Owner’s Manual
HDTV Multimedia
Wall Plate
1111 W. 35th Street,
Chicago, IL 60609
Customer Support: (773) 869-1234
Model: A152-000-2
Your A152-000-2 HDTV Multimedia Wall Plate comes preloaded with the most common
couplers for multimedia in-wall cable installation. You can customize your wall plate by
switching any of the pre-installed keystone inserts with the alternate ones supplied in
the package.
Removing a Keystone Insert from the Wall Plate
You can remove any of the keystone inserts from the
wall plate by using a small, flathead screwdriver. With the
wall plate laying on a flat surface, insert the blade of the
screwdriver between the insert’s snap-in tab and the wall
plate (as shown) and press the tab down toward the insert
until the insert snaps out of the port.
Back of Faceplate
Removing a Coupler from a Keystone Insert
1) Using both hands, hold the keystone insert between both
of your thumbs and forefingers. Make sure the tabs that
hold the coupler in place are facing upward.
2) Use your forefingers to gently pull each tab away from
the coupler.
3) Using both thumbs, push the coupler upward until it can
be removed from the keystone insert.
Copyright © 2008 Tripp Lite. All rights reserved. All trademarks are the property of their respective owners.
Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.
93-2772 200801148
200801148--A152-000-2 HDTV wall plate kit OM 93-2772.indd
1
2/7/2008 9:53:59 AM
|