Small Form-Factor Pluggable
Gigabit Ethernet, Single-Fiber 20 km
CLEI: VAUIAL8P _ _
Product P/N: 1442120G1
Issue Date: 0802
Document P/N: 61442120G1-22A
DESCRIPTION
INSTALLATION
The Small Form-Factor Pluggable (SFP) Gigabit Ethernet,
Single-Fiber is a bidirectional SFP that plugs into the
Central Office Optical Loop Termination (OLT) designed
to accept SFPs. The SFP provides a single optical
interface to the GigE physical interface. Installed into an
appropriate OLT, the SFP provides a Gigabit Ethernet
tributary interface to the supporting system.
To install the SFP into an appropriate module, complete
the following steps:
1. Inspect the SFP. If damaged, file a claim with the
carrier and then contact ADTRAN Customer Service.
2. Do not remove the protective end cap from the SFP
until the fiber optic cable is ready to be connected.
3. Insert the SFP into the SFP receptacle on the OLT.
Ensure the manufacturer’s label on the SFP is facing
upward for correct installation.
NOTE: To ensure compatibility, refer to the documentation
provided with the OLT.
4. Slide the SFP all the way into the receptacle until
there is an audible “click”.
The following features are supported on the SFP:
♦ 1000Base-LX 1490 nm Transmitter
♦ 1000Base-LX 1310 nm Receiver
NOTE: The latch on the SFP is used to remove the SFP from
the cage on the circuit card.
♦ Optical distance: 20 km maximum
5. Continue the installation and turn-up of the OLT
using the instructions in the Job Aid that
accompanied that OLT. The Installation and
Maintenance Practice (I&M) for the OLT is available
CAUTION: Due to compliance certification requirements,
only SFPs supplied by ADTRAN should be used.
ADTRAN cannot certify system integrity with
other SFPs.
Operational Specifications
♦ Optical Specifications:
– Optical transmit level: –8 dBm to –3 dBm
– Optical receive level: –22 dBm to –3 dBm
– Optical budget: 14 dB
– Optical connectors: LC
♦ Extended Environmental Support:
– Operational temperature range: –40°C to +85°C
– Storage temperature range: –40°C to +85°C
– Relative humidity to 95%, noncondensing
|