OVERDRIVE DISTORTION OD300
Thank you for showing your confidence in us by purchasing the BEHRINGER
OVERDRIVE DISTORTION OD300. This effects pedal is ideally suited for electric guitars.
Thanks to its high-performance features you can create state-of-the-art overdrive,
distortion or a combination of both effects.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The TONE control allows you to shape your overall sound.
The DRIVE control adjusts the intensity of the overdrive/distortion effect.
Use the MODE control to adjust the balance between overdrive and distortion
effect. In leftmost position you got pure overdrive effect and in the rightmost
position you get pure distortion.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
+
The OD300 has no on/off switch. As soon as you insert the jack into the
IN connector, the OD300 begins running. When not using the OD300,
remove the jack from the IN connector. This extends the life of the
battery.
The SERIAL NUMBER is located at the bottom.
|