Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
MODEL # 1638CT
Providence Ridge Travel System
Instruction Manual
Convenience through Innovation and thoughtful design
11.06
PARTS
Child Tray
Parent Tray
Base
Locking Cap
Hub Cap
Rear Wheels
Rear Axle Assembly
Stroller
Solid Cap
Front Wheels
Car Seat
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
TO ASSEMBLE STROLLER
* Remove stroller from box. The front wheels, rear wheels, and child tray,
and parent tray need to be installed prior to use.
* To attach the front wheels, slide the red unlock mechanism and squeeze
the stroller handle while pulling backward on the stroller to unfold. See
figures 1 and 2.
* Lean the stroller backwards so that it rests on the handle and rear frame
tubes and the front wheel tubes are pointing upward. Position the front
wheel assembly at the front tube such that the hole in the swivel assembly
will slide onto the front tube. Please see figure 3. Push each front wheel
assembly onto the front tube being careful that wheel assembly locks onto
the front leg. Pull on the wheel assembly to ensure that it is securely
attached to the stroller. Please see figure 3.
Figure 1.
Figure 2.
* Lean the stroller forward to rest on the front wheels. Assemble the rear
wheels as follows:
1. Slide the rear axle assembly onto the rear stroller legs until they lock
into place. Please see figure 4.
2. Slide each wheel onto the rear axle and secure in place with the
Locking Cap. Snap the solid cap over the Locking Cap. Snap the
Hub Cap onto the wheel. Please see figure 5. Please see figure 6 for
order assembly.
Figure 3.
Pull on each wheel to ensure that each is firmly attached to the axle.
* Ensure that the wheels are firmly locked into place. Do Not use the stroller
if the wheels are not locked into place, but rather contact our customer
service department immediately at (800) 328-7363, between the hours of
8:00am and 4:30pm PCT, for assistance.
Figure 4.
Figure 5.
Figure 6.
3
* To attach the front child tray, push the angled tray onto the post at the
end of the right armrest, while pressing downward on the snap button,
until locked into place. Please see figure 7. Rotate the tray downward
until latched onto the left armrest. Please check that the snap button
comes through and securely latches the tray in place. Please see figure
8.
* To remove front child tray, press inward on the left side tray release
button and rotate upward on the tray. Please see figure 9. Please note
that you may remove the tray completely by depressing the snap button
on the right side as shown in figure 10 while pulling forward on the tray.
Please see figure 7.
Figure 7.
* To install the canopy slide the male ends of the canopy into the female
slots on the stroller frame. Please see figure 11. To open the canopy
push forward on the front frame tube of the canopy. Please see figure
12.
* To attach the parent tray line up the parent tray slots with the
corresponding slots on the stroller frame, slide down until it locks into
place. Check to make sure the parent tray is secure before using. Please
see figure 14
Figure 8.
* To remove the parent tray, locate the locking tabs under the tray, pull
outward on the locking tabs and lift up to remove. Please see figure 15
Figure 9.
Front frame
tube
Figure 12.
Figure 11.
Figure 10.
Figure 15.
Figure 14.
4
TO SECURE THE CHILD
• The shoulder straps of the 5-point harness have 3 attachment positions.
Select the position that places the shoulder strap level with, or below
the top of the child's shoulder. To access the harness pull apart seat pad.
Please see figure 16.
• Carefully place the child in the stroller seat and bring the safety harness
around the child's waist and over the shoulders. Place the crotch strap
between the child's legs. Insert the male end of each shoulder/waist belt
into the buckle on the crotch strap. Tighten the harness to be snug around
the child's waist and over the child's shoulders Please see figure 17.
Figure 16.
Shoulder Strap
Waist
Strap
Squeeze
Adjust for a
snug fit
Crotch Strap
Figure 18.
Figure 17.
• To release, apply pressure to both sides of each male clip until the clip is released. See figure
18. This process requires a moderate amount of effort so as to prevent an accidental release by
your child.
WARNING:Avoid serious injury from
falling or sliding out. Always use the safety
harness.
STRANGULATION HAZARD:
Child can strangle in loose straps. Never leave
child in seat when straps are loose or undone.
5
ATTACHMENT OF THE BABY TREND INFANT CAR SEAT
* To attach the Baby Trend Infant Car Seat, recline the seat all the way
back. Please see figure 19
* Check that the front child tray is firmly attached to the stroller
armrests. Make sure that the car seat locks into the front child tray. Then
turn tabs on stroller frame to lock the front of the car seat into the stroller.
See figure 20.
* Position the Infant Car Seat, facing toward the rear of the stroller, so
that the seat shell goes into the front tray and latches into place. Please
see figure 21. Check that the Infant Car Seat is firmly locked onto
the front tray before using.
* To remove the Infant Car Seat, squeeze the release handle located at the
Figure 19.
foot-end of the seat and carefully lift upward on the seat. Please see
figure 23.
Locks
into tray
Figure 20.
Figure 21.
WARNING:Failure to follow these
car seat attachment instructions could re-
sult in serious injury or death.
Figure 22.
6
SEAT BACK POSITIONING
WARNING: The upright position should
be used only for a child that is at least 6 months
old.
* The seat has a multiple position recline that is controlled by a cord and
spring loaded adjuster behind the seat. To recline the seat, pull back on
the loop of the adjuster. Please see figure 23. To place the seat back in
a more upright position, grab the adjuster with one hand and pull the
cord to the desired position with the other hand. See figure 24.
The cord will lock automatically.
Figure 23.
Figure 24.
BRAKES
WARNING: Always set brakes when the
stroller is not being pushed so that the stroller will not
roll away. Never leave stroller unattended on a hill or
incline as the stroller may slide down the hill.
* To engage brakes, apply light downward pressure to the brake lever
located on each rear wheel. The stroller may require slight forward or
rearward movement in order to line up the teeth on the brake with each
wheel brake cluster. See figure 25. Check that the stroller will not move
and that the brakes are properly applied. To release, gently lift up on the
brake lever.
Figure 25.
7
CANOPY
Front frame
tube
* To open the canopy, push forward on the front frame of the canopy. To
close canopy, pull the front edge toward the rear of the stroller until
folded. Always fold the canopy prior to folding the stroller frame. Please
see figure 26.
Figure 26.
CAUTION: Read the following section completely before folding your stroller!
TO FOLD STROLLER
* Close the canopy as described in the canopy section. NOTE: For an
easier fold place the seat in the furthest recline position. Also you
must flip the carseat support tabs to the outside of the stroller frame
before folding. To fold the stroller slide the red fold lock with your
thumb while squeezing the large red fold button in the center of the
handle and push forward on the handle. Please see figure 27. Once the
stroller begins to fold, release the red handle and push forward on the
handle until the stroller is folded. Please see figure 28. To stroller will
automatically lock when folded correctly, and will stand freely in the
folded position.
Figure 27.
WARNING:Failure to
follow these folding instructions
could result in serious injury or
death.
Figure 28.
8
TO UNFOLD STROLLER
* To unfold the stroller slide the red fold lock with your thumb while
squeezing the large red fold button in the center of the handle and push
down on the handle.
Figure 29.
WARNING:Failure to
follow these folding instructions
could result in serious injury or
death.
Figure 30.
CLEANING SEAT PAD
* To clean the seat pad. use warm water, soap and a sponge, and let air
dry.
STOP
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT,
PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT (800) 328-7363
BETWEEN THE HOURS OF 8:00AM AND 4:30PM PACIFIC COAST TIME FOR ASSISTANCE.
9
|