Gear Case Kit
Part No. 1687227 & 1687228
For 2004 Simplicity 860EI Intermediate Snowthrowers
Installation
Instructions
1694433, 1694434
Kit Contents:
Ref Part No. Qty. Description
1
2
3
4
5
6
7
8
1721684
7090052
7092129
7091576
7092125
1721676
1721685
960625
1
6
12
6
6
1
GEAR CASE, RH
4
WASHER, 1/4” SPLIT LOCK
WASHER, FLAT, .268 x .591
NUT, HEX, 1/4-20
SCREW, HEX, 1/4-20 x 7/8
GASKET, GEAR CASE
GEAR CASE, LH
3
1
1
2
FITTING - PIPE PLUG
7
8
6
1
3
5
Figure 1. Contents
This kit is to service intermediate snowthrowers.
INSTALLATION
Disassemble Housing
WARNING
Before beginning any service work turn off the
A
ignition, and disconnect the spark plug wire(s).
1. Remove the washers and retaining rings (D, Figure
2) from both ends of the auger shaft. Remove the
bearings (C).
D
2. Remove the hardware securing both side covers (A),
and remove the side covers.
B
C
Figure 2. Disassemble Housing
A. Side Cover
B. Housing
C. Bearing
D. Washers & Retaining Ring
1
Gear Case Kit
Installation Instructions
Assemble Housing
1. Install the side covers (A, Figure 4) and secure with
the original hardware.
2. Reinstall the bearings (C), washers, and retaining
rings (D) in both side covers.
A
D
B
C
Figure 4. Assemble Housing
A. Side Cover
B. Housing
C. Bearing
D. Washers & Retaining Ring
Fill Auger Gear Case Oil
1. Remove the fill plug (Figure 5). Fill the gear box with
The Dealer Line Winter Weight Worm Gear Oil until
the oil level reaches the bottom of the fill hole.
Pipe Plug
Figure 5. Checking Auger Gear Case Lubrication
3
Installation Instructions
Gear Case Kit
NOTES
Form No. 1732778-01
Rev. 12/2006
TP 200-4412-01-SK-SN
MANUFACTURING, INC.
Briggs & Stratton Yard Power Products Group
Copyright © 2006 Briggs & Stratton Corporation
Milwaukee, WI USA. All Rights Reserved
500 N Spring Street / PO Box 997
Port Washington, WI 53074-0997 USA
4
|