INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Champion® PRO 2-piece Toilet
211AA Series Right Height® Elongated
211BA Series Right Height® Round Front
211CA Series Elongated
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years.To ensure this product is installed properly, please read
these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE.TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
TANK 4225A
EZ-INSTALL KIT INCLUDED WITH TANK
Attachment Handles
with Nuts (2)
PlasticWashers (2)
TankTo Bowl Gasket
BOWL 3195A RIGHT HEIGHT® ELONGATED
BOWL 3195B RIGHT HEIGHT® ROUND FRONT
BOWL 3195C ELONGATED
EZ-INSTALL KIT INCLUDED WITH BOWL
T-Bolts with Retainer (2)
Bolt Caps (2)
Bowl-To-Floor Knobs (2)
SOLD SEPARATELY
Wax Ring
Water Supply Line
Slow CloseToilet Seat
Pr o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
A S A m e r i c a , I n c . 2 012
©
7301836-100 Rev. B
3
4
Apply weight evenly.
Do not move after
placement. Water
tight seal may break.
Hand tighten
only. Do not
overtighten.
!
5
6
Tighten handles
alternately until the
tank contacts the
front and back of the
bowl achieving
china-to-china
contact.
NOTE: To ease
installation, push
down on the top of
the tank while
tightening handles.
7
WARNING: Overtightening of
!
water supply line nuts could
result in breakage and potential
flooding. If the connection leaks
after hand tightening, replace
the supply line. Do not use any
type of sealant on the water
supply connection. Use of
plumber’s putty, pipe dope, or
any other type of sealant will
void the warranty.
A
Connect water
supply line.
(Sold separately)
Hand tighten nut.
B
Turn on water supply.
7301836-100 Rev. B
- 3 -
8
Water Level
Adjustment Knob
Trip Lever Rod
A
Refill Tube
Adjust water level to level
indicated on tank by turning
water level adjustment knob
to move float cup up or down.
Approximate
Water Level
Flush Valve Chain
Float Cup
Fill Valve
Or Water
Control
Flapper
Flapper
Seal
Flush
Valve
B
Overflow
Tube
Tank to Bowl Gasket
Water Supply Line
REPAIR PARTS LABEL
LOCATED UNDERTANK LID.
CARE AND CLEANING
When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth.
WARNING: Do not use in-tank cleaners. These products can seriously corrode fittings in the tank. This damage can cause leakage and property damage.
American Standard shall not be responsible or liable for any damage caused by the use of in-tank cleaners.
TROUBLESHOOTING GUIDE - See Step 8 For Diagram
Problem
Possible Cause
Corrective Action
Does not flush a. Water supply valve closed.
b. Supply line blocked.
a. Open valve and allow water to fill tank.
b. Shut off water supply, disconnect supply line and inspect all gaskets and washers. Reassemble.
c. Readjust chain length as required.
c. Flush valve chain too loose or disconnected.
d. Sand or debris lodged in water control.
d. Shut off water supply. Remove cap and clean as per Fluidmaster maintenance instructions at:
Poor or
sluggish flush
a. Bowl water level too low.
a. Check that refill tube is connected to water control and inserted into overflow tube without being
kinked or damaged.
b. Open supply valve fully. Be sure that proper supply tube size is used.
c. Remove obstruction. Consult a plumber if necessary.
d. Normal supply pressure must be at least 20 psi.
b. Supply valve partly closed.
c. Partially clogged trapway and/or drain pipe and/or vent.
d. Supply pressure too low.
Toilet leaks
a. Poor supply line connection.
b. Poor bowl to tank/floor connection.
a. Review Step 7 of installation procedure.
b. Review Step 1 through 6 of installation procedure.
Toilet does not a. Flapper seal leaking or deformed.
a. Clean debris from seal surface. Replace flapper seal as needed. See web for more info.
b. Shut off water supply. Remove cap and clean as per Fluidmaster maintenance instructions at:
shut off
b. Sand or debris lodged in water control.
c. Flush valve chain too tight, holding flapper open.
c. Readjust chain length as needed.
Toilet bowl
rocks after
installation
a. Wax ring not fully compressed.
b. Floor not level.
a. Retighten bowl-to-floor knobs.
b. Use toilet shims and /or place a bead of caulk around the base of the toilet.
FOR REPAIR PARTS LIST, SEE LABEL UNDERTANK LID.
In Canada:
AS Canada, ULC
In Mexico:
In the United States:
American Standard Brands
P.O. Box 6820
American Standard B&K Mexico
S. de R.L. de C.V.
5900 Avebury Rd.
Mississauga, Ontario
Canada L5R 3M3
Toll Free: (800) 387-0369
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
Toll Free: 01-800-839-1200
Piscataway, New Jersey 08855
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: (800) 442-1902
7301836-100 Rev. B
- 4 -
|