BOSE® AE2i AUDIO HEADPHONES
|
|
|
|
|
Tab 5, 11
Tab 4, 10
Tab 3, 9
Tab 2, 8
English
Safety Information
Please take the time to follow the instructions in this owner’s
guide carefully. It will help you set up and operate your product
properly and enjoy its advanced features. Please save this
owner’s guide for future reference.
CAUTIONS
• Long-term exposure to loud music may cause hearing dam-
age. Please avoid extreme volume when using headphones,
especially for extended periods.
• Do not use headphones when operating a motor vehicle or
anywhere the inability to hear outside sounds may present a
danger to you or others.
• Sounds that you rely on as reminders or warnings may have an
unfamiliar character when using headphones. Be aware of
how these sounds may vary in character so you can recognize
them as needed.
• Do not drop, sit on or allow the headphones to be immersed in
water.
WARNING: DO NOT use mobile phone adapters to connect
headphones to airplane seat jacks as this could result in personal
injury such as burns or property damage due to overheating.
Remove and disconnect immediately if you experience warming
sensation or loss of audio.
Limited Warranty
Your Bose® headphones are covered by a limited warranty.
Details of the limited warranty are provided on the product
registration card that is included in the carton. Please refer to
the card for instructions on how to register. Failure to register
will not affect your limited warranty rights.
What you must do to obtain Limited Warranty Service:
Return product, with proof of purchase from an authorized Bose
dealer, using the following procedures:
1. Contact the Bose organization in your country/region (visit
Global.Bose.com/register for Bose contact information in
your country/region) for specific return and shipping
instructions;
2. Label and ship the product, freight prepaid, to the address
provided by the Bose organization in your country; and
3. Place any necessary return authorization number
prominently on the outside of the carton. Cartons not bearing
a return authorization number, where required, will be
refused.
Note: The serial number is located inside the right earcup.
1
English
Tab 2, 8
Tab 3, 9
Tab 4, 10
Tab 5, 11
Introduction
Thank you for purchasing the Bose® AE2i audio headphones for
select Apple products. These headphones were designed to give
you easy access and greater control of your Apple audio device.
With Bose AE2i audio headphones, you can immerse yourself in
your music and enjoy an around-ear fit that stays comfortable
for hours.
For use with:
The remote and mic are supported only by iPod nano (4th
generation and later), iPod classic (120GB, 160GB only), iPod
touch (2nd generation and later), iPhone 3GS, iPhone 4, iPad,
iPad 2 and 2009 models or later of MacBook and MacBook Pro.
The remote is supported by iPod shuffle (3rd generation and later).
Audio is supported by all iPod models.
Components
Adjustable
Replaceable
headband
earcup
cushions
Remote and
Microphone
1/ inch
8
(3.5 mm) plug
L or R mark
2.5 mm
Detachable audio cable
2
Tab 5, 11
Tab 4, 10
Tab 3, 9
Tab 2, 8
English
Wearing the headphones
Put on the headphones using the markings which identify the left
(L) and right (R) earcups. Adjust the headband so it rests gently
on top of your head and the earcup cushions fit comfortably
around your ears.
Connecting to your Apple device
Ensure the smaller 2.5 mm plug is securely inserted into the left
earcup. Plug the other end of the cable securely into the audio
output jack of the Apple audio device.
Using the headphones with your Apple device
The Bose® AE2i headphones come with a small in-line remote
with an integrated microphone for convenient control of select
Apple products. Easily control volume, track selection and voice
applications, plus switch between your calls and music.
Note: Full controls may not be available for some Apple products.
Headphone controls
Volume up
Answer/End
Volume down
3
English
Tab 2, 8
Tab 3, 9
Tab 4, 10
Tab 5, 11
Basic functions
Increase volume
Decrease volume
Press and release the + button.
Press and release the – button.
Call-related functions
Answer a call
When you receive an incoming call, press
and release the Answer/End button to
answer.
End a call
Press and release the Answer/End button.
Decline an incoming Press and hold the Answer/End button for
call about two seconds, then release.
Switch to an incom- While on a call, press and release the
ing or on-hold call
Answer/End button once. Press and
release again to switch back to the first call.
and
put the current call on
hold
Switch to an incom- While on a call, press and hold the Answer/
ing or on-hold call
and end the current
call
End button for about two seconds, then
release.
Use Voice Control
Press and hold the Answer/End button.
See iPhone User Guide for compatibility and
usage information about this feature.
Media playback functions
Play or pause a song Press and release the Answer/End button.
or video
Skip to the next song Press and release the Answer/End button
or chapter
twice quickly.
Fast-forward
Press and release the Answer/End button
twice quickly and hold the second press.
Go to the previous
song or chapter
Press and release the Answer/End button
three times quickly.
Rewind
Press and release the Answer/End button
three times quickly and hold the third press.
4
Tab 5, 11
Tab 4, 10
Tab 3, 9
Tab 2, 8
English
Folding earcups
The Bose® AE2i audio headphones feature rotating earcups that
fold flat for easy, convenient storage.
The earcups rotate in only one direction. Incorrectly rotating the
earcups can damage the headphones.
Cleaning the headphones
The Bose AE2i audio headphones do not require scheduled
cleaning. Should cleaning be necessary, simply wipe the outside
surfaces with a soft cloth. Be sure the earcup ports are kept
clear, and that no moisture is allowed to get inside the earcup.
Replacement parts and accessories
Accessories or replacement parts can be ordered through Bose
Customer Service. See the contact information for your area
included in this guide.
Part
Product Code
329585-0010
329586-0010
329583-0010
Carry bag:
Replacement cushions:
Audio cable:
Cable with remote and microphone: 345443-0010
Reattaching earcup cushions
The earcup cushions are held in place
by a mounting flange which snaps
under 8 small tabs located around the
inside rim of each earcup. If an earcup
cushion becomes partially or
completely detached, push the
mounting flange of the earcup cushion
back into the earcup. Using your finger
or thumb, press around the edge of the
mounting flange, making sure it snaps
in place all the way around the earcup.
5
English
Tab 2, 8
Tab 3, 9
Tab 4, 10
Tab 5, 11
Troubleshooting
Problem
What to do
No audio or audio in • Ensure both ends of the audio cable
one earcup only
are firmly seated.
• Try a different audio device.
Distorted bass
• Ensure both ear cushions are firmly
secured.
Mis-shaped cushion • The high-density earcup foam will
regain its shape after a few minutes in
a neutral position.
Microphone is not
picking-up sound
•
Make sure that the headset plug is
securely connected to the head-
phone jack.
•
Make sure the microphone is not
being blocked or covered.
The microphone is located on the
back of the Answer/End button.
Phone not respond-
ing to button presses
•
Make sure that the headset plug is
securely connected to the head-
phone jack.
•
•
For multi-press functions: Vary speed
of presses.
Apple product not
responding to remote
Full controls may not be available for
some Apple products.
If any problem persists, contact Customer Service. See the
phone number for your area included in this guide.
6
Tab 5, 11
Tab 4, 10
Tab 3, 9
Tab 2, 8
English
Names and Contents of Toxic or Hazardous Substances or Elements
Toxic or Hazardous Substances and Elements
Part
Name
Lead Mercury Cadmium Hexavalent Polybrominated
Polybrominated
(Pb) (Hg)
(Cd)
(CR(VI))
Biphenyl (PBB) diphenylether (PBDE)
PCBs
X
0
0
0
0
0
0
0
Metal
parts
X
0
0
0
Plastic
parts
0
X
X
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Speakers
Cables
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous
materials for this part is below the limit requirement in SJ/T 11363-2006.
X: Indicates that this toxic or hazardous substance contained in at least one of the
homogeneous materials used for this part is above the limit requirement in SJ/T
11363-2006.
©2011 Bose Corporation. No part of this work may be reproduced,
modified, distributed, or otherwise used without prior written
permission.
Apple, iPad, iPhone, iPod, iPod classic, iPod nano, iPod shuffle, iPod
touch and MacBook are trademarks of Apple, Inc., registered in the
U.S. and other countries.
“Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that
an electronic accessory has been designed to connect specifically to
iPod, iPhone, or iPad, respectively, and has been certified by the
developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with
safety and regulatory standards. Please note that the use of this
accessory with iPod, iPhone, or iPad may affect wireless
performance.
7
©2011 Bose Corporation, The Mountain,
Framingham, MA 01701-9168 USA
AM346022 Rev.01
|