SUBMITTAL SHEET
SYSTEM
INDOOR/OUTDOOR
AIRCONDITIONING PRODUCTS
SS24THS32-1
24THS32
THS2432/CH2432
CEILING SUSPENDED HEAT PUMP
GENERAL DATA
(AT 230V)
PERFORMANCE DATA @ ARI STANDARD CONDITIONS (230/208V)
COOLING
POWER V/PH/HZ
Circuit Ampacity, Min. (A)
230/208/1/60
30
30
Total Capacity
(BTU/H)
22,400/21,600
13,640/12,970
8,760/8,630
10.0/10.0
Fuse size, Max
(A)
Sensible Capacity (BTU/H)
Latent Capacity (BTU/H)
SEER
COMPRESSOR
No. used
R.L. Amps - L.R. Amps (A)
Crankcase Heater
Rotary-Hermetic
1
9.4 - 66.0
30W
Dehumidification (Pints/H)
Amps (A)
6.3/6.2
10.7/11.3
Power Inputs (W)
2,290/2,250
OUTDOOR FAN - TYPE
Dia. (in.) - No. used
Type Drive - No. speeds
No. Poles - RPM (High)
No. Motors ñ HP
Propeller
18-3/32- 1
Direct ñ 2 (AUTO)
6 - 879
1 - 1/7
1,840
HEATING
Total Capacity
HSPF
Amps (A)
Power Inputs (W)
(BTU/H)
25,400/25,000
7.0/7.0
11.7/12.9
2,350/2,280
1.80/1.47
7.6
CFM (High)
F.L. Amps. (A)
Back-up Strip Heater (KW)
Outdoor Sound Rating(bels)
0.9
OUTDOOR COIL ñ TYPE
Fin Type - Pipe Type
Rows - F.P.I.
Face Area (sq.ft.)
Tube Size (in.)
Aluminum Fin & Copper Pipe
Slit Plate - Inner Riffled
2- 14.1
6.78
3/8
FEATURE
Controls
Microprocessor
LCD Wireless type
IC Thermostat
ON/OFF, 24 hours
Built-In
Remote Controller
Temperature Control
Timer
INDOOR FAN ñ TYPE
Centrifugal
Night Setback
Dia. & Length (in.) - No. used 5-1/8 & 4
Air Louver (Horizontal)
(Vertical)
Power Failure Automatic Restart
Self Diagnosis
Manual
Automatic
Built-In
N/A
No. speeds
3 & Auto
4-1,187
1 - 1/24
540/490/425
0.4
No. Poles -RPM (High)
No. Motors - HP
CFM (HI/MED/LOW)
F.L. Amps (A)
OPTION
INDOOR COIL - TYPE
Fin Type - Pipe type
Rows - F.P.I.
Face Area (sq. ft.)
Tube Size (in.)
Aluminum Fin & Copper Pipe
Slit Plate - Inner Riffled
3 - 14.9
1.81
3/8
Refrigerant Line Set
AP2710BH (30 ft)
AP2715BH (50 ft)
Low Ambient Control
Fresh Air Intake
Central Remote ON-OFF Control
Airduct Extension
Built-In
N/A
Available
N/A
Drain Connection Size (in.)
1-1/4
REFRIGERANT
Lbs. - R22 (O.D. Unit)
Control
R22
6.17
Capillary Tube
Indoor Frame Extension
Condensate Drain Pump
Non-Removable Remo-con Bracket
N/A
Available
RCS5PS4B
Connection
Electronic Refrigerant Control Valve
Line Length, Max (ft.)
Lift difference, Max (ft.)
165
100
OPERATING RANGE
Line Size - in. O.D. Discharge 1/4
Line Size - in. O.D. Suction 3/4
Cooling
Indoor Air
Outdoor Air
Intake Temp.
115F DB
23F DB
75F DB/67F WB
17F DB/15F WB
Intake Temp.
95F DB/71F WB
67F DB/57F WB
Maximum
Minimum
DIMENSIONS (in.)
Indoor Unit -Uncrated 7- 15/32 x 51- 6/32 x 26-3/8
-Crated 9- 14/32 x 54- 19/32 x 29-31/32
Outdoor Unit-Uncrated 28-15/16 x 37
H
x
W
x
D
Heating Maximum 80F DB/67F WB
Minimum
-F DB/ - F WB
x 13-3/8
-Crated
32-17/32 x 40
x 16-12/32
CERTIFICATION
WEIGHT
Net
INDOOR
60.0
OUTDOOR
157.0
(lbs.)
Shipping(lbs.)
77.0
170.0
Shipping Volume (cu.ft.) 8.9
12.3
24THS32
Dimensional Data
Indoor Unit: THS2432
6-3/32
3-3/8
3-15/16
12-7/32
11-1/32
5-3/4
3-9/32
5-9/16
11-1/32
4-9/16
Dimension : inch
Holes in the rear side (View from front)
Hole for wall-through piping (View from front)
Drain connection
Drain connection for left side
Refrigerant liquid line (1/4") Flare connection
Refrigerant gas line (3/4") Flare connection
Hole for rear side refrigerant tubing
Hole for through-the-wall refrigerant tubing (ø3-15/16" hole)
Hole for fresh air intake (Knockout hole)
Hole for right side refrigerant tubing (Knockout hole)
Hole for left side drain connection (Knockout hole)
Hole for power supply (Conduit size 1/2")
Infrared rays receiver for wireless remote controller
Cutting position for fresh air intake
5-3/16
2-25/32
1-3/8
48-7/16 (Suspension bolt hole pitch)
1919_THS_I
50-13/32
26-3/8
10
10
Air outlet
9-7/8
or more
or more
51-3/16
Front
8-7/16
9-7/8
(Service space)
(Service space)
Air intake
3-1/2
4-1/16
5-25/32
7-7/32
Outdoor Unit: CH2432
6-11/16
26
4-21/64
1-31/32
1-31/32
37
Dimension : inch
Hole for anchor bolt (4-ø1/2)
Refrigerant tube joint (narrow tube)
Flare connection 1/4 in (6.35 mm)
Refrigerant tube joint (wide tube)
Flare connection 3/4 in (19.05 mm)
Refrigerant tubing inlet
Power supply inlet
1131_THS_I
WARRANTY
Full specific warranty rights, conditions, exclusions and obligations are specified in the
warranty packed with each products.
SANYO products are warranted against defects in materials and workmanship for the
period below;
LABOR
30 Days
N/A
PARTS
5 Years
1 Year
Compressor
Other Components
Because of a policy of continuous product improvements, SANYO reserves the right
to change specifications and design without notice.
SANYO FISHER COMPANY
A Division of SANYO North America Corporation
21605 Plummer St. Chatsworth, CA 91311
Phone : (818) 998- 7322
Fax
: (818) 701- 4160
|