ULTRA OCTAVER UO300
3-Mode Octaver Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA OCTAVER UO300.
This high-quality effects pedal creates a monster sound by adding two additional tones using your
guitar—one and two octaves below the original tone. Thanks to its high-performance features you’ll
get natural, clear octave sounds with constant pitch, even for staccato playing.
Octave effect is possible due to a circuitry that generates signals one or more octaves below the input signal.
1. Controls
(5)
(4)
(1)
(2)
(8)
(3)
(7)
(6)
(1) The RANGE selector allows you to optimize the effects pedal for HIGH, MID and LOW frequencies
and use instruments with different frequency ranges (guitar, bass guitar, keyboard, etc.)
(2) The DIRECT control adjusts the level of the original input signal.
(3) The OCT 1 control adjusts the level of the generated signal one octave below the original signal.
(4) The OCT 2 control adjusts the level of the generated signal two octaves below the original signal.
(5) The blue ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the effect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,
press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.
◊
The UO300 has no on/off switch. As soon as you insert the jack into the in connector,
the UO300 begins running. When not using the UO300, remove the jack from the
in connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE INFORMATION
ULTRA OCTAVER UO300
Responsible Party Name:
Address:
MUSIC Group Services US Inc.
18912 North Creek Parkway,
Suite 200 Bothell, WA 98011,
USA
Phone Number:
Phone: +1 425 672 0816
ULTRA OCTAVER UO300
complies with the FCC rules as mentioned in the following paragraph:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC Group can void
the user’s authority to use the equipment.
|