R0E5212L4CFG00
Converter Board for 32-pin 0.8mm pitch LQFP
User’s Manual
If the requirements shown in the "CAUTION" sentences are ignored, the
equipment may cause personal injury or damage to the products.
CAUTION
Rev. 1.00
Oct. 02, 2007
(1/4)
REJ10J1685-0100
5. Connection Procedure (See Figure 3)
The procedure for connecting the R0E5212L4CFG00 is shown
below.
R0E521000EPB00
or
R0E 521000CPE00
R0E5212L4CFG00
(1) Mount the NQPACK032SA on the user system.
(2) Attach the YQPACK032SA on the NQPACK032SA.
(3) Secure the four corners of the YQPACK032SA with the
YQ-GUIDE's.
(4)
(5)
Be sure to use a
flathead screwdriver.
YQ- GUIDE (x4)
● Do not use the screws included with the
YQPACK032SA for fixing the YQPACK032SA.
● The screwdriver included with the NQPACK032SA is
used for fixing the HQPACK032SA. Do not use it for
fixing the YQ-GUIDE’s.
(3)
YQPACK032SA
(2)
(1)
NQPACK032SA
(4) Attach the R0E521000EPB00 or R0E521000CPE00 to the
R0E5212L4CFG00.
32-pin 0.8mm pitch
(PLQP0032GB-A) foot pattern
(5) Attach the R0E5212L4CFG00 to the YQPACK032SA.
Figure 3 Connection procedure of the R0E5212L4CFG00
6. External Dimensions and a Sample Foot Pattern (See Figure 4)
31.0
0.5
R0E5212L4CFG00 REV.A
MADE IN JAPAN
0.8
6.8
10.0
Unit: mm
Figure 4 External dimensions and a sample foot pattern of the R0E5212L4CFG00
(3/4)
7. Precautions
CAUTION
Cautions to Be Taken for This Product:
z Do not pull or excessively flex the cable. The cable may cause a break.
z When connecting the YQPACK032SA, be sure to use the included YQ-GUIDE's.
z Do not use the screws included with the YQPACK032SA to fix it.
IMPORTANT
Notes on This Product:
z We cannot accept any request for repair.
z For purchasing the NQPACK032SA, YQPACK032SA and HQPACK032SA, contact the following:
z For inquiries about the product or the contents of this manual, contact your local distributor.
8. Adding an MCU file
If you cannot select the MCU file for the R8C/2K and /2L Groups when the emulator debugger is launched, follow as below to add
the MCU file.
(1) Download the MCU file installer for the emulator to be used from the following download site.
- When using with the compact emulator R0E521000CPE00
MCU file installer name: MCU_Files_install_cpe_R8C_2K-2L.exe
- When using with the emulation probe R0E521000EPB00
MCU file installer name: MCU_Files_install_epb_R8C_2K-2L.exe
(2) Start the downloaded installer to add the MCU file.
(4/4)
|