LTC 9349MK
Instruction Manual
EN Mounting Kit
|
LTC9349MK | Instruction Manual | Installation
EN 3
3. Tighten the 4 bracket screws located in each corner
(PHOTO 4).
3
INSTALLATION
Backbox Module Mounting in Suspended Ceiling
Mount the backbox in a suspended ceiling grid using
the existing ceiling tile, as follows.
1. Locate the bracket assembly at the desired location
(PHOTO 2). Loosen the securing screws on the
base bracket assembly (PHOTO 4) enough to retain
the suspension bars during handling, but allowing
adjustment during installation.
x 4
Photo 4: Bracket Securing Screws
Ceiling Tile
Suspension
Bars
4. Secure the bracket assembly to an overhead
securing point using a safety cable (PHOTO 5).
Ceiling Base
Bracket
Photo 2: Ceiling Mounting (Top View)
2. Snap the bar clips over the ceiling rails (PHOTO 3).
Slide the base plate to the desired position on top
of the tile.
Photo 5: Safety Cable Fitment
5. Cut a 172 mm (6.75-inch) diameter hole in the
center of the mounting plate using two (2) pencils
(or a pencil and nail) and the template tool
(provided with the LTC 9349 Unity Dome Series).
x 4
6. Install the unit as instructed in the
LTC 9349 Unity Dome Series manual.
Photo 3: Bracket Clip Fitting
Bosch Security Systems | 21 July 2003
Bosch Security Systems, Inc.
850 Greenfield Road
Robert Bosch GmbH
Geschäftsbereich
Bosch Security Systems B.V.
P.O. Box 80002
Lancaster, PA 17601 EE.UU.
Tel: 800-326-3270
Postfach 10 60 50
70049 Stuttgart
5600 JB Eindhoven
The Netherlands
Fax: 1-717-735-6560
Telefax (0711) 811-12 34
Tele +31 40 27 80000
© 2003 Bosch Security Systems GmbH
3935 890 36112 03-30 July 22, 2003 Data subject to change without notice.
|