Datasheet | integrated Multiservice Access Platform
XE1
AT-TN308-A 10 Gigabit Ethernet Network Module
Aggregation of GbE NetworkTraffic
The XE1 module available for use with the
iMAP 9000 series is a new advancement in
network card flexibility and capacity supporting
10GbE. As network bandwidth continues to
grow, Service Providers find increasing
Metro Ethernet Connectivity
Key Features
Up to 2 XE1 Network Modules are supported
per an iMAP 9400 or 9700 platforms providing
unprecedented capabilities for the delivery of
user-centric services as well as network traffic
aggregation.When used in conjunction with the
CFC56, the 10 GE ports can be used as either
as network interfaces for subtended remote
locations using EPSR protected transport rings
with sub 50ms failover, aggregation into Metro
routers (Provider Edge) or for point-to-point
connectivity between PoPs. This is in addition
to allowing the service provider to support at
wire-speed non-blocking up to 17 different
service modules in the iMAP for delivering
value-add next-generation broadband services
and applications.
• 1 x 10 GbE GbE Wirespeed ports for Uplinks
• XFP Optics
TM
• Support for EPSR 50ms Resiliency
bandwidth requirements farther in the local
loop.The ability to maintain a single IP
• Hardened for OSP designs
infrastructure to address Network Transport
bandwidth as well as last mile access bandwidth
is pivotal for any network operator.The XE1
module is primarily intended to be used as
an aggregation element with the introduction
of Allied Telesis’ 10G iMAP common control
upgrade (CFC56) and the GE8 service module.
Combined, these modules provide 10G
QoS
• Eight Queues
• Strict Priority scheduling
• VLAN Stacking
Security
• Upstream Forwarding Only
• Extensive ACL Suport
transport bandwidth as well as aggregation
TM
of up 8 EPSR rings providing an extremely
flexible, reliable and dense aggregation point
from any network location. As network designs
continue to blend the line between Access
andTransport, the XE1 will become a key
component of any Carrier Ethernet and IP
Triple Play network design.
Part of AlliedTelesis’ IP Broadband
Access Family
Services Supported
• High Speed Internet
• VoIP
• IPTV
• BusinessVPN
Whether it is Metro Ethernet, IPTriple Play,
BroadbandVDSL2/ADSL2+, FTTH or POTS,
the iMAP family is the ideal platform for last
mile service delivery. Added to the ability to
support 100% of the available iMAP service
modules, the XE1 network module has also
been designed to survive the most rugged
environmental conditions. This makes it perfect
choice for networks which require high
flexibility and carrier capabilities anywhere in
the operators’ network.
• Network Element Subtending
The XE1 network module, available for use
with the iMAP 9400 and iMAP 9700 chassis
groups equipped with the CFC56 controller
module, is a new advancement in protected
10 Gigabit aggregation speed and transport.
The XE1 provides unmatched flexibility for the
aggregation of bandwidth-intensive applications
and services including the delivery of IP Triple
Play over any media (Fiber, Copper and xDSL)
as well as Carrier Ethernet services to
residential and business customers. It continues
to support the carrier-class capabilities from
the Allied Telesis Network Module family (GE3)
in addition to increased capacity and the
enhanced QoS capabilities.
Provisioning, management and diagnostics of
subscriber ports can be accomplished from
either the iMAP command line interface or via
the AlliedView NMS. The XE1 also has a fully
supported SNMP interface and supports all the
major MIBs.
AlliedTelesis’ iMAP family of integrated
Multiservice Access Platforms
Allied Telesis
|