User Manual
DiskOnChip 9x12 BGA-to-32-Pin
DIP Adapter
SEPTEMBER 2002
93-SR-002-26-6L
DiskOnChip 9x12 BGA-to-32-Pin DIP Adapter
1 General
The DiskOnChip 9x12 BGA-to-32-pin DIP adapter enables developers to evaluate M-Systems’
DiskOnChip BGA 9x12 devices with any M-Systems evaluation board that contains a 32-pin or
40-pin DIP socket.
1.1 Supported DiskOnChip Devices
The DiskOnChip 9x12 BGA-to-32-pin DIP adapter supports DiskOnChip Millennium Plus 9x12 mm
BGA in 16MB, 32MB and 64MB capacities, and Mobile DiskOnChip Plus in 16MB, 32MB and
64MB capacities. See Section 3.1 for ordering information on the supported DiskOnChip devices.
1.2 Compatible DiskOnChip Accessories
The following DiskOnChip accessories contain a DIP socket (32-pin or 40-pin) and can be used with
the adapter:
• ISA Bus EVB for 3V DIP
• ISA Bus EVB for 5V DIP
• PCI EVB (for all products except DIMM)
• GANG Programmer, Revision C
Note: The Local Bus EVB for 9x12 BGA and DIP products contains an on-board 9x12 BGA socket,
therefore the 9x12 BGA-to-32-pin DIP adapter is not required.
See Section 3.2 for ordering information on the supported DiskOnChip accessories.
93-SR-002-26-6L
3
DiskOnChip 9x12 BGA-to-32-Pin DIP Adapter
2 Using the DiskOnChip 9x12 BGA-to-32-Pin DIP Adapter
2.1 Jumper Settings
The adapter contains the following four jumpers:
• J1: Not used, and should be left open.
• J2: Used for the device LOCK# pin. The default setting is open and leaves the LOCK# pin
negated.
• JP1 and JP2: Used for matching the host voltage supplied by the EVB or the GANG
Programmer, either 3.3V or 5V. Also used for setting the VCCQ for DiskOnChip. See Table 1
for the correct settings.
Table 1: Jumper Settings for Voltage Configuration
Host Voltage
Required VCCQ Voltage
JP1
1-2
2-3
1-2
2-3
JP2
2-3
2-3
1-2
1-2
5V
5V
3.3V
1.8V
3.3V
1.8V
3.3V
3.3V
Note: For devices where VCCQ=VCC, a VCCQ voltage setting of 1.8V will not work.
2.2 Inserting the Adapter into a DIP Socket
To insert the adapter into a DiskOnChip EVB or GANG Programmer equipped with a DIP
socket:
1. Identify pin #1 of the DIP adapter by locating the white triangle on the PCB. Pin #1 is located on
the left side of the triangle. Figure 1 illustrates the location of the white triangle.
2. Insert the adapter by aligning pin #1 of the adapter with pin #1 of the DIP socket on the EVB or
GANG Programmer.
White triangle
next to Pin #1
White line for
alignment ball
Pin #1 DIP
adapter
Figure 1: DiskOnChip 9x12 BGA-to-32-Pin DIP Adapter
93-SR-002-26-6L
4
DiskOnChip 9x12 BGA-to-32-Pin DIP Adapter
2.3 Inserting DiskOnChip into the Adapter
To insert a DiskOnChip 9x12 BGA device into the adapter:
1. Identify the alignment ball (A) of DiskOnChip, at location C1 in the ball diagram. Refer to the
relevant data sheet for more information on the ball diagram.
2. Place DiskOnChip in the socket so that the alignment ball faces the white line on the PCB. See
3 Ordering Information
3.1 DiskOnChip
Ordering information for DiskOnChip devices supported by the BGA-to-32-pin DIP adapter is listed
Table 2: Ordering Information for Supported DiskOnChip Devices
Device
Capacity
16MB
32MB
64MB
16MB
32MB
64MB
Product Number
MD3831-D16-V3Q18-T
MD3831-D32-V3-T
DiskOnChip Millennium Plus
MD3331-D64-V3-T
MD3831-D16-V3Q18-T
MD3331-D32-V3Q18-T
MD3331-D64-V3-T
Mobile DiskOnChip Plus
3.2 DiskOnChip Accessories
Ordering information for DiskOnChip accessories that can be used with the BGA-to-32-pin DIP
adapter is listed in Table 3.
Table 3: Ordering Information for Compatible DiskOnChip Accessories
Accessory
ISA Bus EVB for 3V DIP
Product Number
DIP-ISA-V3-EVB
ISA Bus EVB for 5V DIP
PCI EVB
DIP-ISA-V5-EVB
PCI-EVB-V1
GANG Programmer, Revision C
DOC-DIP-GANG
93-SR-002-26-6L
5
DiskOnChip 9x12 BGA-to-32-Pin DIP Adapter
How to Contact Us
Website:
General Information:
Technical Information:
USA
China
M-Systems China Ltd.
M-Systems Inc.
25A International Business Commercial Bldg.
Nanhu Rd., Lou Hu District
Shenzhen, China 518001
Phone: +86-755-2519-4732
Fax: +86-755-2519-4729
8371 Central Ave, Suite A
Newark CA 94560
Phone: +1-510-494-2090
Fax: +1-510-494-5545
Taiwan
Europe and Israel
M-Systems Asia, Ltd.
Room B, 13 F, No. 133 Sec. 3
Min Sheng East Road
Taipei, Taiwan R.O.C.
Phone: +886-2-8770-6226
Fax: +886-2-8770-6295
M-Systems Flash Disk Pioneers Ltd.
7 Atir Yeda St.
Kfar Saba 44425, Israel
Phone: +972-9-764-5000
Fax: +972-3-548-8666
Japan
M-Systems Japan Inc.
Asahi Seimei Gotanda Bldg., 3F
5-25-16 Higashi-Gotanda
Shinagawa-ku Tokyo, 141-0022
Phone: +81-3-5423-8101
Fax: +81-3-5423-8102
© 2002 M-Systems Flash Disk Pioneers, Ltd. All rights reserved.
This document is for information use only and is subject to change without prior notice. M-Systems Flash Disk Pioneers Ltd. assumes no
responsibility for any errors that may appear in this document. No part of this document may be reproduced, transmitted, transcribed, stored in
a retrievable manner or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic,
optical, chemical, manual or otherwise, without prior written consent of M-Systems.
M-Systems products are not warranted to operate without failure. Accordingly, in any use of the Product in life support systems or other
applications where failure could cause injury or loss of life, the Product should only be incorporated in systems designed with appropriate and
sufficient redundancy or backup features.
Contact your local M-Systems sales office or distributor, or visit our website at www.m-sys.com to obtain the latest specifications before
placing your order.
DiskOnChip®, DiskOnChip Millennium Plus® TrueFFS® and DiskOnKey® are registered trademarks of M-Systems. FFD™ and SuperMAP™
are trademarks of M-Systems. Other product names mentioned in this document may be trademarks or registered trademarks of their
respective owners and are hereby acknowledged.
93-SR-002-26-6L
6
|