MPS1
Mini Pendant Speaker
Models MPS1B/MPS1W
Installation and Use Manual
© 2010 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2194-01A 1010
TO SPEAKER
ANCHOR
POINT
MPS1 Speaker Cable Connections
and Suspension Instructions
In addition to the Main suspension Drop Cable,
a backup Safety Cable is required for proper
installation. Use wire rope or other drop line rated
for at least 100 lbs. to ensure a safety margin.
The attachment point on the structure from which
the speaker is to be anchored also must be able
to handle 100 lbs.
MAIN
DROP
CABLE
SAFETY
CABLE
NOTE: If using suspension cables with a cladding,
be sure to strip away coating where any clamping
device is being used so that bare wire cores of the
cable are being clamped.
MPS1 SUSPENSION
ATTACHMENT
MPS1
MINI PENDANT
SPEAKER
SAFETY
MAIN DROP
CABLE HOLE
CABLE HOLE
ALONG WITH THE MAIN DROP CABLE, YOU MUST ALSO USE A
SAFETY CABLE WHEN SUSPENDING AN MPS1 PENDANT SPEAKER.
BE SURE TO SECURE ALL RIGGING POINTS AND FOLLOW ALL
THE CABLE MANUFACTURER’S MATERIAL RECOMMENDATIONS
& INSTALLATION INSTRUCTIONS. FAILURE TO DO SO MAY RESULT
IN PROPERTY DAMAGE, INJURY OR DEATH, AND LEGAL LIABILITY
FOR YOU AND/OR YOUR COMPANY.
Attach the main drop cable to the MPS1 Main Drop Cable hole in the Suspension
Attachment located on the top of the speaker. This Main Drop Cable will be the primary
connection that will hold all the suspended speakerʼs weight to the anchor point.
Likewise, attach the Safety Cable to the Safety Cable hole in the Suspension Attachment.
This Safety Cable is meant to be a safeguard only, so when attaching to an anchor point
allow for a small amount of slack in the wire, as the Safety Cable should not bear any of
the speakerʼs direct supension weight to keep the speaker hanging level.
IMPORTANT: The MPS1 Mini Pendant is not an outdoor speaker. DO NOT expose the
speaker to rain or moisture. The MPS1 should be installed by qualified personnel.
Technical Specifications
Frequency Response (-10dB)*
Driver Complement
Sensitivity (1W/1m)
Impedance Range
50Hz to 14kHz
4-1/2” Dual-Cone Wide-Range
85dB (Average 100Hz – 10kHz)
Low (16 Ohms) / High (70V)
50W @ 16 Ohms; 32W @ 70V
70V: 32, 16, 8, 4, 2, 1
Power Input (Maximum)
Power Settings (in watts)**
Enclosure Material
Grille Material
ABS Plastic Injection-Molded
Powder-Coated Perforated Steel
2 Terminal Quick-Disconnect Connector
4 lb. 8 oz.
Terminations
Product Weight
Speaker Dimensions
Included Accessory
Optional Accessories
Enclosure Finish & Color
12” Dia.. x 7-7/8” High
(1) Quick-Disconnect Input Connector
Hanging Cable Kit (CK10, white or black)
Textured White or Black
* Free-Space Response, 16-ohm input
** Rear Panel switch selected
Limited Warranty; Exclusion of Certain Damages
The Bogen MPS1 Mini Pendant Speaker is warranted to be free from defects in material or workmanship for two (2) years from the date
of sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use, becomes defective
will be repaired or replaced by Bogen, at our option, provided the product is shipped insured and prepaid to: Bogen Factory Service
Department, 50 Spring Street, Ramsey, NJ 07446, USA. The product will be returned to you freight prepaid. This warranty does not ex-
tend to any of our products that have been subjected to abuse, misuse, improper storage, neglect, accident, improper installation or have
been modified or repaired or altered in any manner whatsoever, or where the serial number or date code has been removed or defaced.
THE FOREGOING LIMITED WARRANTY IS BOGEN'S SOLE AND EXCLUSIVE WARRANTY AND THE PURCHASER'S SOLE AND
EXCLUSIVE REMEDY. BOGEN MAKES NO OTHER WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, AND ALL
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR
A
PARTICULAR PURPOSE ARE HEREBY
DISCLAIMED AND EXCLUDED TO THE MAXIMUM EXTENT ALLOWABLE BY LAW. Bogen's liability arising out of the manufacture,
sale or supplying of products or their use or disposition, whether based upon warranty, contract, tort or otherwise, shall be
limited to the price of the product. IN NO EVENT SHALL BOGEN BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES (INCLUDING, BUT NOT LIMITED TO, LOSS OF PROFITS, LOSS OF DATA OR LOSS OF USE DAMAGES) ARISING OUT
OF THE MANUFACTURE, SALE OR SUPPLYING OF PRODUCTS, EVEN IF BOGEN HAS BEEN ADVISED OF THE POSSIBILITY
OF SUCH DAMAGES OR LOSSES. Some States do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from State to State.
Products that are out of warranty will also be repaired by the Bogen Factory Service Department — same address as above or call
201-934-8500. The parts and labor involved in these repairs are warranted for 90 days when repaired by the Bogen Factory Service
Department. All shipping charges in addition to parts and labor charges will be at the owner's expense. All returns require a Return
Authorization number.
7/22/2008
50 Spring Street, Ramsey, NJ 07446 USA
Tel. 201-934-8500 • Fax: 201-934-9832
|