Alcatel-Lucent 1850 TSS-160
T R A n S p o R T S e R v i C e S w i T C h
|
R e L e A S e 3
The Alcatel-Lucent 1850 TSS-160 is a compact version of the Alcatel-Lucent TSS-320. The two models share
the universal switch matrix architecture, operate on a common software release and use common circuit
packs. The Alcatel-Lucent 1850 TSS-160 is a next-generation, Packet-Optical Transport platform that supports
any mix of traffic, from all-circuit to all-packet. With the Alcatel-Lucent 1850 TSS-160, businesses can begin
with circuit-based transport and gradually ramp up packet transport by simply changing line cards. The Alcatel-
Lucent 1850 TSS-160 supports current traffic requirements while eliminating the scalability issues encountered
when traditional multiservice provisioning platforms (MSPPs) are confronted with the high growth of packet-
based traffic.
The Alcatel-Lucent 1850 TSS-160 offers
the flexibility to split increasing traffic
demands among any combination of
Carrier Ethernet, Transport Multi-
Protocol Label Switching (T-MPLS),
wavelength division multiplexing
(WDM), optical data unit (ODU) and
SDH/SONET transport technologies. It
offers powerful cross-layer network
management and a unified control
plane, simplifying operations and
reducing the total cost of ownership.
• Fully integrates photonic, optical
and data layers
¬ Any transport-technology mix
¬ Carrier Ethernet service through
T-MPLS for standards-based con-
nection-oriented packet transport
¬ SONET/SDH Optical Transport
Hierarchy (OTH) switching, includ-
ing higher-order and lower-order
(HO/LO) synchronous transport
signal (STS) and VC-switching
¬ Very long haul (VLH)/ultra long
haul (ULH) support
Features
¬ ATM pseudo-wire transport and
gateway functions
• Common software and circuit packs
¬ Dense WDM (DWDM)
with Alcatel-Lucent 1850 TSS-320
¬ Transport-oriented OAM and
G-MPLS
• Unique, universal switch architecture
¬ Switches packets or circuits in their
native format
¬ Accommodates any traffic mix,
from all-circuit to all-packet
¬ Offers TDM and packet line cards
for technology-specific processing
Environment
Ethernet forwarding criteria
• Port
Protection
• Ethernet network protection
¬ RSTP: 802.1w
• Operating temperature:
-5°C to +45°C (23°F to 113°F)
• Port plus MAC
• Relative humidity: 0% to 90%,
non-condensed
• Port plus VLAN
¬ MSTP: 802.1s
• Port plus MAC plus VLAN
¬ Link aggregation
• Port plus MAC plus VLAN plus
prio bits
• T-MPLS network protection
¬ Tunnel Lin Protection 1:1
• SONET/SDH network protection
¬ Single- and dual-ended APS 1 + 1
Regulatory compliance
• CE and UL certification
• NEBS level 3
• Unicast traffic
• Multicast traffic
• Broadcast traffic
• FCC part 15 class A
ETSI
¬ Subnetwork Connection
protocol (SnCp), unidirectional
path-switched ring (UPSR)
Dimensions: Alcatel-Lucent 1850
TSS-160 subrack
IGMP functionality
• Internet Group Management
Protocol (IGMP) snooping
¬ Multiplex Section-protection
Ring (MSPRING) 2F bidirectional
line switching ring (BLSR)
• Subrack dimensions
¬ Height: 304 mm (12.0 in.)
¬ Width:498 mm (19.6 in.)
¬ Depth: 290 mm (11.4 in.)
• IGMP proxy
• Equipment protection
¬ power protection
• IGMP fast leave
• Designed to be installed in a
standard eTSi rack
ATM functionality
• Pseudo-wire emulation edge to
edge (PWE3): ATM-PWE3 gateway
¬ Controller protection
¬ Universal switch protection
¬ Height: 2.20 m (7.2 ft.)
¬ Width: 600 mm (23.6 in.)
¬ Depth: 300 mm (11.8 in.)
Power and cooling
• OC-3/STM-1 ATM unchannalized
G-MPLS control plane
• T-MPLS tunnel setup
• TDM HO path setup
• ATM virtual path identifier/virtual
channel identifier (VPI/VCI)
N:1 mapping with PWE3 static
configuration
• Power supply: DC feed (-48-V DC
nominal)
Management
• Alcatel-Lucent 1350 Optical
Management System (oMS)
• ATM QoS, OAM F4, F5: PWE OAM
• Power supply: -65-V
• Power consumption: up to 2000 W
• Cooling: forced air
T-MPLS functionality
• Data plane: T-MPLS, MPLS
• TL1
• Zero-installation craft (ZIC) terminal
• Command line interface (CLI)
Environment
• T-MPLS OAM: CV, automatic pro-
tection switching (ApS), forward
defect indication (FDi)
• Operating temperature:
-5°C to +45°C (23°F to 113°F)
• Simple Network Management
protocol (SnMp)
• Relative humidity: 0% to 90%,
non-condensed
• Tunnel Lin Protection 1:1
• Secure Shell (SSH) v2/Secure
Sockets Layer (SSL) for secure
connection
• Ethernet line (E-line), E-LAN
and e-Tree
Regulatory compliance
• CE certification
SONET/SDH functionality
• Cross-connection
Physical specifications
ANSI
• Operating conditions:
eTS 300 019, Class 3.2
• Termination
Dimensions: Alcatel-Lucent 1850
TSS-160 subrack
• Storage conditions:
eTS 300 019, Class 1.2
• Ethernet mapping over SONET/SDH
¬ Generic framing procedure:
GFP, G.7041
• Subrack dimensions
• Transportation conditions:
eTS 300 019, Class 2.2
¬ Height: 304 mm (12.0 in.)
¬ Width: 498 mm (19.6 in.)
• Virtual concatenation (VCAT)
• Electrostatic discharge (ESD)/elec-
tromagnetic compatibility (EMC):
eTS 300 386 “Telecommunications
Center”
• Link capacity adjustment scheme
(LCAS)
¬ Depth: 305 mm (12.0 in.)
or 356 mm (14.0 in.)
• Performance monitoring
• HO and LO capabilities
• Designed to be installed in a
standard AnSi rack
¬ Height: 2.13 m (7.0 ft.)
DWDM functionality
• Node configurations
¬ Terminal
¬ Width: 660 mm (26.0 in.)
¬ Depth: 305 mm (12.0 in.)
or 356 mm (14.0 in.)
¬ in-line amplifier (iLA)
• Network configurations
¬ point-to-point
¬ Linear
Power and cooling
• Power supply: DC feed (-48-V DC
nominal)
• Power supply: -58-V
¬ Ring
• Power consumption: up to 2000 W
• Cooling: forced air
¬ Mesh
Alcatel-Lucent 1850 TSS-160 | Release 3 | Data Sheet
3
are trademarks of Alcatel-Lucent. All other trademarks are the property of their respective owners.
The information presented is subject to change without notice. Alcatel-Lucent assumes no responsibility
for inaccuracies contained herein. Copyright © 2008 Alcatel-Lucent. All rights reserved.
CAR4688080916 (09)
|