AMBSL1,AMBSQ1
1W Self-Amplified Metal Box Speakers
For Surface Mounting to Walls and Ceilings
Installation Instructions
1. Determine where the speaker(s) will be mounted. Do not mount speakers near noise generating equipment (fans,
motors) and do not use where a normal conversation cannot be conducted. Ensure power is not connected to speaker
wires before installation. Follow all local safety and building codes and route speaker wires to desired wall or ceiling loca-
tion. Pull approximately 12" of wire through opening in mounting surface.
2. Pull speaker wire through the back of the large opening of the speaker enclosure. Using the supplied mounting hardware,
secure the enclosure to the mounting surface (Figure 1). Note that two toggle bolt/screws (for sheet rock surfaces) and
two wood screws (for securing to solid wood or beams) have been included. Utilize the two washers (supplied) with
either toggle bolts, wood screws, or other user supplied hardware.
Use two of the enclosure mounting holes
as a template (diagonally opposed), and
mark screw hole locations. If toggle bolts
will be used, drill two, 1/2" diameter holes
in the mounting surface, otherwise drill a
hole appropriate for hardware being used.
Ceiling
Toggle bolts
(for sheet rock)
Package Contents:
Enclosure mounting holes
(Diagonally opposed)
• Back box enclosure
• Grille with speaker assembly
• Two toggle bolt/screws
• Two wood screws
• Two washers
• Two pluggable screw terminals
• Detachable knob
• Four 1" screws for attaching
grille assembly
Mounting
bolts and
washers
Figure 1 - Sheet rocked ceiling mounting example
© 2006 Bogen Communications, Inc.
Specifications subject to change without notice.
54-2151-01A
0607
|