ULTRA BASS CHORUS BUC400
Ultimate Bass Chorus Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA BASS CHORUS BUC400.
This ultimate effects pedal is specifically designed to match the range and applications of bass guitars.
Thanks to its high-performance features you get super thick chorus with unbelievable stereo effect.
The chorus effect slightly detunes the original signal. A very pleasant detune effect is created relative to
the pitch variation. The chorus effect is often used for dispersing signals.
1. Controls
(5)
(4)
(1)
(2)
(3)
(7)
(8)
(6)
(1) The LEVEL control adjusts the output level.
(2) The LOW FILTER control lowers the amount of ultra-low frequencies in the effect signal to achieve
more defined tone and avoid muddiness of sound.
(3) The RATE control determines the chorus effect speed.
(4) Turn up the DEPTH control to achieve a more full and deeper effect sound.
(5) The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the effect.
(7) Use this 1" TS IN connector to plug in the instrument cable.
(8) The two 1" TS connectors OUT A and OUT B send the signal to your amp. Use both connectors if
you want to achieve full stereo chorus effect. For mono use just plug in OUT A.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,
press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE INFORMATION
ULTRA BASS CHORUS BUC400
Responsible Party Name:
Address:
MUSIC Group Services US Inc.
18912 North Creek Parkway,
Suite 200 Bothell, WA 98011,
USA
Phone Number:
Phone: +1 425 672 0816
ULTRA BASS CHORUS BUC400
complies with the FCC rules as mentioned in the following paragraph:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC Group can void
the user’s authority to use the equipment.
|