Verizon Wireless Network Extender
Quick Start Guide
EP68-00361A
SCS-26UC4
Power
LED
Wireless
Antenna
GPS
Antenna
System
LED
Heat
Vents
DC12V
Power
Port
GPS
LED
WAN
Port
WAN
LED
CONNECTING YOUR NETWORK EXTENDER
1. The Network Extender needs to be located:
•
Near a window (if this is not possible, see
“External GPS Antenna”in the User Manual)
1HWZRUNꢀ([WHQGHU
ꢃ
•
At least two feet away from your router if it
supports Wi-Fi
For best results, place the Network Extender
in an elevated location, such as the top of a
bookshelf or tall cabinet.
3RZHUꢀ6XSSO\
3RZHUꢀ&RUG
ꢂ
2. Connect one end of the included Ethernet
cable to an open port on the router (1) and
connect the other end to the WAN port lo-
cated at the rear of the base station (2).
(WKHUQHWꢀ&DEOH
5RXWHU
3. Plug the power supply connector into the DC
12V power port located at the rear of the base
station (3).
4. Insert one end of the power cord into the
power supply and then plug the other end
into an available outlet (4).
5. Allow 3 - 5 minutes for the base station
to complete the startup sequence and
detect both its connections and available
communications. The first time the base
station is used, it may take as long as one
hour for the initial GPS acquisition.
CONFIRMING NETWORK EXTENDER
OPERATION
LED
Function
Description
PWR
Power
Solid blue: normal
No light: abnormal
Your Network Extender is ready for use when all
four LEDs are solid blue.
SYS
System
Solid blue: normal
Blinking red: establishing
an initial network
connection
connected
Note: The optional GPS antenna cable is required
only when the external GPS antenna installation
is necessary.
Solid red: abnormal
GPS
GPS Signal
Solid blue: normal (GPS
signal is received)
Blinking blue or red:
while searching for GPS
signal
Solid red: abnormal
(GPS signal cannot be
received, the external
GPS antenna is required)*
WAN
WAN (Ethernet Solid blue: normal
connection)
Blinking blue: data
communication
No light: abnormal
* See “External GPS Antenna”in the User Guide.
FOR MORE INFORMATION
TROUBLESHOOTING
•
Refer to the Network Extender User Guide
that came with your device.
What if my GPS LED is still red after one hour?
If the GPS LED is still red after one hour, you need
to relocate the GPS antenna to receive a stronger
signal. See “External GPS Antenna”in the User
Guide.
•
•
Visit verizonwireless.com/support
Call Customer Service toll free at 800-922-
0204 or *611 from your Verizon Wireless
mobile phone.
How do I know my phone is connecting
through the Network Extender?
#
When dialing 48 on your wireless phone, an an-
nouncement will tell you if you are within range
of the Network Extender. In addition, you will
hear a short double tone on your wireless phone
whenever making or receiving a call. The tone is
played at the beginning of the call.
© 2009 Verizon Wireless. All rights reserved. Verizon Wireless is a
trademark of Verizon Trademark Services LLC.
|