Belkin Network Card F8V1027 User Manual

Wireless Modem Jack  
Create a phone jack for your modem from any AC outlet  
Table of Contents  
Introduction . . . . . . . . . . . . . . . . . 2  
Safety and Operation Precautions . . . 2  
Getting Started . . . . . . . . . . . . . . . 3  
Equipment Installation . . . . . . . . . . 3  
Security Programming . . . . . . . . . . . 4  
Troubleshooting . . . . . . . . . . . . . . . 5  
User Manual  
Things You Should Know . . . . . . . . . 5  
Information . . . . . . . . . . . . . . . . . 6  
F8V1027  
 
Getting Started  
Unpacking  
Carefully remove units from packaging. In the  
unlikely event there is any visible damage, DO  
NOT attempt to operate the equipment. Notify  
your dealer or shipping carrier immediately.  
Keep this guide for future use.  
Equipment Contents  
• Base Unit  
The base unit has two telephone jacks on  
the right side and a green light on the  
front. It plugs into the wall jack and  
the phone.  
• Extension Unit  
The extension unit has one telephone  
jack on the right side and a green  
indicator light on the front. This is the  
unit that can be moved from location to  
location to create a phone jack in an  
electrical outlet.  
• Telephone Cord  
A 6-foot telephone cord is provided to connect  
the base unit to the existing wall phone jack.  
Equipment Installation  
Follow the steps below to install the Wireless Modem Jack for modem equipment.  
Base Unit  
NOTE: To ensure proper performance, it is important to install the base unit FIRST and then install  
the extension unit. Also, ensure that both units are securely plugged into the AC wall outlet.  
1. Plug either end of the provided telephone cord into either jack on the right side of the base  
unit, and the other end into any existing telephone wall jack.  
2. Plug the phone previously used at that location into the extra jack on the side of the  
base unit.  
3. Plug the base unit into an electrical outlet.  
Wall Outlet  
Wall Phone Jack  
Telephone Cord  
Base Unit  
3
 
Extension Unit  
4. Plug the extension unit into an AC electrical outlet near where you want a new phone jack.  
5. Plug telephone’s line cord into the extension unit.  
6. Please note: Installation is not complete until you perform the steps outlined in the Security  
Programming directions below. Once this is done, you will be able to hear a dial tone on  
your phone.  
Wall Outlet  
Extension Unit  
Security Programming  
The base and extension units are now connected to your telephone system. After completing  
steps 1-5 in the installation sequence above, set up security for both units by following the easy  
steps below.  
1. Using a small pointed object, such as a pen or pencil tip, press the black recessed button on  
the side of the base unit. The green light on the front of the base unit will come on and stay  
lit during the security programming sequence.  
Note: Once the button is pressed, you must program the extension unit within five minutes.  
If the five-minute time limit is exceeded, the light on the base unit will go out and the  
programming procedure must be restarted by once again pressing the button on the  
base station.  
Base Unit  
Green Light  
2. Using the same small pointed object, press the black recessed button on the side of the  
extension unit. The green light on the front of the extension unit will flash once. This is  
your notification that the security programming for this extension is complete. To program  
additional extensions to the same base, repeat step 2 with the additional extensions.  
Note: When the button is pushed on the extension, the light on the extension should come on for a  
few seconds, and then go out. This indicates that the unit is operating properly. If the green  
light is flashing repeatedly, your base unit is not in programming mode. You will need to  
return to step 1 and repeat the steps.  
Extension Unit  
Green Light  
3. Once all extensions have been programmed, you will need to verify the dial tone for each  
phone. Take your phone off the hook and listen: you should hear a dial tone.  
4
 
Troubleshooting  
Most difficulties associated with the Wireless Modem Jack result from improper installation. If the  
recommendations below do not solve your difficulty, remove both the base unit and remote units  
from the AC outlets; remove all cords and reinstall the equipment, taking extreme care to follow  
the instructions on the previous pages closely. Your environment—including such factors as  
equipment location, or specific design or structural characteristics of your home or office—can  
affect your computer modem performance and/or create interference. Static, buzzing, or humming  
sounds are indications of interference. If you experience unusually high noise levels, follow the  
troubleshooting actions on this page.  
No dial tone  
Check connections, check your power source, try new cords, move the base and/or extension unit.  
Static/interference  
Repeat security programming on page 4.  
Note: Halogen lamps, light dimmers, touch lamps, fluorescent lights, and some surge protectors can  
cause static.  
Can’t dial out  
Decrease distance between units. If problem continues, call Belkin Customer Service at  
1-800-223-5546 ext. 2263.  
Does not ring  
Decrease distance between units. Test extension unit using a different phone.  
Extension beeps  
Repeat the security programming steps on page 4.  
Phone works but modem does not  
Add one or two pauses or commas to the front of the modem’s dial-out number. This allows the  
phone to connect correctly to the line, before the modem begins to dial.  
Cannot set security feature (LED on extension unit blinks during security setup)  
Place the base and extension units as close as possible to each other and then follow the  
security setup procedure on page 4. Once security is set, you can relocate the base and extension  
units to other outlets throughout the house, without losing security.  
Things You Should Know  
The following list is provided to inform you of things that you may encounter when using the  
equipment. It is intended to help you get the best performance possible from your new equipment.  
Power Outages  
Only the telephone plugged into the base unit will continue to operate in a power outage.  
Telephone(s) or modem(s) plugged into extension unit(s) will not function until power is restored.  
Two-Line Phone Operations  
If two lines are being used, only one can operate through the Wireless Modem Jack. A single  
base and extension hookup will operate only with the phone line to which the base is connected.  
Ground Fault Circuit Interrupter (GFCI)  
Do not use a GFCI outlet (e.g., those set up to work in bathrooms, outdoors use) to use your  
Wireless Modem Jack.  
5
 
INFORMATION  
FCC Information  
This equipment has been tested and found to comply with the limits for a Class B digital device,  
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This equipment generates, uses and can  
radiate radio frequency energy and, if not installed and used in accordance with the instructions,  
may cause harmful interference to radio communications. However, there is no guarantee that  
interference will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged to try to correct the  
interference by reorienting or relocating the receiving antenna or by increasing the separation  
between the equipment and receiver.  
This Wireless Modem Jack complies with Part 68 of the FCC Rules. On the device is located the  
registration number. If requested, this number must be provided to the telephone company. This  
equipment cannot be used on telephone company-provided coin service or to Party Line Service.  
This equipment uses the RJ11 connector. If this equipment causes problems on the phone line,  
the telephone company can discontinue your service. The phone company tries to notify you in  
advance. If advance notice is not practical, the telephone company notifies you as soon as  
possible and advises you of your right to file a complaint with the FCC. The telephone company  
may make changes in its facilities or procedures that could affect the operation of this  
equipment. If this happens, the telephone company will provide advanced notice in order for you  
to make the necessary modifications to maintain uninterrupted service.  
Ringer Equivalence  
The Ringer Equivalence Number (REN) for the equipment is 0.4. The REN assigned to each  
terminal equipment provides an indication of the maximum number of devices that may be  
connected to the telephone network. The sum of the REN of all devices connected to a single line  
should not exceed five (5.0).  
Industry Canada Notice for models sold in Canada  
This equipment meets the applicable Industry Canada Terminal Equipment Technical  
Specifications. This is confirmed by the registration number. The abbreviation, IC, before the  
registration number signifies that registration was performed based on a Declaration of  
Conformity indicating that Industry Canada technical specifications were met. It does not imply  
that Industry Canada approved the equipment.  
Operation Range  
The Wireless Modem Jack works within 1000 feet of wiring.  
Limited Two- (2) Year Warranty  
What this warranty covers.  
Belkin Corporation warrants to the original purchaser of any Belkin Wireless Modem Jack, that the  
Wireless Modem Jack shall be free of defects in design, assembly, material, or workmanship.  
What the period of coverage is.  
Belkin Corporation warrants the Belkin Wireless Modem Jack for two (2) years from the original  
date of purchase or as long as the original purchaser owns it, whichever is less.  
6
 
What will we do to correct problems?  
Belkin will repair or replace, at its option, any defective Wireless Modem Jack free of charge  
(except for shipping charges for the Wireless Modem Jack).  
What is not covered by this warranty?  
All above warranties are null and void if the Belkin Wireless Modem Jack is not provided to Belkin  
Corporation for inspection upon Belkin’s request at the sole expense of the purchaser, Belkin  
Corporation determines that the Belkin Wireless Modem Jack has been improperly installed,  
altered in any way or tampered with. The Belkin Wireless Modem Jack Warranty does not protect  
against acts of God such as flood, earthquake, war, vandalism, theft, normal-use wear and tear,  
erosion, depletion, obsolescence, abuse, damage due to low voltage disturbances (i.e. brownouts  
or sags), non-authorized program, or system equipment modification or alteration.  
How to get service.  
To get service for your Belkin Wireless Modem Jack you must take the following steps:  
1. Contact Belkin Corporation at 501 W. Walnut St., Compton CA 90220, Attn: Customer Service,  
or call (800)-223-5546. Be prepared to provide the following information:  
a. The part number of the Belkin Wireless Modem Jack.  
b. Where you purchased the Wireless Modem Jack.  
c. When you purchased the Wireless Modem Jack.  
d. Copy of original receipt.  
2. Your Belkin Customer Service Representative will then instruct you on how to forward your  
receipt and Belkin Wireless Modem Jack and how to proceed with your claim.  
Belkin Corporation reserves the right to review the damaged Belkin Wireless Modem Jack. All  
costs of shipping the Belkin Wireless Modem Jack to Belkin Corporation for inspection shall be  
borne solely by the purchaser. If Belkin determines, in its sole discretion, that it is impractical to  
ship the damaged equipment to Belkin Corporation, Belkin may designate, in its sole discretion,  
an equipment repair facility to inspect and estimate the cost to repair such equipment. The cost,  
if any, of shipping the equipment to and from such repair facility and of such estimate shall be  
borne solely by the purchaser. Damaged equipment must remain available for inspection until the  
claim is finalized. Whenever claims are settled, Belkin Corporation reserves the right to be  
subrogated under any existing insurance policies the purchaser may have.  
How state law relates to the warranty.  
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF BELKIN CORPORATION, THERE ARE NO  
OTHER WARRANTIES, EXPRESSED OR, EXCEPT AS REQUIRED BY LAW, IMPLIED, INCLUDING THE  
IMPLIED WARRANTY OR CONDITION OF QUALITY, MERCHANTABILITY OR FITNESS FOR A  
PARTICULAR PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE LIMITED IN DURATION  
TO THE TERM OF THIS WARRANTY. Some states do not allow limitations on how long an implied  
warranty lasts, so the above limitations may not apply to you.  
IN NO EVENT SHALL BELKIN CORPORATION BE LIABLE FOR INCIDENTAL, SPECIAL, DIRECT,  
INDIRECT, CONSEQUENTIAL OR MULTIPLE DAMAGES SUCH AS, BUT NOT LIMITED TO, LOST  
BUSINESS OR PROFITS ARISING OUT OF THE SALE OR USE OF ANY BELKIN WIRELESS MODEM  
JACK, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. This warranty gives you  
specific legal rights, and you may also have other rights, which may vary from state to state.  
Some states do not allow the exclusion or limitation of incidental, consequential, or other  
damages, so the above limitations may not apply to you.  
This warranty is valid in the US and Canada.  
7
 
Belkin Corporation  
310.898.1100  
Compton • CA • USA  
Belkin Components, Ltd.  
+44 (0) 1933 35 2000  
Rushden • United Kingdom  
Belkin Components B.V.  
+31 (0) 20 654 7300  
Schiphol-Rijk • The Netherlands  
Belkin, Ltd.  
+61 (0) 2 4372 8600  
West Gosford • Australia  
Technical Support  
US:  
310.898.1100 ext. 2263  
800.223.5546 ext. 2263  
00 800 223 55 460  
Europe:  
Australia: 1800 666 040  
© 2003 Belkin Corporation. All rights reserved.  
All trade names are registered trademarks of respective manufacturers listed.  
P74413-A  
 

Black Decker Can Opener EC75 User Manual
Blue Rhino Charcoal Grill CBC830L C User Manual
Blue Rhino Charcoal Grill NB1854WRTR User Manual
Blue Rhino Gas Grill NSG3902D User Manual
Bosch Power Tools Cordless Drill PS20 2 User Manual
Brainboxes Network Card PM 132 User Manual
Campbell Hausfeld Automobile Accessories MP2118 User Manual
Canon Photo Printer ES20 User Manual
Casio Watch 1919 User Manual
Chicago Electric Chainsaw Sharpener 91995 User Manual