FlexWave™ MMW 125 – Europe, Middle East, Africa
Millimeter Wave Transmission System
FlexWave™ Millimeter Wave (MMW) is a point-to-point millimeter wave transmission system that
operates in the licensed 71 GHz to 86 GHz spectrum and provides fiber-speed wireless Line of
Sight (LOS) communication links within a 1 - 6 km range.
FlexWave MMW addresses the increasing shortage in metro access capacity by taking advantage
of the recently allocated licensed 71-86 GHz spectrum. By using the unique propagation
characteristics and the wide bandwidth of that spectrum, FlexWave MMW can support extremely
high speed data transmission for short communication links.
FlexWave MMW provides fiber equivalent performance, 99.999% reliability and security, without
the high installation costs and delays associated with inter-building fiber installations. FlexWave
MMW can be engineered to operate in close proximity to other FlexWave systems so that many
links can co-exist in the same vicinity without causing interference to one another. FlexWave MMW
is driving Ethernet beyond the office and into the metro enabling the move towards a single,
scalable, end-to-end communications technology.
Features:
• High availability (up to 99.999%)
• Best-in-class link performance
• High capacity (full duplex gigE performance)
• Reduced cost per bit due to the inherent cost- and data-efficiency of native Ethernet
• Same cost as microwave with 10 times higher bandwidth
• Simple and quick to install
w w w . a d c . c o m
•
+ 1 - 9 5 2 - 9 3 8 - 8 0 8 0
•
1 - 8 0 0 - 3 6 6 - 3 8 9 1
FlexWave™ MMW 125 – Europe, Middle East, Africa
Millimeter Wave Transmission System
Europe, Middle East and Africa rain zones
O rd e r i n g I n f o r m a t i o n
Description
Catalog Number
MMW System consisting of two radios providing full rate Gigabit Ethernet
850nm MM optical interface for both radios
1310nm SM optical interface for both radios
Copper GBIC, RJ-45 Connectors for both radios
Antennas
MMW-125-MM-SYS
MMW-125-SM-SYS
MMW-125-CU-SYS
One 1 ft (0.3 m) Parabolic Antenna with pole mount kit
One 2 ft (0.6 m) Parabolic Antenna with pole mount kit
MMW-ANT-1
MMW-ANT-2
Note: A complete MMW link consists of one MMW system plus two Antennas; MMW systems can be
ordered with different network interfaces and different antennas sizes. For example one could
order a MMW system with a single mode fiber interface and a 2 ft antenna on one end and a
multimode interface and a 1 ft antenna on the other end.
w w w . a d c . c o m
•
+ 1 - 9 5 2 - 9 3 8 - 8 0 8 0
•
1 - 8 0 0 - 3 6 6 - 3 8 9 1
3
Specifications
Frequency Band:
RF Interface:
71 - 76 GHz; 81 - 86 GHz
FDD
Modulation:
DBPSK
Frequency Source:
Configurations:
Synthesizer
Non-Protected
Hot Standby
Repeater
Mesh
Latency:
<10 usec
Forward Error Correction:
Reed Solomon
PHYSICAL (Including radio, antenna & mount)
0.3 m /1 ft
0.6 m/2 ft
Weight:
Dimensions (WxHxD):
11.79 kg (26.0 lbs)
30 x 53 x 35.5 cm
(12" x 21" x 14")
15.42 kg (34 lbs)
40.6 x 68.5 x 66 cm
(16" x 27" x 26")
TRIBUTARY
Data Rate:
Standards Compliance:
Interface Options:
1250 Mbps full duplex (Gigabit Ethernet)
IEEE 802.3z
Fiber 850 nm Multi Mode, LC connector
Fiber 1310 nm, Single Mode, LC connector
1000Base-SX to 1000BaseT
ELECTRICAL
Input Voltage:
-48 VDC (-40.5 to -57VDC)
ENVIRONMENTAL
Operating Temperature Range:
Altitude:
-27° to +131°F (-33° to +55°C)
15,000 ft (4500 m)
MANAGEMENT
Craft Interface Embedded web based (HTML) server
EMS SNMP
Voltmeter testpoints for Received Signal Strength
REGULATORY
FCC:
1.1310 RF MPE limits
Part 101
ANTENNA
0.3 m/1ft
43.8 dBi
<0.9°BW
0.6 m/2 ft
51 dBi
<0.4°BW
Fine adjust pole mount fitting 6.35 cm (2.5") to 11.43 cm(4.5") OD
From North America, Call Toll Free: 1-800-366-3891 • Outside of North America: +1-952-938-8080
Fax: +1-952-917-3237 • For a listing of ADC’s global sales office locations, please refer to our Web site.
ADC Telecommunications, Inc., P.O. Box 1101, Minneapolis, Minnesota USA 55440-1101
Specifications published here are current as of the date of publication of this document. Because we are continuously
improving our products, ADC reserves the right to change specifications without prior notice. At any time, you may
verify product specifications by contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc.
views its patent portfolio as an important corporate asset and vigorously enforces its patents. Products or features
contained herein may be covered by one or more U.S. or foreign patents. An Equal Opportunity Employer
104680AE 5/08 Revision © 2008, 2007 ADC Telecommunications, Inc. All Rights Reserved
|