SOUND CRUISER
CAR TOP PUBLIC ADDRESS SYSTEM
MODEL S312A
INCLUDES:
•
•
•
•
•
Car top speaker system
New S805A Multimedia Stereo Amplifier
Lightweight Microphone w/on-off switch
Microphone mounting brackets
Lighter and battery adapter cables
SET UP:
INSTALL POWER CABLES
Insert 12 Volt DC Battery cable or automotive cigarette lighter cable into AC/DC in jack. Insure
connection points are clean and free of corrosion. Model S1460 International AC Adapter
(110/220V, 50/60Hz) and battery recharger can also be used. S1465 - NiCad battery pack is also
available.
TO INSTALL OR REPLACE BATTERIES
Remove all plugs from amplifier. Slip a fingernail under battery door on back of amplifier.
Remove battery pack from amplifier. Insert 10 new Alkaline “D” cell batteries, observing
polarity, or NiCad battery pack. Carefully replace battery pack. Slide battery door back into
position.
Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety
hazard or fire could result.
TO OPERATE:
Plug microphone into DYNAMIC Microphone jack.
Plug car top speaker lead into either SPEAKER jack. (Remaining speaker jack is for optional
extension speaker).
Turn Amplifier on (switch is located on the front of the amplifier). The red light will go on,
showing that power is available. Rotate VOLUME control knob to obtain desired loudness level
throughout the coverage area.
ON-OFF
When switch is in the ON position, the red light will be on.
AC/DC IN
Connection for optional adapters:
•
•
S1460 Universal AC Adapter (110/220V, 50/60Hz) / NiCad Battery Recharger
S1462 12 Volt DC (automotive cigarette lighter) Adapter
AUX OUT
Connection for 12 to 15V DC accessory
|