VDx-244 - Quick Install
1
1/2
2
3
4
139 (5.47)
Menu (set)
Mounting anchors
I N T
L L
Guide pattern
Rubber pad
Dome base
100.2 (3.94)
Focus
51.7 (2.03)
13.8 (0.54)
4 mounting screws
not included
BNC
female
Zoom
PT 1/2" TAP
Inner dome
Dome cover
24 VAC /
12 VDC
Class 2
Twist
1 Vpp
75 Ohm
Tilt
4– Ø4.4 0.1
Key
Pan
13.8 (0.54)
51.7 (2.03)
mm (in)
1.2
Important safety instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
1.4
Bosch notices
1.3
FCC & ICES compliance
FCC & ICES Information
1
Safety
Disposal - Your Bosch product was developed and
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
manufactured with high-quality material and components that
can be recycled and reused. This symbol means that
electronic and electrical appliances, which have reached the
end of their working life, must be collected and disposed of
separately from household waste material. Separate collecting
systems are usually in place for disused electronic and
electrical products. Please dispose of these units at an
environmentally compatible recycling facility, per European
Directive 2002/96/EC
1.1
Safety precautions
DANGER!
4. Follow all instructions
5. Clean only with a dry cloth.
High risk: This symbol indicates an imminently hazardous
situation such as "Dangerous Voltage" inside the product.
If not avoided, this will result in an electrical shock, serious
bodily injury, or death.
6. Install in accordance with the manufacturer's instructions.
7. Do not install unit near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
8. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
WARNING!
Medium risk: Indicates a potentially hazardous situation.
If not avoided, this could result in minor or moderate bodily
injury.
Optical elements
9. Only use attachments/accessories specified by the
manufacturer.
Optical elements are sensitive and should be protected at all
times. Do not allow objects to come into contact with glass
surfaces and do not touch optical elements with your fingers.
10. Unplug this apparatus during lightning storms or when
unused for long periods of time.
CAUTION!
–
–
reorient or relocate the receiving antenna;
increase the separation between the equipment and
receiver;
Low risk: Indicates a potentially hazardous situation.
If not avoided, this could result in property damage or risk of
damage to the unit.
Copyright
11. Refer all servicing to service personnel. Servicing is
required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
This manual is the intellectual property of Bosch Security
Systems and is protected by copyright.
All rights reserved.
–
–
connect the equipment into an outlet on a circuit different
from that to which the receiver is connected;
consult the dealer or an experienced radio/TV technician
for help.
CAUTION!
Trademarks
The Low Voltage power supply unit must comply with EN60950
/ UL60065. The power supply must be a SELV-LPS unit or a
SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power
Source).
All hardware and software product names used in this
document are likely to be registered trademarks and must be
treated accordingly.
Intentional or unintentional modifications, not expressly
approved by the party responsible for compliance, shall not be
made. Any such modifications could void the user's authority to
operate the equipment. If necessary, the user should consult
the dealer or an experienced radio/television technician for
corrective action.
Note
CAUTION!
Bosch Security Systems accepts no liability for damage
resulting directly or indirectly from faults, incompleteness or
discrepancies between the user guide and the product
described.
Installation should only be performed by qualified service
personnel in accordance with the National Electrical Code or
applicable local codes.
More information
For more information please contact the nearest Bosch Security
Systems location or visit www.boschsecurity.com
AM18-Q0642
|