■ Use this shaver only for its intended use as
described in this manual. Do not use attach-
ments not recommended by Remington.
■ Keep the cord away from heated surfaces.
■ Never operate this shaver if it has a damaged
cord or if it is not working properly, if it has
been dropped or damaged, or dropped into
water. Return the shaver to a service center
for examination and repair.
IMPORTANT SAFETY
INSTRUCTIONS
®
How to get a great shave
from your Remington®
MicroScreen® 2 Shaver
When using an electrical shaver, basic precautions
should always be observed, including the following.
Read all instructions before using this shaver.
Thank you for buying this premium
shaver from Remington®.
■ Never drop or insert any object into any open-
DANGER
ing.
Inside you'll find tips on using and
caring for your shaver to get the
best shave possible.
To reduce the risk of electric shock:
■ Do not use outdoors or operate where aerosol
(spray) products are being used or where oxy-
gen is being administered.
■ Do not use this shaver with a damaged or
broken cutter or head, as facial injury may
occur.
■ Always attach plug to shaver, then to outlet.
To disconnect, turn all controls to “Off,” then
remove plug from outlet, then detach power
cord from the shaver for storage.
■ Always store your shaver and cord in a mois-
ture-free area. Make sure your cord is discon-
nected from the shaver.
■ Do not reach for a shaver that has fallen into
water. Unplug immediately.
■ Do not use while bathing or in a shower.
■ Do not place or store shaver where it can fall
or be pulled into a tub or sink. Do not place
in or drop into water or other liquid.
■ Except when charging, always unplug this
shaver from the electrical outlet immediately
after using.
■ Unplug this shaver before cleaning.
WARNING
■ To prevent possible damage to the cord, do
To reduce the risk of burns, fire, electric shock,
or injury to persons:
not wrap cord around the shaver.
■ Never put the shaver in direct sunlight or store
in pouch at a temperature above 140° F.
■ “Household Use Only”.
Model DA-757
(LCD Display)
Model Only
■ A shaver should never be left unattended when
plugged in, except when charging your
rechargeable shaver.
Model DA-57
(no LED)
Model DA-107
(no LED)
Model DA-307
Model DA-325
■ Close supervision is necessary when this
shaver is used by, on, or near children or
invalids.
SAVE THESE
INSTRUCTIONS
Model DA-407
Model DA-307 and DA-325 With the shaver unplugged,press in on the
Switch Lock and slide the ON/OFF button upward to turn ON.Note that this
shaver is designed only to operate from its batteries; it must be charged
before using.
Model DA-407,and DA-757 These shavers can be powered from either
the cord or the battery. To shave using the battery, make sure that the
shaver has been charged. To shave using the cord,connect cord to shaver
and then to electric outlet.Press in on the Switch Lock and slide the ON/OFF
button upward to turn ON.
■ Every six months, lubricate the trimmer
teeth by applying a drop of light machine
oil one-third and two-thirds of the way along
the blade. Using your finger tip, spread the
oil along the teeth, and run the trimmer for a
few seconds.
Removing the Headguard
Before operating your
MicroScreen® 2 Shaver, remove
the Headguard, which protects
the Foils and Cutter Assembly.
It is important to remove the
Headguard correctly to avoid
Replacing Foils and Cutters
damaging the clips that hold
Because they are subject to daily use, the cutters and foils of your
Remington® MicroScreen® 2 Shaver will wear and eventually require
replacement to maintain a close, comfortable shave. Depending on your
shaving technique and habits, the foils will usually last six months; the
cutters, one year. Model DA-757 has a foil replacement indicator.
The foil icon on the LCD display will flash when the foil is due for
replacement. Some signs that your foils and cutters need replacing are:
it firmly to the shaver.
Trouble Shooting
■ Press lightly on the top of the Headguard.
■ If your DA-407, 757 shaver battery is completely discharged or the shaver has
not been used for an extended period of time, the shaver may not start when oper-
ated using the cord. If this condition occurs, charge the shaver for approximately
five minutes before shaving.
■ Lift the lower rear edge.
■ Pull the Headguard away from the shaver.
Operation
Use of a shaver at voltages other than the ones
specified below will damage it and void the warranty.
Model DA-57, DA-107 - Corded Shavers 120 Volts A.C.
Model DA-307, DA-325 - Rechargeable Shaver
World-wide A.C.voltage:105-130 Volts A.C.
■
Your DA-407, 757 cord/cordless shaver should not be used strictly as a cord-
operated shaver, as continued cord only use will result in reduction of battery life.
In order to preserve the life of the batteries,they should be fully discharged every
six months and then fully charged for 24 hours.
■ Irritation. As foils get worn, you may notice your skin feeling
sensitive after a shave, particularly when you apply aftershave.
■ Pulling. As cutters wear, your shave may not feel as close, and you
may feel your shaver is pulling at your whiskers.
■ Wear-through. You may notice that the cutters have worn through
the foil.
■
at 60 Hz,and 105-240 Volts,A.C. at 50 Hz.
Model DA-407 - Cord/Cordless Shaver World-wide A.C.
voltage:100-240 Volts A.C.,50-60 Hz.
Model DA-757 - Cord/Cordless Shaver With LCD Display
World-wide A.C.voltage:100-240 Volts A.C.,50-60 Hz.
Battery Removal
(Cord/Cordless and Cordless
Rechargeable Models Only)
To order replacement foils and cutters, call 1-800-736-4648.
When your rechargeable shaver
reaches the end of its useful life, the
batteries must be removed from the shaver and be recycled
or disposed of properly in accordance with your local and state
requirements.
The following procedure should be followed
for battery removal:
• To avoid a possible electrical shock hazard,unplug cord
from electrical outlet and shaver.
• Remove the head assembly by pushing in on the
head assembly release buttons.
• Remove the two screws on the upper back side of the
shaver.
• Pull or pry the shaver halves apart.
• Pull out the motor and frame assembl y.
• Pull or pry the batteries outward from the shaver’s
circuit board.
• Pull and twist the batteries to break the wire connections.
• CAUTION:Do not put in fire or mutilate your batteries when
disposing as they may burst or release toxic materials.Do
not short circuit as it may cause burns.Dispose of properly
in accordance with your local and state requirements.
To prevent inadvertent damage to the Foils and Cutter Assembly,
do not attempt to remove them unless you are replacing them. To
remove the old foil and cutters follow the instructions that come with the
foil and cutter replacement package. It's always a good idea to replace
the foils when you replace the Cutter Assembly.
Charging
Charge your shaver 24 hours before initial use.
Make sure the ON/OFF button is set to OFF (with
“O” visible). Connect the cord to the shaver and then
to the electric outlet.
Model DA-307, DA-325,and DA-407 The Green indicator
light will glow indicating that the shaver is charging.
The shaver will be completely recharged in 14-16 hours.
The red indicator light in the DA-325 model will glow
when the shaver needs to be recharged.
Model DA-757 This shaver has an LCD display. The bars
on the display give the % of battery power left in your
shaver. The plug icon will flash when your shaver needs
to be recharged. There is also a foil replacement indica-
tor. The foil icon on the display will flash when the foil is
due for replacement. The one hour quick charge fea-
ture in this model gives up to 60 minutes of cordless
shaving time. A 5 minute quick charge gives enough
shaving time for one shave
To Replace a Cutter Assembly That is Removed
Unintentionally:
■ Hold the assembly in the middle of the "T."
■ Gently place the forked legs into the open-
ing at the top of the oscillator tips.
■ Do not push downward on the ends of the
cutters, as you may bend the cutter, reducing
its ability to operate smoothly.
■ Do not remove cutters from the plastic
pieces to which they are attached, as you may
damage the assembly.
CAUTION: THESE NICKEL-CADMIUM BATTERIES MUST BE RECYCLED OR DISPOSED IN
ACCORDANCE WITH STATE AND LOCAL REGULATIONS. Do not burn or mutilate, as they
may burst or release toxic materials. Do not short-circuit, as it may cause burns.
To Shave
Model DA-57,and DA-107 Connect cord to shaver and then
to electric outlet.Slide the ON/OFF button upward to turn ON
.
®
Headguard
Warranty service must be performed by a Remington Company-
owned Service Center or Authorized Service Dealer and damage or
loss of any kind resulting from servicing by any other person is not
covered under warranty. Enclosed is a listing of Company-owned
Service Centers. Authorized Service Center Dealers may be found
in the yellow pages of your directory. If you wish, you may mail
the product, postpaid,to Remington Products Company, 60 Main
Street,Bridgeport, CT 06604 Attention:Service Department.
Remington Money-Back Offer
You have just bought one of the finest
shavers available today. If for any reason
within 30 days from when you purchased
®
®
your Remington MicroScreen 2 Shaver,
you are not satisfied and would like a
refund, just return your shaver, together
with the sales receipt, to the retailer from
whom you purchased it. Remington will
reimburse all retailers who accept shavers
within 30 days of purchase. If you have
any questions regarding this money-back
guarantee, please call 1-800-736-4648.
Dual Flexible
MicroScreen® Foil
Head
Assembly
U.S. Warranty Service
ON/OFF Switch Lock
(DA-307, DA-325,
DA-407)
In the United States, service is provided
by our Company-owned Service Centers
and over 300 Authorized Service Dealers.
The addresses of our Company-owned
Service Centers are enclosed. For the
address of your nearest Authorized Service
Dealer, please consult the Yellow Pages
under “Shaver - Electric - Repair.” If you
wish, you may mail the product, postpaid,
to Remington Products Company, 60 Main
Street, Bridgeport, CT 06604, Attention:
Service Department.
ON/OFF Switch
Head
Easy-View Trimmer
Rear of Shaver
Assembly
Release
Button
(Both sides)
Full One-Year Warranty
Remington warrants that your product, except as noted below, is,
on date of purchase, free from defect in material and workmanship.
Remington will correct any such defect without charge if you return
the complete product either in person or by mail, postage paid, to a
Remington Company-owned Service Center or Authorized Service
Dealer within one year after date of purchase.
Charging
Indicator
Light
(DA-307,
DA-325,
DA-407)
Do not return the product to the retailer from whom the product
was purchased.
International Warranty Service
Foil
Gauge
DA-757
Service under the Remington warranty can
be obtained outside the United States by
Remington-Authorized Distributors and
Service Dealers. Please consult your local
telephone directory for the nearest location.
Low Battery
Indicator Light
(not shown)(DA-325)
This warranty does not cover damage by accident, misuse,abuse or
by affixing an unauthorized accessory or alteration to the product, or
by connection of the product to any but the specific current and volt-
age indicated in an accompanying instruction booklet, or by any
other conditions beyond our control. REMINGTON SHALL NOT BE
RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL
DAMAGES.
Cord Inlet
Remington MicroScreen® 2 Models
Which model is yours?
For questions or comments, please write:
Remington Products Company, L.L.C.
P.O. Box 1536,
IN ADDITION,THIS WARRANTY DOES NOT COVER THE FLEXIBLE
SCREEN ASSEMBLY ON OUR FOIL TYPE SHAVERS.
DA-57,
DA-107
Corded Shavers,
120 Volts A.C.
Horsham,PA 19044-6536
Attention:Consumer Affairs
ALL IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO IMPLIED
WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN
DURATION TO ONE YEAR FROM DATE OF ORIGINAL PURCHASE.
DA-307,
DA-325
Rechargeable Shaver - World-wide A.C.
105-130 Volts A.C. at 60 Hz ,and 105-240 Volts,
A.C. at 50 Hz.
Questions or Comments: Please call 1-800-736-4648.
ట
This warranty gives you specific legal rights, and you may also have
other rights that vary from state to state. Some states do not allow
the exclusion limitation of incidental or consequential damages or
limitations on how long an implied warranty lasts, so that the above
limitations and exclusions may not apply to you.
DA-407
DA-757
Cord/Cordless Shaver - World-wide A.C.
voltage:100-240 Volts A.C.,50-60 Hz
Remington,MicroScreen and
ShaverSaver are trademarks of
Remington Corporation,L.L.C.
Cord/Cordless Shaver with LCD Display
World-wide A.C.voltage:100-240 Volts A.C.,
50-60 Hz
P R O D U C T S C O M PA N Y, L . L . C .
No responsibility, obligation,or liability is assumed for the installation
or maintenance of this product.
© 1999 RPC, L.L.C.Rev. 3/99
Part No. 12554
60 Main Street Bridgeport, CT 06604
U.S. Patent Design #362, 739
Canadian Design Patent 77, 681
|