6725ip Phone Quick Reference Card
Phone Requirements
Parts List
•
•
•
Microsoft Lync Server 2010
LAN - 10/100/1000BaseT Ethernet, category 5/5E/6 straight through cabling
Power source - IEEE 802.3af Power-over-Ethernet source or the Aastra 48V Power Adapter (Optional Accessory)
™
®
6725ip Phone
Documentation
Phone
Handset
Ethernet
Cable
USB Cable
Handset
Cord
Telephone Base
Desk Legs
Setting up your phone
To connect the handset to the phone:
Front Panel
Softkeys
1. Connect one end of the handset cord (B) to the handset (A)
and the other end of the handset cord (B) to the handset jack
on the back of the phone (C).
A
B
C
2. Guide the cord through the channel on the back of the phone
to the outer edge (as shown in the “Back Panel”illustration).
OK
OK/Navigation Key
Incoming Call Light
Back Key
To connect the legs to the phone:
A total of four diꢀerent viewing angles allows you to
personalize your viewing preference.
Home Key
Voicemail Indicator
Keypad
OK
Uniꢀed Communications (UC)
Presence Logo
1. Attach each leg by inserting the tabs on the leg into the slots
on the bottom of the phone. There are three pair of leg
slots on each corner of the phone (D).
D
Headset Key
Speakerphone Key
2. For a higher viewing angle, use the second and third slots from the top.
3. For a lower viewing angle, use the ꢁrst and second slots from the top.
4. Push the stand towards the phone until it snaps into place.
Volume Down Key
Volume Up Key
Mute Key
To connect to the network:
USB Port USB Port Ethernet Ethernet
Type A Type B LAN Port PC Port
1. Connect one end of the RJ-45 Ethernet cable (supplied)
into the port marked “LAN”on the base phone.
2. Connect the other end of the Ethernet cable into your
network source jack.
Back Panel
Leg Slot Locations
For Ethernet networks that DO NOT supply
Power-over-Ethernet to the phone:
AN
PC
1. Connect an Aastra 48V power adapter (optional accessory)
to the power port on the base phone and plug the other end
into a wall power outlet.
48V Power Port
Headset Jack
Handset Jack
(connection not required if power
provided over Ethernet connection)
(Optional) Connect the phone via USB
to your computer
Handset Cord Channel
To connect the phone to your computer:
1. Connect the USB Type B connector on the USB cable (supplied)
to the Type B port on the base phone (see illustrtation above).
USB Type B
connector
to phone
USB Type A
connector to
computer
TM
2. Connect the USB Type A connector on the USB cable to a USB port
on your computer.
41-001348-00 Rev 04
|