Steps to configure
Linksys - PAP2 Analog Telephone Adaptor
Configuration Guide
Open Internet Explorer (or any other) web browser on your computer.
Enter the IP address of the ATA in the address field. For example, if it is
5
A login screen will appear. Leave the User Name Field blank. Enter
admin in the Password field.Then click OK button.
6
7
Click Line 1 to enter the SIP Configuration. The configuration informa-
tion is available in the self-configuration tab in Owtalk after sign-up or
click View SIP Account Configuration in Owtalk My Account page.
Fill in the 10-digits Owtalk SIP User Name in the field of Display Name, User ID and
Auth ID.
Fill in the Owtalk SIP Password in the field of Password.
Fill in the Owtalk SIP Proxy/Server in the field of Proxy.
The SIP port number is set at 6060. For the remaining tabs, you can accept the
default settings, or you change them to suit your setup.
8
9
Click Save Settings to enable the settings.
After the ATA set up procedure is complete, the device is ready for use and you
can now receive and make outgoing calls.
10
Appendix A
Owtalk Preconfigured
Linksys ATA
To activate your Owtalk preconfigured device, you need to obtain an
activation number. Go to My Account after sign-up for Owtalk at
the activation number.
Simply dial the activation number after connecting your ATA to your
cable/ADSL modem, router, or broadband Internet connection. Your ATA is
then all set and ready for use.
|