5. Select your connection type (this information is provided by your ISP) and click
"Select". Depending on your selection, you will see the "Static IP Address" page or
the "PPPoE" page. Enter the required values provided by your ISP and click "Enter".
6. The “MAC Cloning/Entry” screen will appear. If your ISP binds your connection to
the MAC address of your network adapter, click "Clone MAC Address" or enter the
MAC address here. Press “Enter”.
Wireless Cable/DS
L
Gateway Router
Quick Setup Guide for Mac®
F5D6230-3
Setting up the Router is accomplished in three easy steps:
1. Connect the Router to your network.
2. Configure your computer’s TCP/IP settings.
3. Configure the Router to your ISP’s settings.
Your Router has been set up to communicate with your ISP. You should have Internet
access at this point. If you are having trouble, see the “Troubleshooting” section in the
user’s manual.
Step 1: Connect the Router to your network
1. Power down your equipment.
2. Connect a network cable between each of your computers and the Router.
Connect each Mac to one of the ports on the rear of the Router labeled 1–3.
Do not connect a computer to the port labeled “WAN”.
3. Connect a network cable between the Router and your cable or
DSL modem.
Be sure this cable is plugged into the port labeled "WAN" on the Router.
BELKIN
GATEWAY
ROUTER
belkin.com
Belkin Components
501 West Walnut Street
Compton • CA • 90220 • USA
310.898.1100
Belkin Components, Ltd.
Belkin Components, Ltd.
7 Bowen Cresent • West Gosford
NSW 2250 • Australia
Unit 13 • Gatelodge Close • Round Spinney
Northampton • Northants • NN3 8RX • United Kingdom
+44 (0) 1604678300
+61 (2) 4372 8600
© 2001 Belkin Components. All rights reserved. All trade names are registered trademarks of respective manufacturers listed.
Mac is a registerd trademark of Apple Computer, Inc. P73882
4. Power on the cable or DSL modem.
|