K-1900-5
Hot-Line Touch
Tone Dialer
February 8, 2005
TECHNICAL
Practice
TELECOM SOLUTIONS FOR THE 21ST CENTURY
Replace Dedicated Phone Lines with a
Touch Tone Hot-Line Dialer
Why pay the premium of leased or dedicated phone lines?
The K-1900-5 will automatically dial a preprogrammed number,
of up to 32 digits, whenever an associated telephone is taken off
2
hook. Using non-volatile E memory, the K-1900-5 is telephone
line powered and will operate on any loop start central office line
or analog PABX/KSU extension.
The K-1900-5 is easily programmed remotely or locally using a
standard Touch Tone phone.
Applications
!
This product does not eliminate the
possibility of toll fraud! To further protect
against fraudulent calls, use with a TR-1
Toll Restrictor (Fax Back Document 705).
• Security and emergency phones
• Interactive point of sale displays
• Apartment security
• Catalog sales
Features
• Automated Teller Machines (ATM’s)
• Replaces leased ring down circuits
• Hot-Line reservation phones for hotels, airlines,
car rentals, etc.
• Touch Tone programmable
• Telephone line powered
2
• Non-volatile E memory (no batteries required)
• Ring detection (won’t dial on inbound calls)
• User programmable security code
• Programmable pauses in one and four second
increments
• Programmable to interrupt user Touch Tone
dialing to help control fraudulent calls from
hand held dialers, etc.
• Programmable dialing speed (normal or fast)
• Can be configured to operate from a contact
closure (Fax Back Document 818)
Specifications
Power: Telephone line powered (24V DC 20 mA minimum)*
Dimensions: 74mm x 53mm x 25mm (2.9” x 2.1” x 1.0”)
Shipping Weight: .45 kg (1 lb)
Environment: 0°C to 32°C (32°F to 90°F) with 5% to 95% non-
condensing humidity
Connections: (1) RJ11 plug, (1) RJ11 jack
Dialing Speed: Normal - 120ms on/off, Fast - 50ms on/off
* Note: When installing multiple line powered products (K-1900-5 and E-
10/E-15/E-20A/K-1500-EHF) on the same line, additional talk battery
voltage and loop current may be required.
Installation
A. Accessing the Programming Mode
Install the K-1900-5 in series between a telephone and a
C.O. line or analog PABX/KSU station.
1. Connect the K-1900-5 to a C.O. line or analog PABX/KSU station.
2. From a Touch Tone phone, call another phone connected to the
K-1900-5.
3. Take the phone connected to the dialer off hook (answer the
phone).
4. Enter ✱ followed by the six digit security code (see section D on
the next page). A double beep will indicate that you have
accessed the programming mode.
VIKING©
Programmable
Tone Dialer
Standard Analog
Telecom Device
C.O. Line or Analog
PABX/KSU Station
MODEL: K-1900-5
Quick Programming Guide
1. Call the phone connected to the dialer.
2. Answer phone. Enter ✱
&
security code.
(Factory set to 845464) Write your
security code below:
3. Enter your spped dial number
&
#00.
Note: For additional programming see
K-1900-5 Technical Practice.
Viking Electronics, Inc.
Hudson, WI 54016
5. You can now program your speed dial number and the following
features listed in section B below.
LINE IN
PHONE
Note: Programming from a cell-phone may not be suitable in areas
with weak coverage.
|