4
en | Before you begin
E2600 DSA E-Series iSCSI Disk Arrays
1
Before you begin
For warnings and detailed installation instructions, refer to the E2600 DSA E-Series
Installation manual and additional documentation in the Online Product Catalog on http://
Attached) > DSA – Disk Arrays > DSA E-Series iSCSI Disk Arrays. (The navigation path is
subject to change).
Management methods are specific to the installation steps in Section 6 and Section 9.
1.1
Learn about management methods
In-band management
Management using the I/O connections between the host and the storage. The host must still
have Ethernet capabilities.
–
Access volume
Used to communicate management requests and event information. An access volume is
needed for only in-band management.
Out-of-band management
Management directly through the Ethernet connections on each controller using one of the
network configurations from the following list (the command line interface CLI might be
required):
–
DHCP server
Permits nodes to dynamically acquire network addresses.
Ethernet IP address
–
Permits direct connection to controller A or controller B by using an IP address in the
form of xxx.xxx.xxx.yyy and xxx.xxx.xxx.yyz.
Static IP address
–
–
–
Recommended for out-of-band management using IPv4 networks.
Router advertisements
Recommended for out-of-band management using IPv6 networks.
MAC address
Associates the media address control (MAC) address (xx:xx:xx:xx:xx:xx) of each controller
with an assigned IP address.
1.2
What you need for assembly
E2600 controller-drive tray ship group
–
–
–
One two-unit (2U) -high E2600 controller-drive tray
Two power cords
One cabinet mounting hardware kit, including:
–
–
Two mounting rails (right and left assemblies)
Eight M5 x 8 mm screws – Use six screws to secure the mounting rails and two
screws to secure the front of the controller-drive tray to the cabinet.
Two M4 x 8 mm screws – Use the screws to secure the rear of the controller-drive
tray to the mounting rails.
–
Options
–
–
Drives (two minimum for each controller-drive tray)
DC power cords for the optional –48 VDC power option
If you have any questions about the firmware or your configuration, contact your Customer
and Technical Support representative.
Tools
–
An Internet connection
07/2012 | V1 |
Quick Install Guide
Bosch Sicherheitssysteme GmbH
