SmartNode™ 4660 & 4670 Series
Multiport BRI/FXS/FXO VoIP
Gateway Router, IAD
Quick Start Guide
This is a Class B device and is intended for use in a light industrial (commercial) or residential environment.
It is not intended for use in a heavy industrial environment.
REGULATORY MODEL NUMBER: 13243D4-001
Part Number: 07MSN4660-QS, Rev. A
Revised: June 5, 2012
Sales Office: +1 (301) 975-1000
Technical Support: +1 (301) 975-1007
E-mail: [email protected]
This device contains no user serviceable parts. This device can only be
repaired by qualified service personnel.
Cet appareil contient des pièces n'est réparable par l'utilisateur. Ce dis-
positif ne peut être réparé par du personnel qualifié.
WARNING
In accordance with the requirements of council directive 2002/96/EC on Waste of
Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you separate
this product from other waste and scrap and deliver to the WEEE collection system in
your country for recycling.
Electrostatic Discharge (ESD) can damage equipment and impair electrical
circuitry. It occurs when electronic printed circuit cards are improperly
handled and can result in complete or intermittent failures. Do the follow-
ing to prevent ESD:
CAUTION
• Always follow ESD prevention procedures when removing and replac-
ing cards.
• Wear an ESD-preventive wrist strap, ensuring that it makes good
skin contact. Connect the clip to an unpainted surface of the chassis
frame to safely channel unwanted ESD voltages to ground.
• To properly guard against ESD damage and shocks, the wrist strap
and cord must operate effectively. If no wrist strap is available,
ground yourself by touching the metal part of the chassis.
1.0 Power up the SmartNode
1. Connect the SmartNode to a power source using the included power supply and cable.
2. When the Power LED stops blinking and remains lit, the SmartNode is ready to configure.
2.0 Configuring your SmartNode
SN4660-SN4670.pdf for detailed information about:
•
Installing, configuring, operating, and troubleshooting the SmartNode
•
Warranty, trademark & compliance
SmartNode 4660 & 4670 Quick Start Guide
3
A.0 Customer and Technical Support
Online support: www.patton.com
Telephone support:
•
Standard: +1 (301) 975-1007 (USA), Monday–Friday: 8:00 am to 5:00 pm EST (1300 to
2200 UTC/GMT)
•
Alternate: +41 (0)31 985 25 55 (Switzerland), Monday–Friday: 9:00 am to 5:30 pm CET (08:00 to 16:30
UTC/GMT)
Fax: +1 (253) 663-5693 (USA) or +41 (0)31 985 25 26 (Switzerland)
4
SmartNode 4660 & 4670 Quick Start Guide
B.0 Appendix—Factory default settings
B.1 SmartNode 4660
Username:
administrator
Password:
(blank)
IP Address (Eth 0/0):
Network Mask (Eth 0/0):
IP Address (Eth 0/1-0/3):
DHCP
n/a
192.168.1.1 (DHCP Server)
Network Mask (Eth 0/1-0/3): 255.255.255.0
B.2 SmartNode 4670
Username:
administrator
Password:
(blank)
IP Address (Eth 0/0-0/3):
192.168.1.1 (DHCP Server)
Network Mask (Eth 0/0-0/3): 255.255.255.0
C.0 Compliance Information
C.1 Compliance
EMC Compliance:
•
•
•
FCC Part 15, Class B
EN55022, Class B
EN55024
Low-Voltage Directive (Safety) Compliance:
•
•
•
UL60950-1/CSA C22.2 No. 60950-1
IEC/EN 60950-1, 2nd edition
AS/NZS 60950-1
PSTN Compliance:
•
•
•
ACMA AS/ACIF S043.2:2008
ACMA AS/ACIF S003:2008
TBR3
SmartNode 4660 & 4670 Quick Start Guide
5
C.2 Radio and TV interference
The SmartNode router generates and uses radio frequency energy, and if not installed and used properly—that
is, in strict accordance with the manufacturer’s instructions—may cause interference to radio and television
reception. The SmartNode router have been tested and found to comply with the limits for a Class B computing
device in accordance with specifications in Subpart B of Part 15 of FCC rules, which are designed to provide rea-
sonable protection from such interference in a commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If the SmartNode router does cause interference to radio or
television reception, which can be determined by disconnecting the unit, the user is encouraged to try to correct
the interference by one or more of the following measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a different AC outlet
(such that the computing equipment and receiver are on different branches).
C.3 CE Declaration of Conformity
Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other rele-
vant provisions of Directive 1999/5/EC. The Declaration of Conformity may be obtained from Patton Electron-
The safety advice in the documentation accompanying this device shall be obeyed. The conformity to the above
directive is indicated by CE mark on the device.
C.4 Authorized European Representative
D R M Green
European Compliance Services Limited.
Oakdene House, Oak Road ,
Watchfield, Swindon, Wilts SN6 8TD, UK
6
SmartNode 4660 & 4670 Quick Start Guide
Copyright statement
Copyright © 2012, Patton Electronics Company. All rights reserved.
The information in this document is subject to change without notice. Patton Electronics assumes no
liability for errors that may appear in this document.
Trademarks statement
The term SmartNode is a trademark of Patton Electronics Company. All other trademarks presented in this docu-
ment are the property of their respective owners.
Warranty
For warranty information, refer to the SmartNode 4660 & 4670 Series User Manual available online
SmartNode 4660 & 4670 Quick Start Guide
7
NOTES
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
8
SmartNode 4660 & 4670 Quick Start Guide
|