INTERNAL
SECURITY
TOUCHKEY IMMOBILIZER
SLI® 762FP-ISS
OWNERS MANUAL
LED INDICATOR
INTRODUCTION
The LED indicates the following:
Congratulations! Your vehicle is now protected by the SLI 762FP-ISS.
This Touchkey Immobilizer is designed to be used with almost any
vehicle.
1. Armed – While unit is armed, the LED flashes.
2. Arming – While unit is arming, the LED flashes rapidly.
3. Disarmed – While the unit is disarmed, the LED is OFF.
4. Triggered – If you try to start the engine without the Touchkey, the
LED will show steady ON.
The Touchkey Immobilizer combines high security with the
convenience of completely automatic arming.
5. Code learning – The LED will show steady ON to indicate a new
Touchkey has been successfully learned.
To disarm and operate the vehicle, insert the Touchkey, remove it, and
start the engine. No other buttons to push, no codes to remember.
When the destination is reached, turn the engine OFF. 30 seconds
later, the engine is automatically and completely disabled.
6. Valid code entered – If a valid PIN number or programming code is
entered, the LED will flash rapidly for three seconds.
7. Valet/override – When the Immobilizer is in the valet/override
mode, the LED will flash 11 times, then flash slowly when the
ignition is turned OFF. The LED will turn OFF when the ignition is
turned ON.
When the Touchkey is inserted into the receptacle, the Immobilizer
reads the key’s code. If the Touchkey was properly coded to the
system, the Immobilizer disarms, allowing the engine to start as
normal.
1. Normal disarm – Insert the Touchkey into the receptacle and
remove it. Start the engine within 30 seconds. If the engine is not
started within 30 seconds, the Immobilizer will automatically rearm.
2. Emergency disarm – If the Touchkeys are lost, use the secret PIN
to put the unit into valet/override mode (see page 2).
However, the engine won’t start if someone tries to start it without the
Touchkey. Only Touchkeys properly learned by the system can start
your engine!
PERSONAL ID NUMBER (PIN)
Included with the SLI 762FP-ISS is a small card with a secret PIN.
This 3-digit number is required to enter the valet mode, do emergency
disarm, or add new Touchkeys.
ARMING THE IMMOBILIZER
1. Arming procedure:
a. Turn the ignition switch OFF.
DO NOT LOSE THE CARD. KEEP IT IN A SAFE PLACE.
For information on valet, emergency disarm, or code learning new
Touchkeys, see page 2.
b. 30 seconds later (unless you turn the switch ON again), the
unit arms, and the LED flashes slowly.
2. Re-starting the engine:
a. Within 30 seconds of turning the ignition OFF – Start the
car normally.
b. 30 seconds or more after turning the ignition OFF – Go
through the disarming procedure again (see above).
®
SECO-LARM
|