A)
(760) 438-7000 • FAX (760) 438-7043
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
3. OPENING KEYPAD
4. TABLE-TOP USE
5. WALL MOUNTING (INDOORS ONLY)
FROM TOP OF CASE TWIST
SCREWDRIVER BETWEEN
CASE HALVES UNTIL IT
POPS OPEN
USE THE FOUR SCRATCH
DETERRENT PADS PROVIDED
FOR TABLE-TOP USE
ATTACH REAR CASE TO WALL
WITH THE TWO SCREWS PROVIDED
CONNECT BATTERY
TO BATTERY CLIP
MOUNT AT A CONVENIENT
LOCATION NEAR PRIMARY
ENTRY/EXIT DOOR
6. CLOSING KEYPAD
7. PROGRAM KEYPAD INTO CONSOLE
LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship
fortwelve (12)months. TheWarranty ExpirationDateislabeledontheproduct.
This warranty extends only to wholesale customers who buy direct from Linear
or through Linear’s normal distribution channels. Linear does not warrant this
product to consumers. Consumers should inquire from their selling dealer as to
the nature of the dealer’s warranty, if any. There are no obligations or liabilities
on the part of Linear Corporation for consequential damages arising out of or
in connection with use or performance of this product or other indirect
damageswith respecttolossofproperty,revenue,orprofit,orcostofremoval,
installation, or reinstallation. All implied warranties, including implied warranties
for merchantability and implied warranties for fitness, are valid only until Warranty
Expiration Date as labeled on the product. This Linear Corporation Warranty is
in lieu of all other warranties express or implied.
2
SEND SIGNAL
FROM KEYPAD
THEN, SNAP CASE SHUT
START IN
TEST MODE
TEST
ENTER MASTER
USER CODE
PRESS
TEST UNUSED SENSOR
NUMBER
ENTER AN
All products returned for warranty service require a Return Product Authorization
Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA#
and other important details.
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important
need in portable wireless signalling. However, there are some limitations which must
be observed.
✶
For U.S. installations only: The radios are required to comply with FCC Rules
and Regulations as Part 15 devices. As such, they have limited transmitter
power and therefore limited range.
A receiver cannot respond to more than one transmitted signal at a time and
may be blocked by radio signals that occur on or near their operating
frequencies, regardless of code settings.
HOLD OFF BUTTON
FOR 3 SECONDS WHEN
FINISHED TO EXIT
LEARN MODE
✶
✶
✶
Changes or modifications to the device may void FCC compliance.
Infrequently used radio links should be tested regularly to protect against
undetected interference or fault.
✶
A general knowledge of radio and its vagaries should be gained prior to acting
as a wholesale distributor or dealer, and these facts should be communicated
to the ultimate users.
PRESS STAR KEY
TO SEND SIGNAL
1
FIRST HOOK BOTTOM
EDGE TOGETHER
Copyright © 2001 Linear Corporation
213007 D
|