LPJ001A-F
802.3af PoE Gigabit Injector, 1-Port
Exceeds the 802.3af standard.
Use with IP telephones, wireless access
points, IP print servers, IP cameras,
and Bluetooth® access points.
1. Specifications
Compliance: cUL/UL®; RoHS
Insert a screw
to secure the unit
to a surface
Insert a screw to
secure the unit
to a surface
Load (Maximum): 0.35 A
Regulation: Line and Load: 54–57 VDC under all
conditions
Connectors: Data in: (1) RJ-45 (10/100/1000);
Data/PoE out: (1) RJ-45 (10/100/1000);
Power: (1) IEC 320 (3-pin)
Figure 1. Location of metal feet on the power injector.
Indicators: (3) LEDs: (1) ON, (1) CONNECT, (1) FAULT
Power: AC input voltage range: 90–264 VAC;
AC input voltage rating: 100–240 VAC, 47–63 Hz;
Output: 19.6 W at 56 VDC
Size: 1.4"H x 2.6"W x 5.5"D (1 x 6.6 x 14 cm)
Weight: 0.4 lb. (0.2 kg)
IEC-320 power connector.
Back panel.
Power and Data in
data out
2. Overview
Front panel.
The LPJ001A-F is a high-powered Gigabit power injector
that exceeds the IEEE 802.3af power standard. The injector provides
up to 19.6 W of power.
Figure 2. Ports on the power injector.
2. Connect the 3-pin IEC320 AC input connector to a
power source. Power on the injector.
Use the LPJ001A-F with IP telephones, wireless access points, IP print
servers, IP cameras, and Bluetooth access points.
3. Using CAT5e or higher cable, connect the RJ-45 port
on the injector labeled “IN” to your network switch.
See Figures 2 and 3.
3. Setting Up Your Power Injector
NOTE: Use CAT5e or higher Ethernet cables (not included).
1. Using screws, affix the metal feet on the front and/or rear to a
flat surface such as a table or wall. See Figure 1.
4. Connect the RJ-45 port labeled “OUT” on the injector over
Ethernet cable to the powered device. See Figures 2 and 3.
NOTE: The power injector should not use the weight
of the Ethernet cables for support.
5. The LEDs will light to diagnose the connection. See Tables 1
and 2.
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) •
Customer
Support
Information
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 •
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 •
•
E-mail: [email protected]
|