VT04
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions – before using this lamp.
2. Keep these instructions – for future reference.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this lamp in damp/humid or wet locations.
6. For indoor use only.
7. Clean only with dry cloth.
8. Do not block any ventilation openings.
9. Do not place near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
10. Do not defeat the safety purpose of the polarized plug. A polarized
plug has two blades with one wider than the other. The wider blade
is provided for your safety. If the provided plug does not fit in your
outlet, consult an electrician for replacement of the obsolete outlet.
11. Protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles, and the point where it exits from
the lamp.
12. Unplug this lamp during lightning storms or when unused for long
periods of time.
13. If the lamp has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have
fallen onto the lamp, the lamp has been exposed to rain or moisture,
does not operate normally, or has been dropped, it should not be
operated. There are no user serviceable parts within this lamp.
SAVE THESE INSTRUCTIONS
3
GENERAL PRECAUTIONS
• Do not use with power supply voltage other than 120V AC
• Avoid placing the lamp in areas that are dusty, humid/moist, lack
ventilation, or are subject to constant vibration.
• Not for use with light dimmers, timers, motion detectors, voltage
transformers, or extension cords.
• Do NOT use lubricating agent in bulb assembly.
• The light bulb may become loose during transit. To reinstall the light
bulb, see the bulb installation instructions on page 6.
• Close supervision is recommended when this lamp is used by or
near children, or others who may not understand the need for these
precautions. Do not leave the lamp unattended during use.
This lamp has been tested and found to comply with Part 18 of the
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This lamp
generates, uses, and can radiate radio frequency energy and, if not
used in accordance with the instructions, may cause interference
to radio communications. If interference occurs try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the lamp and receiver.
• Connect the lamp into an outlet on a circuit different from that to
which the receiver is connected.
• Move the lamp out of the line of sight of the remote control receiver.
• Consult the dealer or an experienced radio/TV technician for help.
4
SET-UP INSTRUCTIONS
Unpacking
Please remove all packaging material. Check the carton for the items
pictured below:
Lamp
Bulb
Diffuser
Selecting a location
• Place your Verilux® TwiLight™ Mini Ultra Blue Light Therapy Sleep
System on a table or other flat surface.
• If using around infants and young children avoid placing system
where bright light shines directly into developing eyes.
Note: Avoid placing this lamp in areas that are exposed to direct
sunlight or close to heat-radiating products, such as heaters. Do not
place the lamp on the top of appliances that radiate heat.
WARNING: DO NOT BLOCK VENTS
Vents are necessary for proper function of the electronic
ballast; blocking them may cause overheating of the
electronics and increase risk of fire.
5
SET-UP INSTRUCTIONS
Bulb & Diffuser installation
1. Insert bulb into lamp by firmly holding bulb base and pushing it into
the socket (See below). Bulb will not appear blue until it is illuminated.
Note: Make sure bulb is fully inserted into the socket. The bottom of
the bulb base should touch the plastic housing of the lamp.
2. Attach the plastic diffuser to the lamp body by first inserting the tab
located at the bottom of the diffuser (A) into the opening of the lamp
base (B).
3. Rotate the plastic diffuser and align the side snap tabs (C) into
position – press firmly to snap parts together.
C
A
B
4. Plug lamp into a standard 110-120V outlet, switch it on and begin
enjoying the benefits of Verilux® Blue Light therapy light!
Note: please allow a few minutes for the bulb to warm up to full
illumination.
Note: if bulb does not illuminate instantly, please refer to the
troubleshooting section of this manual.
6
SET-UP INSTRUCTIONS
Instructions for use
Blue light therapy consists of exposing your eyes to a sufficient quantity
of blue light in the 460 nm range for 30 – 60 minutes, 2–3 hours prior
to falling asleep or for the same duration in the morning. Blue Light has
been shown to act as a “switch” to help regulate both sleep and daytime
circadian rhythm. The Verilux® TwiLight™ Blue Light Therapy Sleep
System should be located between 1’ and 10’ away from you during the
exposure period.You do not need to look directly at the light to benefit
from its effects and some people may experience discomfort if they
stare directly at the light.
• Locate the system on a flat surface such as a dresser or nightstand.
• Turn the system on 5 minutes prior to your session in order for it to
develop maximum brightness.
• Continue with your normal evening activities, but allow the healthful
blue light to bathe you in its illumination. Other ambient light sources
should be reduced during exposure time.
• If a young child or infant is being treated with the TwiLight™ System,
exposure to the direct light must be avoided to guard against
potential damage to developing eyes.
• Optimum exposure time is different for each person; therefore, it is
important to test various brightness levels, times of day, exposure
times and distances from the light source to determine which
combination is most effective.
Note: Eye disease researchers have found limited
evidence that bright light and blue light therapy may cause
additional harm to people with pre-existing eye damage
(including glaucoma and macular degeneration), and
could increase the incidents of age related blindness.
Medical professionals recommend people with pre-existing
retinal conditions be tested prior to using any bright light or
blue light therapy system.
7
BULB REPLACEMENT
Bulb removal and replacement
1. Unplug lamp from power source.
2. To access the bulb, remove the plastic diffuser by depressing the
tabs (D) and lifting it out.
3. Firmly hold the bulb base (B) (Do not hold the glass portion of the
bulb) and pull bulb from the socket in an outward motion (rocking
slightly if needed).
4. To re-install bulb and plastic diffuser, see instructions on page 6.
B
D
8
TROUBLESHOOTING
Before requesting service on your Verilux® lamp please read the
following:
• Make sure all power connectors, cords, and plugs are inserted fully
and securely.
• Be sure the bulb is securely seated in the socket. (See page 6)
• Make sure there is power to the wall outlet or try another outlet – not
connected to a dimmer.
CARE & CLEANING
Your TwiLight™ Mini Ultra is made from high quality materials that will
last for many years with a minimum of care.
Clean only with a soft dry cloth – DO NOT USE SOLVENTS OR
CLEANERS CONTAINING ABRASIVES OR AMMONIA
WARNING: To prevent risk of shock or personal injury
when cleaning lamp, make sure you have turned off and
unplugged the lamp, and allow sufficient time for the bulb
to cool.
9
DISCLAIMER
Verilux® does not make any medical claims regarding the use of this product. Always
consult a qualified health care professional before using light therapy. It is advisable that
you contact a doctor if:
•
•
•
You are hypersensitive to light and/or experience eye discomfort.
You are currently taking any medication that might increase your sensitivity to light.
There is no improvement after using the product for thirty days, or if you feel
uncomfortable after using the product.
•
You have a history of eye disease including, but not limited to, cataracts or macular
degeneration.
Each individual’s sensitivity to light is different. Each person must use his/her own
judgment when determining the length of time spent exposed to the light. The use of
this product is the sole responsibility of the consumer.
Note: The light source used in this lamp does not emit any discernable levels of UV.
10
|