®
Over the Range Microwave Oven
CABINET OPENING DIMENSIONS
PRODUCT MODEL NUMBERS
AMV1154BA
AMV5164BA
AMV5164BC
Bottom edge of
cabinet needs
to be 33" or
more from the
cooking
Electrical: Product rating is 120 volts AC, 60 Hz, 14.5 amps (13 amps
CANADA) and 1.65 kilowatts (1.5 kilowatts CANADA). This product must be
connected to a supply circuit of the proper voltage and frequency. Wire size
must conform to the requirements of the National Electrical Code or the
prevailing local code for this kilowatt rating. The power supply cord and
plug should be brought to a separate 20-ampere branch circuit single
grounded outlet. The outlet box should be located in the cabinet above the
microwave oven. The outlet box and supply circuit should be installed by a
qualified electrician and conform to the National Electrical Code or the
prevailing local code.
16-½ "
surface
33"min.
2"
Backsplash
PRODUCT DIMENSIONS
C
A
NOTES:
B
• The space between the cabinets must be 30" (76.2 cm) wide and free
of obstructions.
• This microwave oven is for installation over ranges up to 33" (83.8 cm)
wide.
• If you are going to vent your microwave oven to the outside, see
Venting Requirements for exhaust duct preparation.
• When installing the microwave oven beneath smooth flat cabinets be
careful to follow the instructions on the top cabinet template for
power cord clearance.
Width (A)
29-7/8"
(75.9 cm)
29-7/8"
(75.9 cm)
29-7/8"
(75.9 cm)
Depth (B)
15"
(38.1 cm)
15-1/4"
(37.7 cm)
15-1/4"
(37.7 cm)
Height (C)
16-1/2"
(41.9 cm)
16-1/2"
(41.9 cm)
16-1/2"
(41.9 cm)
AMV1154BA
AMV5164BA
AMV5164BC
VENTING REQUIREMENTS
NOTE: It is important that venting be installed using the most direct route
and with as few elbows as possible. This ensures clear venting of exhaust
and helps prevent blockages. Also, make sure dampers swing freely and
nothing is blocking the ducts.
For best performance, use no more than three 90° elbows.
To calculate the length of the system you need, add the equivalent length
for each vent piece used in the system. See the following examples:
A 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent should
be used.
The total length of the vent system including straight vent, elbow(s),
transitions and wall or roof caps must not exceed the equivalent of 140 ft
(42.7 m) for either type of vent.
Outside ventilation requires a HOOD EXHAUST DUCT. Read the following
carefully.
OUTSIDE BACK EXHAUST (EXAMPLE ONLY)
OUTSIDE TOP EXHAUST (EXAMPLE ONLY)
The following chart describes an example of one possible ductwork installation.
The following chart describes an example of one possible ductwork installation.
DUCT PIECES
EQUIVALENT
LENGTH*
NUMBER
USED
EQUIVALENT
LENGTH
DUCT PIECES
EQUIVALENT
LENGTH
NUMBER
USED
EQUIVALENT
LENGTH
x
=
x
=
Roof Cap
40 Ft.
(12.2 m)
x
(1)
(1)
(2)
=
40 Ft.
(12.2 m)
Roof Cap
24 Ft.
(7.3 m)
x
(1)
(1)
=
24 Ft.
(7.3 m)
3 Ft. Straight Duct
(3¼" x 10"
Rectangular)
3 Ft.
(1 m)
x
x
=
=
3 Ft.
(1 m)
12 Ft. Straight Duct
(6" Round)
12 Ft.
(3.7 m)
x
x
=
=
=
12 Ft.
(3.7 m)
90° Elbow
10 Ft.
(3 m)
20 Ft.
(6.1 m)
Rectangular-to-Round 5 Ft.
(1.5 m)
(1)
5 Ft.
(1.5 m)
Transition Adaptor*
Equivalent lengths of duct pieces are based on actual
tests and reflect requirements for good venting
performance with any vent hood.
Equivalent lengths of duct pieces are based on actual
tests and reflect requirements for good venting
performance with any vent hood.
Total Length
=
63 Ft.
(19.2 m)
Total Length
41 Ft.
(12.5 m)
NOTE: For back exhaust, care should be taken to align exhaust with space between studs, or wall should be
prepared at the time it is constructed by leaving enough space between the wall studs to accommodate
exhaust.
* IMPORTANT: If a rectangular-to-round transition adaptor is used, the bottom corners of the damper will have
to be cut to fit, using tin snips, in order to allow free movement of the damper.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 8101P679-60
09-15-08
|