With the tent secure, drape the fly over the tent body. Connect the
four corner buckles on the fly to their mates on the tent webs.
NOTE: Depending upon your preference, you my fit the fly on the
tent two ways. For rainey weather, we recommend that you place
the fly over the tent with the vestibule sections over the doors and
that you join yellow web to yellow web. For fair weather and easier
egress, turn the fly and join the yellow web to a black web.
ASSEMBLY INSTRUCTIONS
SCENIC PASS 2 TENT:
B
C
Component List:
1 Tent Body, 2 Tent Poles, 1 Tent Fly, 1 Carry Bag,
1 Pole Bag, 1 Stake Bag/ Stakes
A
fig. 3
D
Reach under the fly and connect the hook and loop tabs to the
tent poles. See fig. 8 & 9.
Unroll and unfold the tent with the floor on the ground.
Remove the fly and set it aside. Do not stake the tent down
yet. In windy conditions, we recommend that a narrow end
should face into the wind and that you stake down one
corner of this end. See fig.1
Raise up the tent poles and attach the
peak of the tent to them. Capture both
poles where they cross, with the loop and
dog bone. See fig. 4 & 5.
Join the shock-corded poles together. Try to prevent pole
sections from snapping together, as this can damage the
pole ends. Make certain each insert end has seated firmly
fig.8
fig.9
into each plain end.
fig. 4
C
At the front of the tent, pull the stake out loop on the vestibule taut
and stake it down. Make sure that the vestibule is tight. Repeat
with the other vestibule at the rear of the tent. See fig. 10.
D
B
fig. 5
fig. 1
A
Attach all the clips to the poles. Your tent is now free-standing,
place it in location that has enough room for the fly and stake it
down through the corner loops. Stake the opposite corners while
applying tension to smooth the floor wrinkles. See fig. 6 & 7
At the front corner of the tent;
[with the yellow web]- A, fit
the post end of one of the
aluminum poles into the web
grommet. Angle the pole to
the opposite corner;
At corner , repeat with the
second pole to
A
to
C.
fig.10
B
fig. 2
B
D.
Start at the front of the tent at
and grasp the end of the pole in one hand and the web
loop in the other. Push the pole from to creating an arc.
Insert the post into the web grommet to tension the tent
D
With the vestibule wings staked down and tight, go around the
tent, and adjust or tighten all the side release buckles.
Your tent is now ready for use.
D
B
across the diagonal. Repeat with the other pole;
See fig. 2 & 3.
C
to
A.
NOTE: In strong winds, tie extra ropes to the storm loops on the
fly and stake down so that the ropes are tight.
fig. 6
fig. 7
REV A 4.09
|