Installation Guide
N600 Wireless Dual Band Gigabit Router
Step 1:
Step 2:
WNDR3700v4
(not included)
Connect one end of the
yellow Ethernet cable
Unplug the power
Laptop or desktop
computer
to turn off your modem.
to your modem, and the
other end to the Internet
port on your router.
Step 5:
Connect your computer
to the router ( ).
Package Contents
DSL
Use another Ethernet cable to
establish a wired connection
as shown in this diagram.
Internet
Optionally, connect wirelessly
by using the preset wireless
security settings, located on
the bottom label.
Power On/Off
Power On/Off
Modem
Ethernet cable
Step 3:
Step 6:
N600 Wireless Router
Plug in the power to
turn on your modem.
Open a browser.
Step 4:
If the web page does not
display, close and re-open
the browser, then enter
in the address bar, or
check the “Troubleshooting”
section on the back of
this installation guide.
Connect the power adapter to the
router, then plug it into an outlet.
Wait approximately 2 minutes
until your modem turns on.
GHz
2.4
Wait for the 2.4 GHz LED (
to light.
)
If your modem has
a battery backup,
first remove and reinsert
the battery before connecting
your modem to power.
N600 Wireless Router
Power adapter
If none of the LEDs light, make sure
that the Power On/Off button is in the
on position (pushed in).
|