Panasonic Garage Door Opener CZ RD516C 1 User Manual

User Manual/Mode d’emploi  
Wired Remote Control/Télécommande câblée  
CZ-RD516C-1  
User Manual  
Wired Remote Control  
2-5, 10  
Mode d’emploi  
Télécommande câblée  
6-10  
F569672  
 
Press the remote control’s button  
TO TURN ON OR OFF THE UNIT  
9
RETRIEVE ERROR CODE  
1
a
• During operation, the unit stops and both  
• Please be aware of the OFF indication on the  
remote control display to prevent the unit from  
starting/stopping improperly.  
and b is OFF indicates abnormality occurs.  
a
1.Ensure  
2.Press  
is OFF, press  
for 5 seconds.  
or  
. If error code and abnormality  
2
TO SET TEMPERATURE  
• Selection range: 60°F ~ 86°F.  
TO SELECT OPERATION MODE  
a
can be identied,  
then write down the error code.  
3.Press for 5 seconds to quit checking.  
will be ON continuously,  
3
4.Turn the unit off and reveal the error code to  
authorized dealer.  
AUTO mode - For your convenience  
• Unit selects operation mode during startup  
according to temperature setting and room  
temperature.  
Note: Press  
for 10 seconds to enter AC reset  
switch (Not used in normal operation).  
HEAT mode - To enjoy warm air  
• Unit takes a while to warm up. The power  
indicator blinks during this operation.  
10 AIR FILTER MAINTENANCE  
Cleaning is needed when “FILTER CHECK”  
indicator is ON.  
COOL mode - To enjoy cool air  
• Use curtains to screen off sunlight and outdoor  
heat to reduce power consumption during cool  
mode.  
DRY mode - To dehumidify the environment  
• Unit operates at low fan speed to give a gentle  
cooling operation.  
• lt is recommended to clean the air lter every 6  
weeks.  
4
TO SELECT FAN SPEED  
• After the air lter is cleaned, press  
reset.  
to  
FAN SPEED  
• Do not operate without an air lter.  
• Wash/rinse the lters gently with water to avoid  
damage to the lter surface.  
• Do not dry the part with a hair dryer or a stove.  
• Replace any damaged lters.  
• For AUTO, the indoor fan speed is  
automatically adjusted according to the  
operation mode.  
5
TO ADJUST AIRFLOW DIRECTION  
• Keeps the room ventilated.  
• In COOL/DRY mode, if AUTO is set, the louver  
swing left/right and up/down automatically.  
• In HEAT mode, if AUTO is set, the horizontal  
louver x at predetermined position. The  
vertical louver swing left/right after the  
temperature rises.  
• For Hide-Away models, AIR SWING buttons  
are not in use. Airow direction can not be  
adjusted.  
Press and hold for approximately 10  
seconds to show temperature setting in °C  
or °F.  
6
Press and hold for 5 seconds to dim or  
restore the unit’s indicator brightness.  
7
8
Press to restore the remote control’s  
default setting.  
3
 
To set the timer  
DAILY TIMER SETTING  
WEEKLY TIMER SETTING  
To turn ON or OFF the unit at a preset time.  
• Daily timer and weekly timer could not be set at  
the same time.  
• Promotes energy saving by allowing you to set  
up to 6 programmes in any given day.  
1
3
4
1.Press TIMER  
for 4 seconds to change  
2
display to weekly timer.  
• Press once to change the display from  
Clock to Timer or vice-versa.  
1
• Press for more than 4 seconds to change  
the display from Daily Timer to Weekly  
Timer or vice-versa.  
2.Press TIMER  
day.  
or  
to select your desired  
2
3
4
Select ON or OFF timer  
Set the time  
3.Press  
to conrm your selection.  
4.“1” will be blinking, press  
1.  
to set programme  
Conrm  
5.Press TIMER  
to select ON or OFF timer.  
or to select your desired  
To cancel ON or OFF timer, press  
.
• Timer operation is based on the clock set in the  
remote control and repeats daily once set.  
• The timer closest to the current time will be  
activated rst.  
6.Press TIMER  
time.  
If you want to set the timer together with your  
• If timer is cancelled manually or due to power  
failure, you can restore the previous setting by  
desired temperature, press  
temperature.  
to select the  
pressing  
.
7.Press  
to conrm programme 1. The selected  
day will be highlighted with  
.
• After 2 seconds, the display will move to the  
next programme. Repeat steps 4 to 7 to set  
programmes 2 to 6.  
• Same timer programme cannot be set in the  
same day.  
• During timer setup, if no button is pressed within  
30 seconds, or if the  
button is pressed, the  
setting at that moment is conrmed and timer  
setup is ended.  
4
 
OPERATION DETAILS  
NOTE  
The timer setting will shown at wired remote  
control only but not at indoor unit’s TIMER  
indicator.  
• POWERFUL, QUIET operation setting could be  
operate according to wireless remote control.  
• When wired remote control is in operation, the  
timer setting from wireless remote control will be  
cancelled.  
Check Current Timer Programme  
Perform the step below to check the timer  
programme for a particular day.  
1.Press TIMER  
to enter timer mode.  
2.Press  
to enter day setting.  
3.Press TIMER  
shown, press  
or  
to conrm your selection.  
or to check the set  
until your desired day is  
4.Press TIMER  
programmes.  
Modify Current Timer Programme or Add  
New Timer Programme  
1.Press TIMER  
to enter timer mode.  
2.Press  
to enter day setting.  
3.Press TIMER  
shown.  
or  
until your desired day is  
4.Perform steps 4 to 7 of “WEEKLY TIMER  
SETTING” to modify existing timer programme,  
or add any timer programme.  
Cancel Current Timer Programme  
Perform the step below to cancel the timer  
programme for a particular day.  
1.Press  
to enter day.  
2.Press TIMER  
shown.  
or  
until your desired day is  
3.Press  
to enter programme setting.  
4.Press TIMER  
or until your desired  
programme is shown.  
Press to cancel the programme and  
will disappear.  
Disable & Enable Weekly Timer  
To disable weekly timer setting, press TIMER  
, then press  
To enable previous weekly timer setting, press  
TIMER , then press  
.
.
5
 
Information/Informations importantes  
Federal Communications Commission Interference Statement  
This device complies with part 15 of the FCC Rules. Operation is subject to the following two  
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any  
interference received, including interference that may cause undesired operation.  
This equipment has been tested and found to comply with the limits for a Class B digital device,  
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This equipment generates, uses and can  
radiate radio frequency energy and, if not installed and used in accordance with the instructions,  
may cause harmful interference to radio communications. However, there is no guarantee  
that interference will not occur in a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the interference by one or more of the following  
measures:  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and the receiver.  
• Connect the equipment to an outlet on a circuit different from that to which the receiver is  
connected.  
• Consult the dealer or an experienced radio/TV technician for help.  
FCC Caution: To assure continued compliance, follow the attached installation instructions. Any  
changes or modications not expressly approved by the party responsible for compliance could void  
the user’s authority to operate this equipment.  
Industry Canada Notice  
This Class B digital apparatus complies with Canadian ICES-003.  
Avis de la FCC  
Cet appareil est conforme à la section 15 des règlements de la FCC. Le fonctionnement est soumis  
aux deux conditions suivantes : (1) cet appareil ne doit pas émettre de brouillage nuisible, et (2) cet  
appareil doit accepter toute interférence, y compris toute interférence qui pourrait occasionner un  
fonctionnement inopportun.  
Ce matériel a fait l’objet de tests et il a été trouvé conforme aux limites établies pour un appareil  
numérique de la classe B comme il est stipulé à la section 15 des règlements de la FCC. Ces  
limites sont conçues pour assurer une protection raisonnable contre le brouillage nuisible dans un  
environnement résidentiel. Ce matériel génère, utilise et peut émettre de l’énergie de fréquence  
radio et, s’il n’est pas installé et utilisé conformément aux instructions, il peut provoquer un brouillage  
nuisible aux communications radio. Cependant, on ne peut garantir que le brouillage n’aura pas  
lieu dans le cadre d’une installation particulière. Si ce matériel cause un brouillage nuisible de  
la réception radio ou de la télévision, ce qui peut être déterminé en mettant l’appareil hors et en  
marche, vous êtes encouragé à remédier à la situation en prenant les mesures suivantes :  
• Réorienter ou déplacer l’antenne réceptrice.  
• Augmenter la distance entre l’appareil et le récepteur.  
• Brancher l’appareil dans une prise d’un circuit différent de celui auquel est branché le récepteur.  
• Consulter un revendeur ou un technicien radio/télévision chevronné pour obtenir de l’aide.  
Mise en garde de la FCC : Pour assurer la conformité de cet appareil, suivre les directives  
d’installation fournies. Tout changement ou toute modication non expressément autorisée par le site  
responsable de la conformité risque d’annuler la permission qu’a l’utilisateur de faire fonctionner le  
présent appareil.  
Avis d’Industrie Canada  
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.  
10  
 
Panasonic Corporation  
Panasonic Canada Inc.  
© Panasonic Corporation 2014  
Printed in China  
F569672  
Imprimé en Chine For inquiries (U.S.A.), please call 1-800-851-1235 (Pour les É.-U.)  
SS0114-0  
 

Miele Dishwasher G 645 User Manual
Mountfield Lawn Mower EL 410 User Manual
Mountfield Lawn Mower SP536 User Manual
Mustek Printer PP3000 User Manual
Nvidia Computer Hardware NVIDIA Quadro User Manual
Onkyo Home Theater System SKB 540 User Manual
Onkyo Stereo Amplifier A 9070 User Manual
Panasonic CRT Television CT 27SF34 User Manual
Panasonic DVD Recorder DMR BS750 User Manual
Panasonic Network Card 2SD1149 User Manual