Quick Installation Guide
TEW-AO12O
1. Before You Start
Package Contents
?TEW-AO12O
?User’s Guide
?Antenna Mounting Base
?Mounting Kit
System Requirements
?Wireless Router, Access Point or Wireless Adapter with detachable
antenna and reverse SMA male connector
?TEW-ASAK or TEW-ASAL1 (with TEW-455APBO)
?TEW-L406 or TEW-L412
Application
Workstation with
Wireless PCI Adapter
(TEW-443PI)
12dBi Outdoor Omni
Notebooks with
Wireless PC Card
Direction
(TEW-441PC)
(TEW-
Workstation with
Wireless PCI Adapter
(TEW-443PI)
Workstation with
Wireless PCI Adapter
(TEW-443PI)
Notebook with
Wireless PC Card
(TEW-441PC)
Notebooks with
Wireless PC Card
(TEW-441PC)
Outdoor Arrestor Kit
(TEW-ASAK)
Cable/DSL
Modem
Internet
LMR400 Cable
(TEW-L406 / TEW-L412)
108Mbps
Wireless Router
(TEW-452BRP)
1
English
2. Hardware Installation
1. Unscrew the antenna from your
wireless access point or wireless
router.
2. Attach the blue sleeve (Reverse
SMA) end of the jumper cable
(provided with the TEW-ASAK) to
your wireless access point or
router.
3. Connect the black sleeve (N-type)
end of the jumper cable to the
TEW-ASAK.
4. Connect the other end of the
TEW-ASAK to the blue sleeve of
the antenna cable (TEW-L406 or
TEW-L412).
2
English
5. Run the antenna cable through the
mounting base.
6. Connect the black sleeve (N-type)
end of the antenna cable to the
TEW-AO12O.
7. Connect the antenna to the
antenna base and tighten the
screws.
3
English
3. Mounting
Wall Mounting
1. Slide the mounting brackets
through the Antenna base and
tighten the screws.
2. Place the antenna base on the
desired spot on a wall. Use a pen
to mark the spots at each of the
four holes.
3. Drill holes for the fastener plugs at
the marked positions on the wall.
4. Insert fastener plugs into the drilled
holes.
5. Use the provided wood screws to
screw the antenna to the fastener
plugs to the wall.
4
English
Pole Mounting
1. Slide the mounting brackets
through the Antenna base and
tighten the screws.
2. Slide the two provided u-clamps
around the pole. Place the pole
mounting bracket at the desire
height and position
3. Secure the mounting bracket to the
pole mounting bracket using the
nuts and washers provided.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
Thank you for choosing TRENDnet
5
English
Troubleshooting
Q1: I am unable to connect my antenna to my wireless router or access point.
What should I do?
A1: The connector type on your wireless router or access point must be reverse
SMA male. Contact the manufacturer of your wireless router or access point
regarding the antenna connector type.
Q2: Why do some of my wireless PCs receive a strong wireless signals, while
other PCs receive a weaker signal?
A2: The TEW-AO12O is an Omni directional antenna and can only send and
receive signals from a specified radius. You can adjust the position of the wireless
router or access point, extend your TEW-AO12O to an optimal location or move
those wireless PCs closer to the wireless access point or router.
Q3: My Access Point indicates that it is receiving power, and my laptop is within
range of the TEW-AO12O. However, my laptop does not receive any signals from
my Access Point.
A3: Make sure that you properly connect the antenna to the Access Point. (See 2.
hardware Installation)
Q4: Does the TEW-AO12O work with my IEEE 802.11a wireless router, access
point or wireless adapter?
A4: No. The TEW-AO12O is only compatible with IEEE 802.11/b/g wireless
devices.
Q5: Is it necessary to use the mounting kit that comes with the TEW-AO12O?
A5: It is only necessary if you decide to mount the TEW-AO12O at a permanent
location. Use discretion when attaching the mounting brackets to the
TEW-AO12O.
If you have any questions regarding the TEW-AO12O, please contact TRENDnet
Technical Support Department.
6
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
TRENDnet Technical Support
.
US Canada
Toll Free Telephone: 1(866) 845-3673
24/7 Tech Support
.
.
.
.
.
Europe (Germany France Italy Spain Switzerland UK)
Toll Free Telephone: +00800 60 76 76 67
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone: +(31) (0) 20 504 05 35
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Product Warranty Registration
Please take a moment to register your product online.
20675 Manhattan Place
Torrance, CA 90501
USA
Copyright ©2007. All Rights Reserved. TRENDnet.
|