TERK Technologies Automobile Accessories 143P005 User Manual

Mounting the Bracket::  
1
2
4
Select the top bar of either the driver’s side or  
passenger side mirror mount (Fig.1). Place the  
bracket on the front side of the bar (Fig.2).  
While holding the brackets together, install the lock  
washers and the wing nuts (Fig.3). Before completely  
tightening the wing nuts make sure that the ground  
plane of the bracket where the antenna will be located  
is parallel to the ground. Tighten both wing nuts so that  
the bracket is secure.  
Insert the two metal tabs of the small bracket  
into the two slits near the top of the L-bracket  
(Fig.2).  
C K A E T  
T R U C K M I R R O R M O U N T B R  
Fig.1  
Fig.2  
3
L-Bracket  
Lower the small bracket over the mirror bar until  
o r W k s w i t h M a g n e t e i c t M R o u a n e t d S t l a i l o i S a  
e t n n a s  
e t R a e d t l i l o i A n  
the bolts in the L-bracket come through the  
slots of the small bracket (Fig.2).  
Small Bracket  
S R B - M M  
Fig.3  
Fig.4  
Installing the Antenna::  
Works with Magnetic Mount Satellite Radio Antennas  
Shown below with the TERK XMicro & SIR-Mini  
Cable Protector  
For technical support, call 1.800.942.TERK (8375)  
1
2
Take your SIR-Mini (for SIRIUS Satellite Radio)  
or XMicro (for XM Satellite Radio) and place the  
antenna on the top of the bracket between the metal  
tab and the cable pass-through hole (Fig.5).  
Made in China  
One year limited warranty  
XMicro  
SIR-Mini  
The SIRIUS name is a trademark of  
SIRIUS Satellite Radio  
The XM name is a trademark of  
XM Satellite Radio  
Route the cable from the antenna through the top  
of the bracket using the cable pass-through hole.  
Determine the best route for the cable to reach the  
satellite radio receiver.  
TERK and TERK Technologies are trademarks of  
TERK Technologies Corp. Commack, NY  
Fig.5  
©2004 TERK Technologies Corp.  
143P005  
XMicro  
SIR-Mini  
Note: The cable has a very small diameter and should  
be routed with care. Three feet of cable protector has  
been included. Please install the cable protector around  
the cable when going through areas that may cause  
damage to the cable such as a door jamb or window. (Fig.4)  
Installation instructions printed on the inside of this card::  
3
Once the cable has been routed to the satellite radio  
receiver, plug the antenna connector into it.  
Please refer to your satellite radio receiver owner’s  
manual to activate your satellite radio service and  
complete your receiver installation.  
Limited Warranty  
TERK Technologies Corp. (TERK) warrants this product against defects in  
materials or workmanship for one (1) year from the date of purchase.  
During this warranty period, this product will be replaced without charge.  
This warranty does not cover any damage due to acts of nature, commercial  
use, accident, misuse, abuse or negligence. This warranty is only valid in  
the USA. Replacement as provided under this warranty is the exclusive remedy  
of the consumer. TERK shall not be liable for any incidental or consequential  
damages for breach of any express or implied warranty on this product,  
except to the extent that limitations of this sort are prohibited by applicable law.  
THERE ARE NO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS  
FOR A PARTICULAR PURCHASE EXCEPT TO THE EXTENT THAT IMPLIED  
WARRANTIES OF EITHER SORT ARE REQUIRED BY APPLICABLE LAW, AND  
IN SUCH CASE, EACH WARRANTY IS LIMITED IN DURATION TO ONE YEAR.  
 

Texas Instruments Power Supply TPS40003 User Manual
Thermos Gas Grill 461644604 User Manual
Toshiba All in One Printer 165 205 User Manual
Toshiba Answering Machine SM QRC VB User Manual
Troy Bilt Portable Generator 01919 1 User Manual
Uniden Cordless Telephone DSS 8955 + 3WP User Manual
Uniden Cordless Telephone EXT 1480 User Manual
Uniden Scanner BCT8 User Manual
UTStarcom Headphones PN 820 User Manual
Valcom Speaker V1001 User Manual